Answered: If the standard reduction potential for…

If the standard reduction potential for Copper is 0.34V, calculate the reduction potential for silver. Galvanic Cell Standard Conditions.pdf 1054 KB A. 1.10 V O B. 0.80V O C. 0.13V O D. 46V

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter18: Electrochemistry

Section: Chapter Questions

Problem 150CP: Given the following two standard reduction potentials, solve for the standard reduction potential of...

See similar textbooks

Similar questions

Electrochemical Cells II Consider this cell running under standard conditions: Ni(s)Ni2(aq)Cu+(aq)Cu(s) a Is this cell a voltaic or an electrolytic cell? How do you know? b Does current flow in this cell spontaneously? c What is the maximum cell potential for this cell? d Say the cell is connected to a voltmeter. Describe what you might see for an initial voltage and what voltage changes, if any, you would observe as time went by. e What is the free energy of this cell when it is first constructed? f Does the free energy of the cell change over time as the cell runs? If so, how does it change?
Determine the overall reaction and its standard cell potential at 25 C for this reaction. Is the reaction spontaneous at standard conditions? Cu(s)|Cu2+(aq)Au3+(aq)|Au(s)
Consider a galvanic cell based on the following half-reactions: a. What is the expected cell potential with all components in their standard states? b. What is the oxidizing agent in the overall cell reaction? c. What substances make up the anode compartment? d. In the standard cell, in which direction do the electrons flow? e. How many electrons are transferred per unit of cell reaction? f. If this cell is set up at 25C with [Fe2+] = 2.00 104 M and [La3+] = 3.00 103 M, what is the expected cell potential?
Consider a galvanic cell based on the following half-reactions: a. What is the standard potential for this cell? b. A nonstandard cell is set up at 25C with [Mg2+] = 1.00 105 M. The cell potential is observed to be 4.01 V. Calculate [Au3+] in this cell.
Using values from the table of standard reduction potentials, calculate the cell potentials of the following cells. (a) Ga(s)|Ga3+(aq)Ag+(aq)|Ag(s) (b) Zn(s)|Zn2+(aq)Cr3+(aq)|Cr(s) (c) Fe(s),FeS(s)|S2-(aq)Sn2+(aq)|Sn(s)
An aqueous solution of an unknown salt of gold is electrolyzed by a current of 2.75 amps for 3.39 hours. The electroplating is carried out with an efficiency of 93.0%, resulting in a deposit of 21.221 g of gold. a How many faradays are required to deposit the gold? b What is the charge on the gold ions (based on your calculations)?
a Calculate G for the following cell reaction: Tl(s)Tl+(aq)Pb2+(aq)Pb(s) The Gf for Tl+(aq) is 32.4 kJ/mol. b From G, calculate the standard cell potential for the cell reaction and from this, determine the standard potential for Tl2+(aq)+eTl(s).
An aqueous solution of an unknown salt of vanadium is electrolyzed by a current of 2.50 amps for 1.90 hours. The electroplating is carried out with an efficiency of 95.0%, resulting in a deposit of 2.850 g of vanadium. a How many faradays are required to deposit the vanadium? b What is the charge on the vanadium ions (based on your calculations)?
The equation G = nF also can be applied to half-reactions. Use standard reduction potentials to estimate Gf for Fe2+ (aq) and Fe3+ (aq). Gf for e= 0.)
For the cell: Cr|Cr3+Co2+|Co E° is 0.46 V. The same cell was prepared in the laboratory at standard conditions. The voltage obtained was 0.40 V. A possible explanation for the difference is (a) the surface area of the chromium electrode was smaller than the cobalt electrode. (b) the mass of the chromium electrode was larger than the mass of the cobalt electrode. (c) the concentration of Cr(NO3)2 solution used was less than 1.0 M. (d) the concentration of Cr(NO3)2 solution used was less than 1.0 M. (e) the volume of Cr(NO3)2 solution used was larger than the volume of Cr(NO3)2 solution used.
The mass of three different metal electrodes, each from a different galvanic cell, were determined before and after the current generated by the oxidation-reduction reaction in each cell was allowed to flow for a few minutes. The first metal electrode, given the label A, was found to have increased in mass; the second metal electrode, given the label B, did not change in mass; and the third metal electrode, given the label C, was found to have lost mass. Make an educated guess as to which electrodes were active and which were inert electrodes, and which were anode(s) and which were the cathode(s).
For the standard cell potentials given here, determine the ?G for the cell in k].. (a) 0.000V,n=2 (b) +0.434V,n=2 (c) -2.439 V, n = 1