Answered: If the total power is 450 kW in a power…

If the total power is 450 kW in a power measurement of a 3- Phase delta connected load by 1- wattmeter method, Calculate wattmeter reading. a. 150 kW

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A 425 V, 3-phase star connected alternator supplies a delta-connected load, each phase of which has a resistance of 55 Ohms and inductive reactance 36 Ohms. Calculate (a) the current supplied by the alternator (b) Power Factor of the load and (c) the output power of the alternator. Phase Current Power Factor of the Load Output Power When the two-wattmeter method is used to measure the input power of a balanced load, the readings on the wattmeters are 90 kW and 15 kW, the connections to one of the coils on the meter reading 15 kW having to be reversed. Determine (a) the total input power, and (b) the load power factor. Input Power Power factor
A three-phase motor running on full-load at an efficiency of 90% is measured by two Wattmeter's which indicate 275 kW and 125 kW respectively. The power factor is ....................
In the balanced three phase power measurement using two wattmeter method, each wattmeter reads 18 kW , when the pf is unity. What does each wattmeter reads when the pf falls to (i) 0.707 lag and (ii) 0.422 lag. The total three-phase power remains unchanged. (i) W1 at 0.707 lag (i) W2 at 0.707 lag (ii) W1 at 0.422 lag (ii) W2 at 0.422 lag
In an Industry, three phase power measurement is carried out, using two wattmeter method, each wattmeter reads 14 kW , when the pf is unity. What does each wattmeter reads when the pf falls to (i) 0.6 lag and (ii) 0.819 lag. The total three-phase power remains unchanged.
Two wattmeters were connected to measure the power of a balanced three phase load. If the readings were 622 Watts and 402.6 watts, what is the total reactive power of the load is in VARS.
In the two-wattmeter method of power measurement for a three-phase load, the readings of the wattmeter are 2000 W and 1000 W. What is the power factor of the load?
power factor on 1100 V, 50 Hz mains. The power factor of the system is improved from 0.6 lagging to 0.95 lagging by using a capacitor bank embedded in delta. Assuming the KVA of the load remains constant, indicate the rating of the capacitor and find how much additional kW can be obtained. And If the capacitor bank is connected in star, indicate the rating of the capacitor
An alternator is connected in star. If the phase voltage is 110 V, the line voltage is *
Please show your clean and complete solution. Thank you so much!
moodle.nct.edu.om/mc arning Portal Courses - Reports Academic Departments ETC - e-Services - CIMS - In two wattmeter 3-phase power measurement method, if the two wattmeter readings are equal then the power factor of the circuit is O 0.866 O 0.5 O 1 The speed of a dc motor is O directly proportional to the flux O inversely proportional to the flux O inversely proportional to applied voltage O inversely proportional to back emf Windows L In DC machines, yoke is made up of hp
I need the answer quickly