i need the answer quickly Il- Determine the consuming energy in (kw h) and the monthly cost for the buiklding, if the electrical devices areworking as shown in the tableConsuming current perNumberNumber ofWorking time(Hour per day)NoDevice Typedeviceof itemsphaseAmpAC unitcomputerPhoto copyTVLED lightNote: the voltage apply equals 220 volt140.8322single41.751210200.2If the cost of one-unit energy (40 ID per kWh)

II- Determine the consuming energy in (kw h) and the monthly cost for the building, if the electrical devices are working as shown in the table Consuming current per device Amp Working time (Hour per day) Number Number of No Device Type of items phase AC unit computer Photo copy TV LED light 14 0.8 single 1.75 0.2 12 10 5. Note : the voltage apply equals 220 volt 20 If the cost of one-unit energy (40 ID per kWh)

II- Determine the consuming energy in (kw h) and the monthly cost for the building, if the electrical devices are working as shown in the table Consuming current per device Amp Working time (Hour per day) Number Number of No Device Type of items phase AC unit computer Photo copy TV LED light 14 0.8 single 1.75 0.2 12 10 5. Note : the voltage apply equals 220 volt 20 If the cost of one-unit energy (40 ID per kWh)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

i need the answer quickly
What is ampere circuital law?
3. Which of the following statements about the use of structural steel as an equipment grounding conductor(EGC) in an AC system is correct?A. Structural steel isn't allowed for use as an EGC.B. Structural steel can be used as an EGC bonding jumper between panelboards.C. Structural steel must have an EGC bonding jumper every three feet of structure.D. Structural steel can be used as an EGC when it's bonded at both ends.
When using an oscilloscope for testing engine management systems, what is an attenuator used for? In your answer provide an example of when an attenuator should be used. (5 - 10 words)
i need the answer quickly
The contractor is controlled by?
Refer to the National Electrical Code® or the working drawings when necessary. Where applicable, responses should be written in complete sentences. For problems 1 and 2, six luminaires, similar to Style E used in the Commercial Building, are to be installed in a room that is 12 ft x 18 ft (~3.7 m x ~5.5 m) with a 9 ft (2.8 m) floor-to-ceiling height. The spacing ratio for the luminaire is 1:0. 1. The maximum distance that the luminaires can be separated and achieve uniform illuminance is ft ( m). For problems 2-5, two luminaires, 8 ft (2.5 m) and 4 ft (1.2 m) in length with dimensions as shown in Figure 15-7, are to be installed in tandem (end to end). The end of the long luminaire is to be 2 ft (600 mm) from the wall. 2. The center of the outlet box should be roughed in at ft ( m) from the wall. 3. The first support should be installed at the wall. ft ( m) from 4. The second support should be installed at from the wall. ft ( m) 5. The final support should be installed at the wall. ft…
22surse_assessment_id=_18982_1&course_id=_22058_1&content_id= _262244_1&ques * Question Completion Status > A Moving to another question will save this response. uestion 2 If the switch is closed for a long time and then opened at t-0. What is the initial value of the capacitor's voltage? ww None of the answers o 12 O Take Test: Quiz 2-. FUJITSU F10 F11 F12 Prt Scr E7 F8 F9 F6 Sys Rq ECO 7 V 8 A 9. 5 Y ! U P
The wording that I am running into with questions such as "The number of conductors required to be installed between three-way and four-way switches is " is confusing. The text is not expalining this in a way that I am understanding anything other than grounding conductor, which is optional unless I am using a metal box. So what type of "conductor" is beng discussed?
Hey see