ifcfg, ifup, ifdown, ethtool, nm-tool /etc/init.d/networking restart ip link set down ip link set up The ifconfig command is a tool used to display and configure network interfaces. This command will display information about the network card, IP address, broadcast address, and network mask. It also shows how many packets were received and transmitted. There is also information about the loopback device (lo). ping The ping command allows the user to test whether or not a network connection is
Linux Command | Function |
ifconfig also: ifcfg, ifup, ifdown, ethtool, nm-tool /etc/init.d/networking restart ip link set down ip link set up |
The ifconfig command is a tool used to display and configure network interfaces. This command will display information about the network card, IP address, broadcast address, and network mask. It also shows how many packets were received and transmitted. There is also information about the loopback device (lo). |
ping | The ping command allows the user to test whether or not a network connection is active, the speed of that connection, and how a network behaves given specific data loads. |
arp also: arping |
The arp command by itself is used to view the information currently in the ARP table (Address Resolution Protocol). This table maps the IP address of machines on your network segment with their MAC address. |
hostname also: domainname, dnsdomainname |
The hostname command tells you what the hostname of your machine is set to. The hostname is determined from a number of sources, such as the /etc/hosts file. On Ubuntu, the /etc/hostname file is used to set your machine's hostname |
nslookup also: host, dig |
These commands query the DNS determine information about network hosts. If you supply the IP address, the command gives the hostname. If you supply the hostname, the command gives you the IP address. All three commands use the /etc/resolv.conf file to determine the DNS server(s) |
traceroute also: tracepath | This program prints the route along which an IP packet travels from the local host to reach the destination host. It also shows each hop along the connection route from a local to remote host and gives all the intermediate routers. |
Other Linux networking commands: route, ip, ipcalc, nmap, lokkit, iptables, ... |
Use the information in the table above to answer the following questions. For each question, write
down the Linux command/file name which provided you with the answer.
1. What does Linux call the NIC connected to the Ethernet cable?
__________________________________________________________________________________
________________________________________________________________________________
2. How many hops are there to the Google web server?
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
3. What is the IP address of the NUST web server?
__________________________________________________________________________________
__________________________________________________________________________________
4. Determine your hostname.
__________________________________________________________________________________
5. Determine your IP and MAC addresses.
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
6. Determine your neighbour’s MAC address.
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
7.Write down the number of hops that it took to reach the www.coursera.org
Compare the results to those in no.2 and explain why the results are different.__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
8.Determine your DNS server IP addresses.
__________________________________________________________________________________
__________________________________________________________________________________
9.a) Open the following file: /etc/network/interfaces. Explain the information displayed.
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
b) In the same file, disable the use of DHCP and use static addresses. What is the information in your
new file?
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
c) Verify that the DHCP has been disabled.
________________________________________________________________________________
d) Create a second loopback interface lo:0. Give it an IP address of 172.21.21.21. The subnet mask is
255.255.0.0. Activate the loopback interface.
Trending now
This is a popular solution!
Step by step
Solved in 3 steps