If the farmer applied 120-50-40 kg N-P2O5-K2O in a 1 hectare of rice farm, how much Urea (46-0-0) will be needed to satisfy the requirement? * A.) 261 kgs B.) 55.2 bags C.) 108.7 kgs D.) 571 kg

Q: A.How many independent material balances can be written? B.How many unknown variables can be…

A: Given:70 kg/min of 5% aqueous H2SO4 solution is mixed with 30 kg/min of 3% aqueous solution.We can…

Q: Diced potatoes are being dried in a drier using heated air. 20kg of potatoes at a moisture content…

A: Let's first calculate the mass of moisture in the potatoes:let's also calculate the mass of dry…

Q: A sample of Al203 with an available surface area of 871 m2 is suspended in 148 mL of 0.01 M KNO3.…

A: Initial surface area=871 m2 Moles of KNO3=1.48 x 10-3moles KOH required later=1.473 x 10-3moles…

Q: Figure P5.6 shows a plot of BOD remaining versus time for a sample of effluent taken from a…

A:

Q: H.W (3.1) : Evaluate the given crude oil ° API 36.3 Volume percent TBP Temperature ( "F) 5 62 10 144…

A: (3.1)  specific gravity for whole crude = 141.5/(131.5 + API) for the crude the specific gravity =…

Q: Show all work, include units, keep work as precise as possible and only apply sig figs to report…

A: Given that: Concentration of nitrous acid (HNO2) solution = 0.75 mol/L Volume of HNO2 solution =…

Q: Calculate the value missing and assume that the mass of protein is 8kg Mass of the Percentage (%)…

A:

Q: A binary distillation is performed so that a distillate 94% and bottoms 8% in of the more volatile…

A: Given data:  Feed flow rate = 600 kmol/h Composition of feed, A = 40 mol % B = 60 mol % Composition…

Q: Alum is used as a coagulant. The best dry alum dose from the jar tests is 10 mg/L. Assume dry alum…

A: Given that, The dose of alum = 10 mg/L Converting into kg/L, the dose is = 10 mg = 10×10-6 kg = 1×…

Q: In the catalytic decomposition ofhydrogen peroxide experiment the following results were obtained :…

A:

Q: 1. Given the chemical composition by weight to a sample of the cement as follows Ca O SiOz Al203…

A: Chemical Composition by weight to a sample of the cement is: CaO SiO2 Al2O3 Fe2O3 SO3 MgO LOSS…

Q: 27. Calculate the molarity of NaOH(40 g/mol) solution if 1w.25 mL qas used to tirate 0.2615 gram of…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 0.92 B 0.08 T 0.00 X C2 rio 0.45 B С1 X82 0.40 T 0.15 X (1-XB2-KT2) 0.00 B 0.04 T 0.96 X (1-X83-XT3)…

A: Given: n0 = 400mol/min So, B0 = 180mol/min T0 = 160mol/min X0 = 60mol/min

Q: Q2/ A limestone analyses (wt%): CaCO; 87%, MgCO3 8.5% and Inert 4.5%. By heating the limestone you…

A: Calcium carbonate is a common substance found in rocks as minerals calcite and aragonite. It is also…

Q: Determine the number of moles in each fraction. Assume that the sample is 10 g in the beginning.…

A: In the table the number of moles are given in milli moles .

Q: Calculate the percent Fe (AW = 55.85) in a 0.2802 gram sample that requires 29.68 mL of 0.01831 M…

A:

Q: n a converter, 40.82 kg of SO3 is fed and allowed to come into contact with a certain amount of…

A: Given data: Weight os SO3=40.82 KgAmount of H2SO4=90.12%Amount of Oleum=3.03%Molecular Weight of…

Q: Temperature, °C 10 1200- 1064.43°C 1000- 800- 600- Weight Percent Gallium 20 30 423°C 12.2 410°C…

A: The melting points of the components are typically represented by the temperatures at which the pure…

Q: Yeast cells grow in the exponential phase. The cell mass concentrations are given in Table 4.4.…

A: Write the expression for the cell growth as follows: Cx = Cx0expμmaxt      ......1   Where, Cx is…

Q: 3. Chemical company recovers crystalline K2CrO4from aqueous solution of the salt using evaporation…

A:

Q: A continuous fractionation column is to be designed to separate 20000 kg / hr of a mixture of 40%…

A: Continuous fractionation column  Given Data : Feed rate (F) = 20000 Kg/hr Composition of benzene in…

Q: (a) State THREE (3) solubility categories of the phase diagram.

A:

Q: What is the molar concentration of 250. mL H3PO4 is needed to reach the equivalence point with 500.0…

A: This question is based on the concept of molarity. Data given: Volume of H3PO4  = 250 mL…

Q: If the farmer applied 120-50-40 kg N-P2O5-K2O in a 1 hectare of rice farm, how much solophos…

A: Given that, Area of the rice farm A = 1 ha N-P2O5-K2O = 120-50-40 Percentage of P2O5 in solophos =…

Q: QUESTION 3 A blend of four monodisperse polystyrene (PS) samples was produced. The molecular weights…

A: 53,000 g/molExplanation:To find the number-average molecular weight (MN) of the blend, we can use…

Q: Calculate the specific gravity of each pseudo-components of the crude assay Attached, knowing that K…

A:

Q: Given the following dissolved oxygen data for an aeration test at 15° C with Cs - 9 mg/L, the KLa…

A: The KLa is given by: KLa=-ln9-1-ln9-710-1 minKLa=-0.1540 min-1

Q: A student is asked to standardize a solution of barium hydroxide. He weighs out 1.09 g potassium…

A: Given that- Mass of potassium hydrogen phthalate (KHP), [KHC8H4O4]=1.09 g Molar mass of KHP=204.22…

Q: 0.200 XX 0.180 0.160 0.140 0.120 O Component A O Component B A Component C 0.100 0 0.O80 0.060 x…

A: Given data: The concentration versus conversion plot of a reaction is given.

Q: Select ALL the correct descriptions ) The graph was created by preparing solutions of known density…

A: Between options 1 and 2, option 2 is correct that is the graph was created by preparing solutions of…

Q: :C 70, H 5, N 1.3, 09, S 2.8, H₂O 4,7, and ash 9 are the final analysis of coal (on a moist basis in…

A: Gross calorific value of given coal sample is to be calculated.

Q: C0nsider the f0l0wing unbalanced chemical reacti0n. F e subscript 2 left parenthesis S O subscript…

A:

Q: At −12.0 ∘C−12.0 ∘C, a common temperature for household freezers, what is the maximum mass of…

A: The molecular mass of Maltitol = 344g Freezing temperature = -12oC m = 2.5kg From the table, The…

Q: Calculate the number of moles in 47.8 grams of C,H60. (C=12g; H=1g; O=16g) a. 1.04 mole C,H,O O b.…

A: Given that weight = 47.8 gram molecular weight ,M.W  = 12 x 2 +1 x 6 + 16 = 46 g

Q: Compute the number-average molecular weight of a polymer with the repeat unit shown for which the…

A:

Q: A sample with initial dry mass of 12.5kg was wetted and dried in a batch drier using hot air. The…

A: Given that  the mass of the dry solid = 12.5 kg the data for the drying time of the weight solid is…

Q: mixing process

A:

Q: 2. A 60 wt% Pb-40wt% Mg alloy is rapidly quench. The final microstructure consists of an a phase…

A: As per the given data, we have to obtain a temperature where a  60wt%Pb to 40%Mg alloy is to be…