Handwritten Please. (ii) A piston travels between two stops and is restrained by a linear spring as shown.The cross-sectional area of the piston is 0.05 m² and the initial volume of the gas inthe cylinder is 0.01 m³. At the top stops, the volume is 0.03 m³. The spring constantis 30.0 kN/m. The gas inside the cylinder is initially at 0.50 MPa and the pressurerequired to just raise the piston from the stops is 1.00 MPa. The final gas pressure inthe cylinder is 2.00 MPa.(a) Draw a P-V diagram showing the process.(b) Calculate the work done by the gas, in kJ.NNNNN

GivenA=0.05m2V1=0.01m3V3=0.03m3k=30.0 kN/m3P1=0.5MPa=500 kPaP2=1MPa=1000kPaP3=2MPa=2000kPa

ii) A piston travels between two stops and is restrained by a linear spring as shown. The cross-sectional area of the piston is 0.05 m² and the initial volume of the gas in he cylinder is 0.01 m³. At the top stops, the volume is 0.03 m³. The spring constant s 30.0 kN/m. The gas inside the cylinder is initially at 0.50 MPa and the pressure required to just raise the piston from the stops is 1.00 MPa. The final gas pressure in he cylinder is 2.00 MPa. a) Draw a P-V diagram showing the process. NNNNN Gas

ii) A piston travels between two stops and is restrained by a linear spring as shown. The cross-sectional area of the piston is 0.05 m² and the initial volume of the gas in he cylinder is 0.01 m³. At the top stops, the volume is 0.03 m³. The spring constant s 30.0 kN/m. The gas inside the cylinder is initially at 0.50 MPa and the pressure required to just raise the piston from the stops is 1.00 MPa. The final gas pressure in he cylinder is 2.00 MPa. a) Draw a P-V diagram showing the process. NNNNN Gas

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Note 1 indicates 10 GAGE 1010-1020 sheet metal can be used to make the main body of this part According to the left side view, how much tolerance is given to the thickness of the metal?
please answer, thank you
What is an inflection point?
How many auxiliary views of the print?
2) A washer is going to be manufactured by cutting operation out of 2024ST aluminum alloy sheet that has a thickness of 2.5 mm. The outside diameter of the washer is 25.0 mm, and the inside diameter is 12.0 mm. Make a rough sketch, define the geometries to be used and determine a. The punch and die size for the blanking operation b. The punch and die size for the punching operation c. The force required performing the blanking and punching operation simultaneously. The aluminum has a tensile strength = 300 MPa.
If the answer is no can anything be done to save the part?
The answer is one of the options below please solve carefully and circle the correct option Please write clear .
Most sheet metalworking operations are performed as which of the following: O Cold working O hot working O warm working O All of the Mentioned