If the motion of a jet after landing on a runway is shown by the a-t graph below. Note that at t 0 s, s = 0 m and v = 461 %3D %3D m/s. What is the velocity (v) at time t 22s? Answer in Whole number. Numerical values only. Don't indicate units here, just on the submitted solution. a (m/s) 10 20 (s) -10 -20

If the motion of a jet after landing on a runway is shown by the a-t graph below. Note that at t 0 s, s = 0 m and v = 461 %3D %3D m/s. What is the velocity (v) at time t 22s? Answer in Whole number. Numerical values only. Don't indicate units here, just on the submitted solution. a (m/s) 10 20 (s) -10 -20

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

9. A baby crawls toward a toy. Its motion is shown on the following graph of x vs t. What is the average speed of the baby between at t = 0 and t = 4 s? z(m) 3- 2- t(s)
The tire wrench shown in the accompanying figure is used to tighten the bolton a wheel. Given the information on the diagram, determine the moment about point O for the two loading situations shown:a. pushing perpendicular to the wrench armb. pushing at a 75° angle.
note: use 3 decimal places
four decimal places
In the given figure below, a tube was supported at A and E with a ball and socket and a wire at D connected to F. Determine the following give that Force F is equal to 690.86 N. Note: Express your answer in terms of the units. Observe 3 decimal places. The error threshold is ± 2.50% Relative to the right answer. XB: 188.419mm Xc: 471.768mm Ya: 209.808mm Ze: 155.444 mm Zf: 471.096 mm 1.) Determine x-component of vector DF. 2.) Determine the y-component of Vector DF 3.) Determine the z-component of Vector DF. 4.) Determine the moment experienced by the system assuming that there is no wire support.
Velocity in a fluid flow is expressed as V= (x³y² + 2zt)i + (2y² + xyt)j + (12xyt)k The magnitude of x-component of acceleration of a particle of fluid at point (1, 1, 1) at t = 2 seconds is ___________ units (round off to nearest integer).
If the motion of a jet after landing on a runway is shown by the a-t graph below. Note that at t = 0 s, s = 0 m and v = 441 m/s. What is the velocity (v) at time t = 25s? Answer in Whole number. Numerical values only. Don't indicate units here, just on the submitted solution. ********* a (m/s) 10 20 | (s) 10 20
Give me right solution according to the question
The x-coordinate of a particle in curvilinear motion is given by x = 5.3t³ - 2.2t where x is in feet and t is in seconds. The y-component of acceleration in feet per second squared is given by ay = 5.5t. If the particle has y-components y = 0 and vy = 2.8 ft/sec when t = 0, find the magnitudes of the velocity v and acceleration a when t = 4.4 sec. Sketch the path for the first 4.4 seconds of motion, and show the velocity and acceleration vectors for t = 4.4 sec. Answers: V = a = i 305.636 141.997 ft/sec ft/sec²
In the figure shown: Given: ac/B =50 mm/s2 (1) aD/A=90 mm/s² (4) Find: a) velocity(mm/s) of C when t=4s b) distance travelled(mm) by D after 2 s. (note: constant acceleration for each component and it started from rest) A B D
A venturi meter is a device that is used for measuring the flow rate of a fluid within a pipe. Gas is flowing at speed v2 through a horizontal section of pipe, as shown in the figure below, whose cross-sectional area is A2 = 0.0700 m2. The gas has a density of p = 1.30 kg/m. The venturi meter has a cross-sectional area of A1 = 0.0500 m2 and has been substituted for a section of the larger pipe. The pressure difference between the two sections is p2- P1 = 120 Pa. Find: (a) Find the speed vy of the gas in the larger, original pipe. (b) Find the speed vị in the venturi. (c) Find the volume flow rate O of the gas. Hi Lo P1 A2 2 A2 2 A1 Venturi meter
A particle moves that is defined by the parametric equations given below (where x and y are in meters, and t is in seconds). Compute the radial component of the velocity (m/s) at t = 2 seconds.