Assignment No.2 CLO-2 (10)Apply principle of horizontal flow grit chamber to find out thedimensions of a grit chamber for a population of 60000 individualshaving a water consumption of 250 LPCD with a peak factor of2.72. Moreover, assumes any missing information if any. Apply principle of horizontal flow grit chamber to find out thedimensions of a grit chamber for a population of 60000 individualshaving a water consumption of 250 LPCD with a peak factor of2.72. Moreover, assumes any missing information if any.

Answered: Image /qna-images/answer/0b690e89-ede9-492e-8fac-c765b4dc0112.jpg

Answered: imensions of a grit chamber for a…

imensions of a grit chamber for a population of 60000 individuals aving a water consumption of 250 LPCD with a peak factor of .72. Moreover, assumes any missing information if any.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Answer the question based on the figure given. Gravely sand Ysat = 18.5 kN/m³; Ym = 17.8 kN/m³ Sand…

Q: A sample, 75 mm in diameter and 20 mm high was consolidated in an oedometer with drainage at upper…

A: From Given Data :Diameter of the sample D =75 mm ;Height of sample (H) = 20 mm ; Length of drainage…

Q: Q4) Determine the required SOR and scour velocity in a grit chamber to remove grit particles of 0.23…

Q: Q5: Three specimens of the same soil were subjected to the pressures given below: specimen 1 2 100…

Q: A clay soil specimen, 1.5 in. thick (drained on top only) was tested in the laboratory. For a given…

A: Given Data:d=1.5inu=60%t=8min 10sec

Q: 16 36 64 200 400 1440 2 160.00 Q2) the following results were obtained from odometer test on…

Q: A consolidated drained (CD) triaxial test was conducted on a granular soil. At failure the cell…

A: Given data : Deviator stress (σd)=8505 psfConfining pressure (σ3')=3150 psf

Q: A course sand sample is placed in the constant permeameter test. What is the coefficient of…

Q: Three samples of soil are tested under consolidated undrained conditions with measurement of the…

A: Mohr circle is drawn to find the failure envelope and further the shear parameters of the soil. The…

Q: The time required to reach (40%) consolidation is (5 min.) for a sample of (3 cm) thickness, the…

A: U=40% t=5min

Q: Q3: At one of the work sites, laboratory tests were conducted to find some properties of soil…

Q: If the primary consolidation settlement of a clay layer is calculated to be 396 mm, what is the…

A: ASKED: To compute the settlement for the given time factor. Given, Primary consolidation…

Q: Given the depth of grit chamber is 1 m, while settling velocity, vs, density, s and dynamic…

Q: a. Compute the undrained angle of friction. b. Compute the value of undrained cohesion. c. Compute…

A: ## calculation of a consolidated undrained test results of part a,b,c,d##

Q: A 3-m thick layer of saturated clay (two-way drainage) under a surcharge loading underwent 90%…

A: Thickness of saturated clay layer, H= 3 m Drainage condition = 2 way drainage Degree of…

Q: 11. Given: Undrained Trixial test on saturated pure clayey layer with the following data: O,- 150kPa…

Q: Problem 3-A wet sand sample has a volume of 4.64 x 104 m³ and welghts 8 N. After oven deving the…

A: Given data : Dry weight (WDry)=7.5 NMoist weight (WM)=8 NVolume (V)=4.64×10-4 m3

Q: The time required for a 50% consolidation of a 25 mm thick layer (drained at both sides) in the…

Q: 3.8 Following CT scanning, data are available for a chalk core plug from the North Sea area. The…

Q: A permeability test is inducted with a sample of soil that is 60 mm in diameter and 120 mm long .…

Q: Problem-2 In an SPT test gave the average below count of 35 in fine sand below water table. Find the…

A: given average below count for SPT testN'=35it is needed to find the corrected value of SPT number.

Q: Figure 1 below shows the CBR results for two materials (1 and 2) what is the CBR value for each…

A: Given,CBR results for two materialsto determine,for soil 1the resilient modulus of the subgrade soil…

Q: Answer the ff: a) The ratio of horizontal to the vertical permeability is b) The ratio of vertical…

A: To find horizontal and vertical permeability

Q: 12 cm, and the outside diameter of the well screen is 20 cm. Analyze this test and give the best…

A: Given data screen is 2 m long, inside diameter of the casing is 12 cm, and outside diameter of the…

Q: Three samples of soil are tested under consolidated undrained conditions with measurement of the…

Q: Question 12 If the primary consolidation settlement of a clay layer is calculated to be 460 mm, what…

Q: What does the values of the strength envelope from the consolidated–drained (C–D) test series…

A: Failure Envelope/Strength Envelope : When the series of Mohr upper circles plotted and a tangential…

Q: 1. Ovo = 58 kPa 3. (N1)60 = 7.7 5. amax =0.40g 2. ovo = 43 kPa 4. Z = 3m

A: Factor of safety against liquefaction is the ratio of cyclic resistance ratio to the cyclic stress…

Q: For any C–U- or U–U-type test, what is the magnitude of excess pore water pressure existing in the…

A: In the given question, we have to determine the indication of magnitude of excess pore water…

