If v1= -10 sin (t-30°) V and V2= 12 cos (t+ 45°) V,find vt= V1+ V2.O - 12.158 cos (w t - 55.95) VO - 12.158 cos (w t + 55.95) V12.158 cos (wt - 55.95) VO 12.158 cos (w t + 55.95) V Evaluate the complexnumber: (4050°+ 20-30°)1/26.91 /_ 12.816.91 /_ -11.816.91 /_ 11.81O 6.91 /_ -12.81

According to the question we have to calculate the value of vt and solve given expression.

Answered: If v1= -10 sin ( t-30°) V and V2= 12…

If v1= -10 sin ( t-30°) V and V2= 12 cos ( t+ 45°) V, find vt= V1+ V2. O - 12.158 cos (w t - 55.95) V O - 12.158 cos (w t + 55.95) V 12.158 cos (wt - 55.95) V 12.158 cos (wt + 55.95) V

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Find the phase relation for the following pairs of sinusoids, (which leads and lags which by how…

Q: Consider the following circuit consisting of an AC generator V-V.sin(et), a capacitor C, an inductor…

A: Given circuit diagram is shown below. Here the AC generator is V=Vosinωt Volts. We need to find the…

Q: Prove the following expression by using phasors: 10 cos(@t)+10sin(@t) = 14.14 cos(@t – 45°)…

A: The solution is given below

Q: Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A.…

Q: A capacitor of C = 30 µF is connected in series to a resistor R = 252 and an AC source operating at…

A: In this question We need to determine the all unknown parameters. We know Inductive Reactance XL =…

Q: For the Phasor diagram shown, find for every component the p.d. after that draw the Circuit. Can…

A: Power Factor- It is developed as the angle in voltage and current which is known as the power…

Q: A sinusoidal source is v(t)=2 sin 500t. Determine the Vmax. Determine the frequency. Determine the…

Q: 4. With respect to the following figure, explain why vo does not follow v₁ until VÂ – Vy and follows…

A: Given:A diode circuit, with output waveform, we need to explain:the operation of the circuit. Assume…

Q: circuit shown in Figure, find its Vrms (gen) and inductive reactance. After that, solve for its…

A: In this question we will find total impedance , total current and voltage across all components...

Q: An AC series circuit has R=300 ohms, L=0.90H, and C=2.0microfarad with a generator of 50V andw= 1000…

Q: 1- What is the mutual admittance, Y34, of the electric circuit shown in Figure ? Select one: a.…

Q: impedance of a series RC circuit is given as (8- j6) ohms and is connected to an ac source of…

A: In this question , we will find capacitive reactance...

Q: phase of 0 degrees, and its frequency is 5000 rad/s. a)Find VTH and ZTH for the thevenin equivalent…

Q: Zin w=10 krad/s aQ www + υ - duF HE O a. Zin = 1660,50 + j213,73 ohm O b. Zin = 1107,00 + j267,73…

Q: i, = 3 sin(377t + 60°) R1.2 N XL 1.20 Ω Χ. 20 Xc

A: The solution is given below

Q: 12 cos 3t V R www + L m 4 sin 2t A 10 V If we would like to use Superposition to solve for vo in the…

Q: QUESTION 6 R www m + + 12 cos 3t V Vo 4 sin 2t A 10 V If we would like to use Superposition to solve…

A: Here we use the superposition theorem yo calculate Vo due to current source.

Q: Find Zc || z, = 12 + j52 Z2=7- j242 z,=8+ j6N ZA O 24.763 - j34.568 ohms 20.14 - j51.48 ohms 55.06 +…

Q: voltage source, E = 10 VZ30°, is applied to a capacitive impedance of 202. Solve for the phasor…

A: Step 1: Step 2: Step 3: Step 4:

Q: Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A.…

Q: Evaluate 8/10° +62-20° 9280°-4250° O 0.50 +j2.24 O -0.50-12.24 O 50-j224 O -50-j224 and express the…

Q: For the circuit of Figure, find the apparent power delivered to Zc if ZA= 5-12 12, ZB = 30, Zc = 8 +…

Q: Apply a sinusoidal input voltage with 2V p-p and vary the frequency according to the table below.…

Q: Find the sinusoids

Q: Standard alternating e.m.f. achieves its positive maximum value at 90°. Select one: True False

A: We know Standard alternating EMF = BLV. sin(∆)

Q: The circuit below is operating under sinusoidal steady-state conditions. Find the phasor voltages…

Q: 11.24 (A)* Consider the high-pass, active filter shown in the Figure P11.24. If vi(t) = 12 cos (1000…

A: given circuit is components are input voltage is to determine the output…

Q: Find the phase relation for the following pairs of sinusoids, (which leads and lags which by how…

A: In this question, Find the phase relation for the following pairs of sinusoids, (which leads and…

Q: 8. Two signals vi(t) = 1.5cos(wt+0.2) and v₂(t) = .62cos(wt-1.7) are added. Find the phasor sum.

