If you obtained a drawing that contained Auto CAD polylines representing contours, what is the best way to add them as data to a surface? Select one. Oa Create a new surface, add the polylines as drawing objects O b Create a new surface, add the polylines as breaklines O c. Create a new surface, add the polylines as DEM Od Create a new surface, add the polylines as contours

Q: 4" 8" 6"

A: Solution:- Centroid of the given section: Table for calculation  Area inch2 x- coordinate inch y-…

Q: Additional Problem #2 30 mm Locate the centroid of the cross-sectional area at right. Sketch the…

A: The given figure is shown below:

Q: Find the vertical and horizontal line detect segmentation

A: Detecting vertical and horizontal lines in an image is a common task in image processing and…

Q: Live and Rectangle mode, Arc and Circle mode, and Dimension and Alphanumeric mode  symbol modes are…

A: Computer-aided drafting is used to draw the plannings of the building and drafting of the planning.…

Q: Given the isometric view of the cut block objects shown, use rectangular grid paper to sketch a…

A:

Q: Calculate the shear force and bending moment diagrams with manual calculation and verify using Space…

A:

Traverse Survey

Traverse surveying is a popular method of surveying. Traversing is that type of survey where several connected survey lines form a framework and the directions and lengths of the survey lines are measured with the help of a tool to measure angles and tape or chain respectively. Traverse networks involve placing survey stations in a queue or trail and using pre-tested points as a basis for looking at the next point. This type of surveying is different from Tacheometric surveying, where only angles are measured and the process of chaining is reduced.