If the atmospheric CO2(g) concentration is 500 ppm, calculate the pH of the river water and the concentration of Ca2+ in mol/L.

Q: 3. Determine the osmotic pressure of seawater assuming that its composition can be reasonably…

A: Equation for Osmotic pressure can be written as:

Q: A droplet of liquid A of radius r₁ is suspended in a stream of gas B shown below. Gas film We…

A: The principle of conservation of mass states that the total mass of an isolated system remains…

Q: When Ca(OH)2 is dissolved in water, it is known that the enthalpy of solution (AHsoln) is -16.2…

A: Given data: Enthalpy of solution = -16.2 kJ/mol Mass of calcium hydroxide = 54 g Volume of water =…

Q: Fresh orange juice contains 10.0 wt% solids and the balance water, and concentrated orange juice…

A: Given: Required to find: The amount of product (37.0% concentrate) produced per 100 kg fresh juice…

Q: Macmillan Learning Ethanol is often used as a fuel additive, but to function in most engines, the…

A:

Q: Question 1 A vapour stream flows into an absorber at a flow of 100 mol/s. The composition of the…

A: Given:The flow rate of the vapor stream Component Mol%Water1diethyl ether4n-butanol2n-butane93The…

Q: 4.9. Inside a distillation column (see Problem 4.8), a downward-flowing liquid and an upward-flowing…

A: Flow rate of vapor mixture entering the condenser = 100 lbmol/h Composition of vapor mixture is,…

Q: A tray distillation column tower is to be designed to distill 450 Ibmol/h of a binary mixture of 60…

A:

Q: 2. One hundred mole per hour of 40 % by mole solution of ethylene dichloride in toluene is fed into…

A: Given that: Basis Feed , F = 100 mol/h Feed composition  (F) is: Ethylene dichloride = 40% Toluene =…

Q: Chlorocyclohexane reacts with sodium cyanide (NaCN) in ethanol to give cyanocyclohexane. The rate of…

A: Reaction A When Sodium Iodide is added to the solution, the Cl- that are attached to cyclohexane…

Q: Aqueous sulfuric acid (H,SO,) reacts with solid sodium hydroxide (NaOH) to produce aqueous sodium…

A:

Q: Separation of Propylene–Propane by Adsorption.Propylene (A) and propane (P) are separated by…

A: The figure given that is applicable for the process described is: Here,   W = Millimoles of…

Q: It is decided to measure the flow rate of a stream of pure air by injecting pure CO₂ at a rate of 10…

A:

Q: Hydrogen is stored at 1 MPa pressure, at 400 °C, in a spherical steel vessel of 0.5 m radius. The…

A:

Q: Degree-of-freedom analysis Question 1 Strawberries contain about 15 wt% solids and 85% water. To…

A: Content of solids in strawberries = 15 wt%Content of water in strawberries = 85 wt%The residue…

Q: Q: Automotive antifreeze consists of ethylene glycol, CH2(OH)CH2(OH), a nonvolatile non…

A: Given: T = 37 0C, Vs = 1200 ml, Kf = 1.86 0C/m Assume that you have 1000 g of solution. Then, you…

Q: Figure 1. Solubility curve for copper (II) sulfate and benzoic acid in water as a function of…

A: Gievn: mass of benzoic acid=5gm Temperature of boiling water=373K The amount of boiling  water…

Q: A gas stream, containing 0.10 mol% carbon monoxide (CO), 2% O2 and 97.9% CO2, flows along a flat…

A:

Q: This example illustrates the use of liquid-liquid phase equilibria in material balance calcu-…

A: Assume outlet phases are in equilibrium. The solubilities of the components at 200C are:EDC in…

Q: Derive the differential equation that describes the desorption in a plug flow basin (Hint: write a…

A: To derive the differential equation that describes the desorption in a plug flow basin

Q: The data given below are for the adsorption of Nitrogen Gas on Silica Gel. The Saturation Vapor…

A: We are given the data for V adsorbed and P  and we are asked to find the parameters c and k for…

Q: stock solution of 12.0 M nitric acid (HNO3) is available to you. You have been told to make a 2.37 M…

A: As it is given in the question that we have M1=12M HNO3. Using V2=20.5L of stock  solution, we have…

Q: Q1: A): Oxygen (A) is diffusing through nondiffusing carbon monoxide(8).The total pressure is 1 10…

A: Given that, Total pressure Pt = 1×105 Nm2 = 105 Pa Temperature T = 298 K Thickness L = 3 mm = 3×10-3…

Q: 4.47. In an absorption tower (or absorber), a gas is contacted with a liquid under conditions such…

A:

Q: One way of purifying gaseous H₂ is to pass it under high pressure through the holes of a metal’s…

A: Palladium is used for absorbing H2 under high pressure. Density of absorbed H2 approaches density of…