Answered: If a differential amplifier having an…

If a differential amplifier having an open loop gain of 80 dB is fed with 2.45mV dc at its non-inverting input and 1.84 mV dc at the inverting input, then the output will be

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A subtractor amplifier can properly subtract signals when The resistors are of any values The input…

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: For an ideal non-inverting amplifier, what will happen to the gain if the feedback resistor is equal…

Q: 5. A differential amplifier has an open-loop voltage gain of 150 when the input signals are 3.55 V…

Q: 8. The inverting amplifier has a gain of -10. Assume that Vin 1.0 V. The approximate value of the…

Q: Problem Find the values of the input and output impedances. Determine the closed-loop voltage gain.…

A: For the given op-amplifier circuit the following parameters are given. Aol=50,000Zin= 4 MΩZout=50 Ω…

Q: Assume ideal op-amps, determine Vol and Vo. Show all work. 16N Vol Vo2 12V 2A

Q: A differential amplifier has a common mode gain of 0.2 and CMMR = 80DB. The differential mode gain…

A: Given the common mode gain is = 0.2 Common Mode Rejection Ratio = 80dB Differential gain = ?

Q: 04 A) Discuss "In inverting and non-inverting amplifiers R2 is normally equal to R1" Then, what is…

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: +15 V 25 mV, LF157A Vout pp 3 kN -15 V 150 2

Q: (c) Design the Circuit-K such that the differential gain of the operational amplifier circuit in…

A: Given: Consider the circuits shown below and note that R3 = R4, va, and vb are the input voltages,…

Q: 31 Calculate the the Output Voltage of a non-inv op-amp with the following parameters Rf = 360kOhms,…

A: In this question we will find input resistance of opamp...

Q: A differential amplifier has an open-loop voltage gain of 150 when the input signals are 3.55 V and…

Q: An inverting amplifier with a gain of 40DB uses an op-amp with ft = 1MHZ (same as in previous…

Q: D/A and A/D Converters Sw: Sw2 Sws SwA 2R 2R 2R 2R R 2R R. R. R. b2 ba Consider the above R-2R…

A: Analog signal is defined over continuous period of time. DAC and ADC are data converters. A DAC…

Q: CRB RB Q4 R V01⁰ +0. io Q₁ Stage 1 Q3 Cm Ic RC Q₂ V02 M R₁ R4 RA -R3 Stage 2 R3 741 + +10v R W 2…

A: ans:(c) 5KHz

Q: How Determine the output voltage of an op-amp for ip voltages of Uij = 150μV and Vi₂ = 140 μV. The…

A: Vi1 = 150 uV, Vi2 = 140 uV, Ad = 4000, CMRR = 100 and 10^5To find Vo1 and Vo2

Q: or a subtractor circuit using one op-amp, when all the resistors are equal which of the following…

A: Note : Both option (a) and (c) are same so right answer is not given. If all of the resistor are…

Q: 9. How do the open-loop voltage gain and the closed-loop voltage gain of an op-amp differ?

A: 9-The open-loop gain of the op-amp is the gain without the feedback path, it is the basic op-amp…

Q: Assuming perfect symmetry 2 + 0, determine the differential voltage gain expression of the amplifier…

A: Given circuit: λ≠0 To find: Differential voltage gain?

Q: 7. Determine the bias current, laus, given that the input currents to an op-amp are 8.3 ju.A and 7.9…

A: Given, Input currents of op-amp are Let, Ib+ = 8.3 uA = current at the non-inverting terminal of…

Q: Q- 5. Assuming ideal op amps, find the voltage gain of ea circuits. 100 100 kn 100 kn 10 k 10 KE 10…

Q: For an opamp, the CMRR is 75 dB. If the differential gain is 4000, then what will be the common mode…

A: If Ad and Ac represent the differential and the common-mode gain for an operational amplifier, then…

Q: An amplifier without feedback has a gain of 1000. What is the gain with a negative feedback of…

A: Given, An amplifier gain without feedback, A = 1000 A Negative feedback with feedback factor,…

Q: a. Define on-off ratio. Why series JFET has higher on-off ratio as compared to shunt JFET? b.…

A: On off ratio is a characteristic of logic transistors

Q: File Edit View For an operational amplifier, the common mode gain is 0.1 and the differential gain…

A: For an operational amplifier, the following information is given: The value of the common-mode gain…

Q: The CMRR of a differential amplifier is 60 dB. If the differential mode gain is 1400, what is the…

A: Given, In a differential amplifier, CMRRdB=60 dB. Differential mode gain, Ad=1400.

