4. With respect to the following figure, explain why vo does not follow v₁ until VÂ – Vy and follows only when v₁ ≥ VB - Vy in the positive half cycle? What happens in the negative half-cycle? Explain. Assume a sinusoidal current of Iosin(ot) from v₁, what is the voltage drop across R when vo pert follows vand vo does not follow V₁. + R vo VB-Vy

4. With respect to the following figure, explain why vo does not follow v₁ until VÂ – Vy and follows only when v₁ ≥ VB - Vy in the positive half cycle? What happens in the negative half-cycle? Explain. Assume a sinusoidal current of Iosin(ot) from v₁, what is the voltage drop across R when vo pert follows vand vo does not follow V₁. + R vo VB-Vy

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

When a resistor is connected across the terminals of an ac generator (117 V) that has a fixed frequency, there is a current of 0.332 A in the resistor. When an inductor is connected across the terminals of the same generator, there is a current of 0.365 A in the inductor. When both the resistor and the inductor are connected in series between the terminals of this generator, what is (a) the impedance of the series combination and (b) the phase angle between the current and the voltage of the generator? Note: The ac current and voltage are rms values and power is an average value unless indicated otherwise. (a) Number (b) Number Buda i Vrms R Irms.R Circuit 1 Units Units Vrms. Irms, L Circuit 2 > L Vrms R www Circuit 3
An electrical engineer is working with a parallel AC circuit. The circuit draws 8 ohms on a resistive branch, and the angle of the total impedance is 35°. What is the approximate number of ohms on the inductive branch? O 0.7 O 4.59 O 5.6 O 6.55
Let's say V= 10 sin( 2r) is a refence sinusoid. Then its phasor diagram is drawn as shown in Figure 1. V (a) (b) (c) (d) Figure 1 a B
Consider the following circuit used to provide power for an induative RL load. The input voltage is V-100V and the load has a 50 impedance value. The thyristor is working at a frequency fs = 2 kHz. The discharge current is to be limited to 40A and the required dv/dt is 40V/us. If the value of Ce is equal to 0.14uF, then the snubber losses are equal to: R. V. Select one: O a 5.4W O b. 7.4W 1.4W Od. 3.4W
An emergency power supply is required to provide a three-phase sinusoi- dal voltage source of 208 V (L-L) at a frequency of 400 Hz. The power is to be obtained from a battery consisting of cells in series, each cell hav- ing an internal voltage of 2.2 V and an internal resistance of 0.006 m. The load on the three-phase, 400-Hz system requires a fundamental fre- quency apparent power of 7.2 kVA at 0.9 power factor lagging. The in- ductance of the load is such that harmonic currents are negligible. How many cells should be connected in series to provide the required output? The switches may be regarded as ideal.
Problem 3 a) In Figure 1, the current through a 550 nF capacitor is i= 12 x 10-3 A sin(2000t + 20°). What is the sinusoidal expression for the voltage e? b) In Figure 2, the voltage across a 110 mH coil is e = 150 V sin(377t + 45°). What is the sinusoidal expression for I %3D the current i? i – - e e Figure 1 Figure 2 Page 1 of 2
please answer alll subparts for like either dislike... 1. Find the total real power supplied by the source 2. The total reactive power supplied by the source is 3. The magnitude of the total apparent power is 4. The power factor of the source is 5. A capacitor is connected across the loads as indicated in Figure 1 to improve the power factor to 0.95 pf lagging The required reactive power supplied by the capacitor is 6. The value of the capacitor is
4) Therenin's Equinlena Circuit and Marimum Poer truns fer Thiorem a) For the Circuit derive the given in the figure, therenin's eq uivalence Circuit acrass the branch witn the loud impedanu. b) Culculate to deliver the volue of the load Impedanca makimum power to the load, c) caleula te the Power dissipa ted through the loud, 72
Īs L₁ ~ Load 1: 200 W, unity power factor Load 2: 1200 W at 0.85 power factor lagging Load 3: 400 W + j100 VAR Load 4: -200 VAR । [+ L₂ L3 L4
The picture shows three LC circuits, two of them with capacitors of capacitance C and the three with coils of inductance L, the three circuits are coupled by means of two capacitors Cc capacitors.L inductance coils, the three circuits are coupled by means of two capacitors of capacitance Cc. The currentscirculating through each mesh are those indicated in the figure: I1, I2 and I3. Using Kirchhoff's law for voltagesand taking into account the definition of current I = -dQ/dt, find the system of coupled equations for the systemand then find the angular normal frequencies of the system.
R + 12 cos 3t V Vo 4 sin 2t A 10 V If we would like to use Superposition to solve for v, in the circuit shown above, we must find the individual contribution of .each independent source :SINUSOIDAL CURRENT SOURCE CONTRIBUTION What is the amplitude of the voltage v, considering only the contribution of the sinusoidal current source? Assume that R = .15 Ohms, L = 11.6 Henry, and C = 0.02 Farad .Write your answer in Volts
]What happens when we encounter a circuit that has all 3 components in series? Parallel? How do we figure out what our phase relationship in a series reactance and resistive circuit? Parallel?