Answered: If the Bebye- Waller factor e-2W = 0.95… | bartleby

Related questions

Question

If the Bebye- Waller factor e^-2W= 0.95 at the (200) Bragg peak, what is the average squared thermal displacement <δ²> ? And what is the typical thermal movement amplitude <δ²>^1/2 in Angstrom and in unit of the nearest neighbour distance?

Expert Solution

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Estimate the density of dislocation at the interfaces of GaN/SiC and GaN/sapphire with the unit of number of defects/cm². For example, 1018/cm².
The absorption coefficient of amorphous Si and CIGS are approximately 10^4 cm^-1 and 10^5 cm^-1 at hv = 1.7 eV, respectively. Determine the amorphous Si and CIGS thickness for each solar cell so that 90% of the photons are absorbed.
1 answer. 48. From equations (6-23) and (6-29) obtain the dispersion coefficient for matter waves (in vacuum), then show that probability density (6-35) follows from (6-28). As we learned in Exon ene сог par and
B, n, and p denote magnetic field strength, particle number density, and pressure, respectively. γ is theadiabatic index. The integral is taken over the full length of a flux tube with a small cross section.In ideal MHD convection, these quantities are conserved.A) Pinpoint the detailed assumptions of “ideal MHD convection”;B) With the ideal MHD assumption, prove that V, N, and H are conserved.
(a) Use the appropriate Uncertainty Principle to calculate the linewidth uncertainty in units of Hz, for an optical emission transition that has a lifetime of τ = 10−9 s. (b) Use calculus to show that an emission transition that has a linewidth of ∆f in frequency, has a linewidth in wavelength given by ∆λ = −(λ^2)/c * ∆f (c) What would be the linewidth in nm, of a transition at 600 nm if it had the lifetime given in part (a)?
) The Rayleigh number is defined as gpaAT® Ra
A material has a mass attenuation coefficient of 0.35 cm²/g (for a given photon energy) and has a density of 1 g/cm³. What is the thickness of the Half-Value Layer (HVL) of this material? (Note: the Half-Value Layer is the material thickness required to reduce an incident beam intensity by a factor of two).
W:30