Imagine a stick of celery sitting in a beaker full of salt water contalnIng 10% salt. If I took the stick of celery out of the beaker of pure water and put it into a beaker of pure water that contains 0% salt which of the following would happen? Water would leave the celery Water would not enter or exit the celery Salt would leave the celery and enter the pure water Water would enter the celery

Imagine a stick of celery sitting in a beaker full of salt water contalnIng 10% salt. If I took the stick of celery out of the beaker of pure water and put it into a beaker of pure water that contains 0% salt which of the following would happen? Water would leave the celery Water would not enter or exit the celery Salt would leave the celery and enter the pure water Water would enter the celery

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

✓mall amount of acetonitrile (CH₂CN) is dissolved in a large amount of water. Imagine separating this process into the four stages sketched below. (These sketches show only a portion of the substances, so you can see the density and distribution of atoms and molecules in them.) CH₂CN 98 B H₂O Use these sketches to answer the questions in the table below. The enthalpy of solution AH soln is negative when CH3CN dissolves in water. Use this information to list the stages in order of increasing enthalpy. Would heat be absorbed or released if the system moved from Stage A to B? What force would oppose or favor the system moving from Stage A to B? Check all that apply. 0 O absorbed O released O neither absorbed nor released none Olonic bonding force O covalent bonding force metal bonding force Ohydrogen-bonding force dipole force ion-dipole force Odispersion force 0.0. X solution. S
In a quality control lab at the Fairlife brand (owned by the Cocaine-Cola company), a technician prepares a solution of lactose (milk sugar) by dissolving 30.00 g in 110.0 g of water. The temperature of the water is 55.0ºC. Find the partial pressure of water above the solution above the solution. Question 16 options: A) 1.670 torr B) 94.1 torr C) 169.4 torr D) 116.3 torr E) 92.7 torr
A 50/50 blend of engine coolant and water (by volume) is usually used in an automobile's engine cooling system. If a car's cooling system holds 5.30 gal,5.30 gal, what is the boiling point of the solution? For the calculation, assume that at normal filling conditions, the densities of engine coolant and water are 1.11 g/mL and 0.998 g/mL respectively. Also, assume that the engine coolant is pure ethylene glycol (HOCH2CH2OH),(HOCH2CH2OH), which is non‑ionizing and non‑volatile, and that the pressure remains constant at 1.00 atm. The boiling‑point elevation constant for water will also be needed.
The intermolecular force between the water and the ions in solution is stronger than the intermolecular force between two water molecules. The presence of the solute (NaCl) will cause the vapor pressure to ______ and will ______ the boiling point.
Assume that you were assigned calcium nitrate in lab. The water in your test tube weighed 22.096 g. Following the procedure in the lab manual, you determined that freezing point of water is 0.24°C.You weighed out 1.080 g of salt and added it to the original test tube, then determined that the freezing point was -0.83°C. Based on these experimental parameters, calculate the van't Hoff factor for calcium nitrate. Report your answer with 3 places after the decimal. Note that these are made-up numbers, and do not reflect a true experiment.