Q: D Question 13 (b) What is the voltage gain, Ay of this configuration? 0.55 D Question 14

Q: n op-amp has an open-loop gain of 80,000. Vsat = ±14 V. A differential voltage of 0.5 V p-p is…

A: 1) A circuit that can change the frequency of oscillation with an application of a dc voltage is…

Q: For an operational amplifier, the common mode gain is 0.1 and the differential gain is 1000. What…

A: Given information: For an operational amplifier, the following information is given: The value of…

Q: For an op-amp with negative feedback, the output is O a. equal to the input O b. fed back to the…

Q: One way to measure the slew-rate limitation of an op amp is to apply a sine wave (or square wave) as…

A: Given Frequency of input sine wave is f =1 MHz The peak to peak amplitude of output wave form is…

Q: For the op-amp shown in the following figure, the midrange voltage gain is equal to- к на 3 kf www…

A: Given circuit is,

Q: In inverting amplifier, if the input signal is .9 1000mVpp, output signal is 4Vpp, and feedback…

Q: (a) 3 literals: IZ + xyz + z (b) 3 literals: (ïỹ+ z) + z + xy+wz (c) one literal: wr(z+ gz) + x(w+…

Q: A certain op-amp has the following internal critical frequencies in its open-loop response: 125 Hz,…

A: The criticle frequencies, The signal frequency,

Q: Determine the output voltage of an op-amp for input voltages of Vi1=150μV, Vi2=140μV and CMRRs of…

A: Given, Vi1 = 150 uV Vi2 = 140 uV Ad = 4000

Q: 1.Current cannot flow to ground through ______ A.an ordinary ground B.a virtual ground C.a…

A: Two terminals of the opamp are said to be virtual short if two terminals of opamp is at same…

Q: 5. If you have this relationship between the input and output voltage Vour=1.5 Vn+2 in which 2 is a…

A: Given: The relationship between the input and output voltage: Vout=1.5Vin+2 in which 2 is a bias. To…

Q: For an operational amplifier, the differential gain and the common mode gain is 5555 and 5…

A: An operational amplifier is basically a differential amplifier. This means that the differential…

Q: V_in1 = 10 mv V_in2 = 1 mv GNDI

Q: A certain op-amp has two internal amplifier stages with the following gains and critical…

Q: What will be the CMRR of an opamp if the value of the common mode gain is 100 and the value of the…

A: An op-amp has two type of gains: 1. Differential Gain (Ad)2. Common mode gain (Ac)Since an op-amp…

Q: It has been determined that a certain op-amp has three internal critical frequencies, as follow 1.2…

A: Given dataThe three internal critical frequencies are The midrange open loop gain is .To find…

Concept explainers

Differential amplifier

There are two amplifying stages with common degeneration in a differential amplifier.

Question

If a differential amplifier having an open loop gain of 80 dB is fed with 2.45mV dc at its non-inverting input
and 1.84 mV dc at the inverting input,
then the output will be
V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Sid nov
3ZF The typical value of the out impedance of an op-amp is a.between 100 Ohms to little less than 1 KOhms b.less than 100 Ohms c.at least 10 percent of the input impedance d.equivalent to short circuit
A CC amplifier can be used when a. all of the above b. a current gain without a voltage gain is required c. a voltage gain and a current gain is required d. matching high to low impedances
For the op-amp shown below the values of I, and Vx respectively are: a) OmA, 7sinwt v. b) 7mA, 7v. c) OmA, 0v. d) 5mA, 10v. 7 sinut IK 1₂ 5k I, lok -Vo
File Edit View For an operational amplifier, the common mode gain is 0.1 and the differential gain is 1000. What will be the CMRR of the opamp?
An op-amp is connected to power supplies so that its Vcc value is 15V. It has an open-loop gain of 8 x 106 V/V, and the non-inverting input is 1 µV. If the output voltage is equal to 2V, what is the magnitude of the voltage connected to the inverting terminal?
Choose the correct answer. *Please answer it ASAP if you can*
Assume an op-amp has bias currents of 10.0 LA and 10.2 HA. The input offset current is 20.2 uA 0.2 LA O 10.1 HA O none of the above
An instrumentation amplifier has an input common mode voltage of 6 V, what is the common mode voltage on the output assuming the amplifier gain is 100 and CMRR is equal to -100 dB. a.6mv b.360 mv c.3 mv d.35 mv e.60 mv
Write the characteristic determinants for the equations:
Design a voltage follower amplifier circuit with a voltage divider on it. Assume that you have 60v voltage input voltage with a frequency of 60hz. Instead of using “Universal Op Amp 2" as a component, use the OPO7 Amplifier. What should be the values of your R1 and R2 to get a reading of a voltage output equal to 5.38 volts at exactly 20ms. The arrangement of your input should be, the one that is at the top most is the Voltage Input followed by the R1 and the lowest part is the R2. Draft17 Cursor 1 V(n005) Horz: 20.0054ms Vert: 5.3827036V What is the value of R2 in kilo ohms? No need to include the Units. R2 = k Ohms
Q7)This Multiple choice questions from electronics lab course &just write for me final answer ,It easy for you.