If other estimates of the allowable moment for this section are ME=82,195 in-lbs from a linear stress assumption, MEP-90,338 in-lbs from an Elasto-Plastic assumption, & MP-89,753 in-lbs from an iterative plastic analysis, assume Mp from the iterative plastic analysis is most accurate, and determine the percentage difference in estimate versus MP for (a) the linear stress assumption producing Me, & (b) the non-linear assumption of stress producing Mc, & (c) the non-linear assumption of stress producing MEP.

Q: The image shows the yield loci for the Tresca and von Mises yield criteria. Between which two points…

A: GIVEN: TO FIND:

Q: A 10 mm diameter wire cable is being used to lift a crate of parts. If the cable is made from…

A:

Q: With a thick walled cyclinder the inner radius is 0.05m and out radius is 0.2m. The internal…

A: Thick and thin cylinder: The pressure vessels are categorized according to there diameter to…

Q: Suppose an ideally-prepared test specimen in an R.R. Moore rotating beam test has an ultimate…

A:

Q: Consider a 2-meter simply supported beam with a circular cross section. The beam is subjected to a…

A:

Q: you are analyzing the maximum stress of a rectangular cross-section beam supported at both ends with…

A: The maximum stress in a rectangular cross-section beam supported at both ends with a single load in…

Q: Emate =315 mPA G 28GPA Cmad ulus rigidi- -130 mPA nate= 185 mPA Elculate Poisson's Patio fwe have a…

A:

Q: Q5 It was found experimentally that a certain material does not change in volume when subjected to…

A: when a body is subjected to elastic state of stresses, then the strain in the three mutual…

Q: A socket of above knee amputee is used in the following analysis. It may considered as cylinder with…

A:

Q: Find the Von-Mises yield stresses

A:

Q: Q5.A force of 1500 KN is applicd on a stcel bar, young's modulus is 200 G Pa. Length of the bar is…

A:

Q: If a key material has an ultimate strength of 120 ksi and a yield strength of 80 ksi and factor of…

A:

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.