Q: 2.32 A mud retort analysis of a 16-1bm/gal fresh- water mud indicates a solids content of 32.5% and…

A: A sample chamber assembly of known volume filled with mud is used in retort analysis for drilling…

Q: Q.5 A grit chamber of dimensions 12.0 mx 1.50 m x 0.80 m liquid depth has a flow of 720 m³/hr. Its…

A: Given data- Grit chamber- Dimensions- 12 m×1.5 m×0.8 m,discharge Q=720 m3/hr, To Find- The surface…

Q: A sample of the soil was taken for oedometer test and the initial thickness of the sample was 19 mm…

A: Initial thickness of sample = 19 mmstress increment = 100 KPaA time and compression reading given…

Q: Question 6 A consolidation test was conducted on a clay sample and found that the clay has a…

Q: cup device. Number of blows 6 12 20 28 32 Water content (%) 52.5 47.1 43.2 38.6 37.0 Two…

Q: Define Mohr–Coulomb Failure Criterion

A: The Mohr–Coulomb failure criterion is a set of linear equations in principal stress space…

Q: A 846 psf soil surcharge load is applied to induce consolidation. Initial vertical effective stress…

A: Given-Surcharge=846psfInitial vertical effective stress=1353psfExcess pore pressure=494psf

Q: Design a grit chamber for a conventional wastewater treatment plant to treat wastewater from a…

A: Considering the population of the area is 50000. Average quantity of sewage, considering sewage…

Q: From the given figure: Tank 10mY = 8kN/m oil G.S. 4m SAND 6m CLAY Determine the loss in pore water…

A: Degree of consolidation = 30 % or 0.30 external pressure increase = γoil ×h = 8×10 = 80 KN/m2

Concept explainers

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.

Question

Assignment No.2 CLO-2 (10)
Apply principle of horizontal flow grit chamber to find out the
dimensions of a grit chamber for a population of 60000 individuals
having a water consumption of 250 LPCD with a peak factor of
2.72. Moreover, assumes any missing information if any.

Apply principle of horizontal flow grit chamber to find out the
dimensions of a grit chamber for a population of 60000 individuals
having a water consumption of 250 LPCD with a peak factor of
2.72. Moreover, assumes any missing information if any.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A consolidated, undrained tri axial test was carried out on a 73.0 mm diameter and 146.6 mm-long decomposed granodiorite sample at an initial water content of 26%. The sample was obtained from Palmerston Highway, North Queensland, Australia, to back-analyze a slope failure, and wasinitially consolidated under a cell pressure of 200 kPa and backpressure of 150 kPa. The drainage valvewas dosed and the cell pressure was increased to 254 kPa when the pore water pressure increased to182 kPa. Find Skempton's B-parameter. The nature of the soil sample is such that it was not possibleto achieve a higher B value. The drainage valve was opened and the sample was consolidated furtherunder the cell pressure of 254 kPaand backpressure of 150 kPa. At the end of consolidation, the drainage valve was dosed, locking in thebackpressure in preparation for the undrained loading. The axial strain 8, additional vertical stressapplied to the sample under undrained conditions Δσ', and the pore water pressure…
صخقهصجمسود
The time required to reach 60% consolidation for a sample of 1 cm thick in odometer under condition of double drainge was found to be 35 sec. The time for a layer of 10 m thick to reach the same consolidation degree if drainage in one side. Negative rating for wrong answers
Will a grit particle with a radius of 0.10 mm and a specific gravity of 2.65 be collected in a horizontal grit chamber that is 13.5 m in length if the average grit-chamber flow is 0.15 m³/s, the width of the chamber is 0.56 m, and the horizontal velocity is 0.25 m/s? Hint: Use the data below V's = g S-1] 18 DE 12UP , v=0.959 x 106 m²/s
Styles Editin A production casing was planned to run in the production hole of a well with casing shoe at 15,000 ft. When casing was run empty to the mid depth, collapse safety factor was calculated to be 1.9. When the casing was at the bottom and full of a certain mud, safety factor of the collapse was calculated to be 2.75. If the mud weight of the fluid in the annulus was 14.0 ppg, determine the casing collapse rating and mud weight of the fluid inside the casing.
Help me asap
A soil specimen, 1.5 in. thick (double drainage condition) was tested in the laboratory. For a given load increment, the time for 60% consolidation was 58.5 sec. How long will it take to reach the same degre of consolidation for a similar layer in the field that is 5-ft thick and drained on one side only.
How might you determine the horizontal coefficient of consolidation (ch) in an oedometer test
4 7 l. 12:33 التدرج الحبيب. . . HW1 HOMEWORK 1 We made sieve analysis for a soil sample, we had these results, complete the table. Sieve opening Wt. retained on Accumulative wt. % of Sieve no % of passing wt. (mm) 4.76 each sieve (gm) (gm) accumulative wt #4 2.38 #20 0,84 88.5 #40 0.42 77.9 #100 0.149 161.6 4200 0.074 29 pan 67.6
Refer to Problem 11.7. Given: cv 2.8 106m2/min.How long will it take for 60% consolidation to occur?