If a power scraper with 1000 hp diesel engine works with its maximum power for 6 min., 50% of max power for 4 min. and 25% of the max power for the rest cycle time ( cycle time is 15 min). Also the equipment takes a rest for 15 min per hour. Then the consumption of the diesel of such scraper is about: *

If a power scraper with 1000 hp diesel engine works with its maximum power for 6 min., 50% of max power for 4 min. and 25% of the max power for the rest cycle time ( cycle time is 15 min). Also the equipment takes a rest for 15 min per hour. Then the consumption of the diesel of such scraper is about: *

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Explain the mechanical efficiency for an ideal diesel cycle of two and four stroke engines
EX: In a combined cycle power plant air inlet condition are (1.01 bar) and (17 °C) ,compressor exit pressure is (10 bar). Gas turbine inlet temperature is (800 °C), the plant produce a total of (50MW) and the exhaust from the gas turbine leaves the steam generator at(150 °C).While the steam leaves the steam generator at (60 bar) and (400 °C) .Find the flow ratio required and the thermal efficiency in each cycle. Take the condenser pressure to be (0.02 bar) and compressor gas turbine and turbine and steam turbine efficiencies (80%,85% and 87 % respectively?
Calculate the thermal efficiency of the heat engine working on the diesel cycle takes in air at 1 bar. 20 °C and a compression ratio 12 and the highest temperature during the cycle was 1100 c
What is the final temperature after compression of a diesel cycle if the initial temperature is 34.98 deg. C and the Clearance is 0.07.
If the compression ratio and the cut-off ratio in a diesel engine are 15 and 3 respectively, what is the expansion ratio?
Compare and contrast diesel power plant with one of the existing power plant in the country in terms of: b. Economy
For same maximum temperature which is more efficient Otto or diesel engine?
The compression ratio of the ideal Otto cycle with air is 8. cycle their highest and lowest temperatures are 1625K and 315K respectively. Specific taking into account the change of temperatures with the temperature, a) The heat given to the cycle, b) Thermal efficiency of the cycle, c) A Carnot cycle operating between the same temperature limits Calculate your efficiency
An engine break horse power output of 10,000kw for an hour using 2,000kg of fuel per hour and having of L.C.V of 42,000kj/kg. Information:Heat converted into useful work per hour =NKwh;where N the power output in KW=3,600nkj.Heat supplied =M x K. Calculate the break thermal efficiency of the engine
An engine operating on the Otto cycle principle has an initial compression temperature of 675°C and a compression ratio of 8. The pressure at this condition is 100 kPa and the cylinder volume is 0.028 m³. The maximum temperature that can be achieved by the system is 4500°C. a.)Calculate the temperature and pressure at each end of the process (point), B. thermal efficiency, C. MEP
Could this engine be built? Hot reservoir TH 600 K 100 J 60 J 40 J Cold reservoir T. = 300 K O a. It's impossible to tell without knowing what kind of cycle it uses O b. Yes О с. No
2. A 10 MW steam turbine generator power plant has a full- load steam rate of 12 kg/kw-hr. Assume no-load steam consumption of as 14% of full-load steam consumption, compute for the hourly steam consumption at 75% load in kg/hr.