A: In this question, We need to determine the phasor of the sum of the both signals. We are solving…

Q: The sinusoid of the phasor I =-15 50 i i(t)=I m Cos (ut+$) where: $= (---- ) ° Im=(--)A

A: Phasor is a vector representation of a sinusoidal function. A complex number can be represented in 3…

Q: j2 2 ell 10.640° 10 2 -15 2 20 i, Find the currents i, İ, and i, in this sinusoidal steady-state…

A: The equivalent circuit with assumed mesh current in each mesh is shown below: In above circuit, the…

Q: Find v₁ and v2 for o= 10000 rad/sec. Sketch the waveforms for vs, v₁ and v₂. Repeat for 0= 100…

A: Given Data:DC and AC equivalent circuits of a main circuit having both,DC voltage andAC voltage To…

Q: AV X ms Soru 3) Yukarıdaki grafikte periyot T-76 ms ve iki işaret arasında X=8 ms zaman farkı…

Q: A certain impedance has a phasor voltage of V = 25221° across it and a phasor current of I = 3450°…

Q: QUESTION 5 R www L roo + + 12 cos 3t V Vo 4 sin 2t A 10 V If we would like to use Superposition to…

A: In this question we need to find a amplitude of voltage Vo only when sinusoidal voltage source is…

Q: In the circuit shown in Figure, find its Vrms (gen) and inductive reactance. After that, solve for…

Q: For the next three items, consider a series R-L-C circuit energized by a sinusoidal voltage source…

A: In this question, we need to determine the phase angle between voltage and current. Also need to…

Q: For the coupled circuit shown, find the 12 J52 A J82 value of mutual inductance "M" and put the dots…

A: The solution is given below

Q: Add : V, = 30 cos (w t + 50°) Vz= 50 cos (wt -b0°) a. Per for m V, + Vz = V signal b. Find v and…

A: Since both the given voltages of same reference which is cosine function hence we can directly add…

Q: Write a report to compare between Ac Through capacitance and AC through in inductance then: For the…

Q: Four Circuit elements are Connected , Sinusoidal altemating v series qiven Sy e = 110sin Cut + 30).…

Question

100%

If v1= -10 sin (
t-30°) V and V2= 12 cos (
t+ 45°) V,
find vt= V1+ V2.
O - 12.158 cos (w t - 55.95) V
O - 12.158 cos (w t + 55.95) V
12.158 cos (wt - 55.95) V
O 12.158 cos (w t + 55.95) V

Evaluate the complex
number: (40
50°+ 20
-30°)1/2
6.91 /_ 12.81
6.91 /_ -11.81
6.91 /_ 11.81
O 6.91 /_ -12.81

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Introduction to Ac circuits. show detailed illustration and step by step solution
Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A. Determine the power factor and state whether lagging or leading. Show your solutions. Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A. Determine the APPARENT POWER in VA. Show your solutions. Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A. Determine the REACTIVE POWER in VAr. Show your solutions. Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A. Determine the TRUE POWER in watts. Show your solutions.
4) Find current phasor I for the following AC steady state circuit. j35 O -j14 2 12/0° V 103 n3 j25 Q
Answer should be in rectangular form only
A sinusoidal voltage source V = 53 /67o Vrms feeds an impedance with a current I = 5 /33o Arms. The apparent power generated by the source is: Select one: a. 118.64 VA b. 80.02 VA c. 286.2 VA d. 265 VA e. 71.55 VA
3
For the circuit shown below, Given that V= 10020°V, and I 304Z30 Ams. %3D then the values of P2 rms and Q3 are given as Is P2 600 VAR Сарacitive 800 W 1200 W 1400 VAR Vs Inductive
SUBJECT: CERCIT
Problem: Five linear components of complex impedances Z1, Z2, Z3, Z4 and Z5 are connected as it is shown in the circuit bellow. They are supplied by a sine wave voltage source U. Z1 Z4 Il Z3 13 Z2 Z5 If it is known that: Z1 Z3 Z4 Z5 II 13 Ω Ω Ω Ω A A 30 + j5 30 + j10 30 + j15 0+ j25 0.470 - jo.114 0.002 - j0.007 A) Find the average power that each component dissipates; B) Find the average power absorbed by the circuit; C) Verify the results.
Solve for step by step process with complete solutions
4) Given: R = 700-N, Xc = - j 500-N, e(t) = 150 sin(wt) V Find: a) Total impedance of the ckt. b) Total current in phasor and sinusoidal form c) Voltage drop across the resistor and capacitor in phasor and sinusoidal form d) Total Power and Power factor
A 110 MVA 50 kV three phase generator has a subtransient reactance of 12%. The generator supplies one motor over a transmission line having transformers at both ends as shown in Fig. The motor have rated input of 100 MVA 28 kV with 11% subtransient reactance. The rating of the sending end transformer, Ty is 80 MVA, 35 kV / 200 kV (A-Y) with leakage reactance of 18% Transformer T2 at the receiving end has 60 MVA 15 KV/200 KV (A - Y). The leakage reactance of T2 and is 16%. Series impedance of the 40 km line is 100 ohms. Draw the reactance diagram with all reactance marked in p.u. Choose 110 MVA and 35 kV as the base values. Generator T Motor Zpu new of the Generator Zsu new of the Transformer 1 KV, New for Transmission Line Zau new for the Transmission Line Zpu new of the Transformer 2 KV, New for Motor Zpu new for the Motor win