In two wattmeter 3-phase power measurement method, if the two wattmeter readings are equal then the power factor of the circuit is O 0.866 O 0.5 O 1

Q: Transform

A:

Q: Load 1 consists of three resistors with a resistance of 6 ohms each, connected in wye and the phase…

A:

Q: d, what would be the new impedance?

A:

Q: Find the current through each resistor USING KIRCHHOFF'S LAW. Use Cramer's Rule.

A: Redraw the given circuit by resolving currents I3 and I6 in terms of Ix as follows. Figure 1

Q: 12/0* v 10 10 ww 10 2/0 A A

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 2. A 25 cycle current is 15+j0 amp flows in an impedance having a resistance of 17.32 ohms and…

A: 2. Given data, Frequency, f=25 Hz Current, I=15+j0 A Resistance, R=17.32 A Inductive reactance,…

Q: 1- Calculate the voltage across the dependent source. 20 + 2420 V In vo j2a

A:

Q: 53. Determine the voltage at point C shown below with respect to ground: A 100 2 120 V= 50 2 B ww

A: we need to find out voltage at point c with respect to ground.

Q: Hi the question in the photo but can you please just find the percentage voltage regulation with…

A: Explanation: load = 10 kVA load voltage (Vfl) = 240 volt Power factor = 0.78 Therefore, Load current…

Q: 1:) A tvee-phare afternator 2500 KW at alnQ KV and a hoad of vypplies pf of 0.7. Arroning the…

A:

Q: 12 10A 20A

A:

Q: Problem 1 392 492 + 12V Find the power of the current-dependent voltage source. (292) moldo19 492 6i…

A:

Q: Find the equivalent resistance seen by the generator 10v. 552 552 10V + IG Vo ww 552 Select one: O…

A:

Q: A 13.2KV, 60H2 Single phase lina Connects a Substahon o an resistunce Tha line Voltape is l.5 kV and…

A: Consider that the line voltage is V and line  current is  I, the active power, reactive power and…

Q: 2. Find 1₁, 1₂ and 13. 552 M 20V +1 350 SI HI₂ 12 100 W W 12-2 W 150 Із 300 M 4052 2052

A: We need to find out the current for given circuit. We will simply the given circuit then we will…

Q: 3. A 60 cycles current 2.8+j 0 flows in a series circuit having a resistance of 40 ohms, an…

A:

Q: What is the phase relation between given voltage current? and v = 25 sin(@t –15°)V i=12.5 sin(@t…

A:

Q: 2. Solve for the branch currents using any method. 10V 15V 50 50 20V

A: In this question,   We need to determine the branch current.  We are solving this method using the…

Q: Determine the power factor of the source. R = 6 Ohms

A: The given circuit diagram is shown below,Here, the value of R is 6 ohms.So,

Q: From the figure given below, find the current flowing through 10 Q resistance, using Kirchoff's law.

A: The required current through the resistor can be calculated by using the kirchhoff's current law.

Q: 3 V = 400V W₁ W₂ 50/4550/36.87 3-0 load 75 KVA PF = 0-8 lag Sequence: 1-2-3 Solve for wattmeter…

A: Wattmeter:- It is a device which displays the measured power. Voltage, current, power factor, power…

Q: evalue of real

A:

Q: 1 Ohm 2 Ohms Ohms 4 Ohms ELECTONICS H 220V H Ohms

A: Brief description:  In the above given question they have mentioned an electrical circuit which is…

Q: The unit for three phase apparent power is Select one: O a. KW O b. V O C. KVA O d. KVAR

A: The apparent power is defined as the combination of the reactive power and the true power and is…

Q: With the power off, construct the following circuit using MultiSim. + V - R1 2200 十 V3 E 16V R2 3300…

A:

Q: ww B 10 V 'DŽ 12 2 Ic E 12 V

A: Nodal analysis is nothing but combination of both KCL and ohm's law.

Q: 2260'A j40 60 20 j20 24,079 ll le

A:

Q: Problem 4 Determine the total average power supplied to the network and the amount of average power…

A: In this question, we need to determine the total average power and average power across by each…

Q: 2. Determine x using delta to wye transformation. In Bn 1o0V +

A:

Q: Q4- Calculate the voltage between "a" and "b" using Thevenin's theorem. 562 jsa -102 HH -jsn 80/60°…

A:

Q: The voltage from A to N in a balanced three phase circuit is 240 ∠-30° V. If the phase sequence is…

A:

Q: The two wattmeter method is used to measure the power in a three-phase load. The wattmeter readings…

A: Given- Three phase load-Wattmeter readings=400W  & (-35) WTo Find-The total active power Pactive

Q: A voltage and current applied to a single phase load is  v= 25 sin (300t+30)  and i= 18 sin (250t-…

A: According to question we have to find,  Phase angle, active power, reactive power.

Q: Consider the following parallel connected loads with the following characteristics L1: 1.2kW purely…

A: In this question we need to find the reactive power (in kVAR) needed to be supplied by a capacitor…

Q: Ex2 R finel power Re5o JORDAN - AMMAN Tz Z

A:

Q: 52 IG 10V 302 12Ω Vo 72

A:

Q: + R 15 V =4V

A: The solution is given below

Q: Using Kirchhoff's Laws, calculate the current flowing through each branch of the shown. 6+j8 4.47…

A: In this question we will find currents in each branch......

Q: Find the current through each resistor USING KIRCHHOFF'S LAW. Use Cramer's Rule. 13 50 <1 0.5/x I5…

A:

Q: Determine Vo for the network during the negative half-cycle. 1 kQ +8 V Si +. 4 V 8 V

A:

Q: 3. The following are the symmetrical components sequence of phase B current: Positive = 10 cis 45…

A:

Q: ef: when 3¢-V= 3e0 Vs300 300 53 WHY IN VOLTAGES WHEN SWITCHING FROM THREE-PHASE TO SINGLE-PHASE WE…

A: In this question we will write  line voltages and phase voltages....

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.