If a student were performing this experiment at an ambient temperature and pressure of 70°F and 1 atm, respectively, what manometer height [mm] would give a velocity of 15.5 m/s? Your Answer: Answer

Q: What does it mean to be an independent slip system?

A: Slip system: It is a combination of slip planes along which the probability of deformation is…

Q: Why is it important to resist the loadings?

A: Loading is defined as an external force or a couple to which a member is subjected during its…

Q: When looking to upgrade your gear, what are the top three factors you should keep in mind?

A: To explain: Three factors that should keep in mind while upgrading the gear.

Q: Which of the following statements about items that are press fit is NOT true? Group of answer…

A: Press-fit is used as a fastener to join two mating parts tightly by providing the thrust to the…

Q: The explantion is not clear

A: given : height of channel h = 10m width of channel w= 34m angle made by channel θ= 15o to find:…

Q: What precautions should be taken if a hammer is used to shift a part into alignment?

A: Welding is a metal joining process in which two or more parts joined together. Misalignment in the…

Q: What material is the piston? None of these answers are correct Steel Cast iron O Aluminum

A: Given:   To select the correct option for the material of the piston.

Q: What type of simple machine is a wheelbarrow? lever inclined plane O wedge screw

A: A machine used to reduce the effort while performing a task is called a simple machine.

Q: Where is a bent material most likely to fail?

A: Let us take an example. Consider any beam applied with external bending  moment . This beam…

Q: Worn teeth on a speed gear can cause?

A: worn teeth creates a big problem in gear drive.

Q: Comparision between pulverized coal firing and stoker firing.

A: Pulverized coal firing and stoker firing are two common methods used for combustion in boilers to…

Q: Draw three views of the adjusting bracket. . Orill-2 Holes 3 BOrill

A: The figure below shows the top and front view of the given model.

Q: The 2XXX, 6XXX, and 7XXX series of raw aluminum alloy's or non-heat treatable and the 1XXX, 3XXX,…

A: Given: The 2XXX, 6XXX, and 7XXX series of raw aluminum alloy's or non-heat treatable and the 1XXX,…

Q: Technician a says that aluminum expands at a different rate than cast iron technician b says that…

A: Technician A is correct.

Q: The primary manufacturing process for the rocker arm is stamping. True False

A:

Q: As the coordination number increases in any of the cubic structures, the APF also increases. :Select…

A: 1. Yes we can say that as the coordination number increases, atomic packing fraction of the cubic…

Q: What is the Axial Load?

A: The axial load is a force that acts along the centroidal or longitudinal axis of the system. If the…

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.