QI)I- If a conductor with a current of 200 mA passing through it converts 40 J of electrical energy into heat in 30 s,what is the potential drop across the conductor?2- The resistance of a copper wire is 0.92 2 at 4°C. At what temperature (°C) will it be 1.06 2?3-Find the range in which a resistor having the following color bands must exist to satisfy the manufacturer'stolerance4-A 172-W resistor has a resistance of 1000 2. What is the maximum current that it can safely handle?5- What is the total cost of using 720wattsfor 30min, 640watts for 2hours and 360 watts for 60 min at 9¢ perkilowatthour?Q2) Find the unknown quantities in the circuit of Fig.land Fig.2R1R3R410 210nP- 30 W100 VR30 NR,R 10n30 ! R.R:2AP.R2 P3Good tuckDr. Ibrahim AljubouriFig.1.Fig.2.

Since there are multiple questions present, according to company policy we will be answering only…

Answered: If a conductor wvith a current of 200…

If a conductor wvith a current of 200 mA passing through it converts 40 J of electrical energy into heat in 30 s, what is the potential drop acróss the conductor?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: ssume F from part 1 and add d(x,w,x,y,z) = ∑(3,7,10) then write the simplified e

A: Given: to simplify (a)the boolean function F(w,x,y,z)= ∑(4,5,11,13,15) (b) the boolean function…

Q: Ten coulombs of charge flow past a given point in a wire in 2 s. What is the current in amperes?

A: Given, Charge q=10 C Time t=2 s

Q: Determine the heat dissipated (in Joule) through a conductor of 10 ohms resistance, when 1 A of…

A: Given a conductor having, Resistance, R = 10 ohms Current, I = 1 A Time, t = 5 seconds =

Q: A 3-phase synchronous generator has no-load line-to-line terminal voltage of 1KV. When the output…

Q: I Changed the material from copper to string to aluminum refer to the pictures below. Can you…

A: Disadvantages of aluminium over copper 1. Aluminium expend more compare to copper.so if we use it…

Q: If the current flowing in a certain conductor is 40 mA. a. find the total charge in coulomb and…

A: Given, Current in conductor I=40 mA Time t=1.8 s Charge on electron qe=1.602×10-19 C

Q: A certain electrical conductor was found to have a conductivity of 105.3 percent at 20 degrees…

A: Conductivity of the conductor is 105.3% at 200Casked to find the followingresistivity of the…

Q: What is the diameter of a 1.00-m length of tungsten wire whose resistance is 0.32 2? (the…

A: Given data, A tungsten wire have L=1.00 mR=0.32 Ωρ=5.6×10-8 Ωm

Q: A 30 A curent passes through a 9 mm? wire. At what rate is heat dissipated (W) ? QUESTION 3 A 100 A…

A: Given data: The value of current is: i = 30 A. The area of cross section is: 9 mm2. The expression…

Q: Electric field of th ground to the hei

A: Given data, Electric field E = 100 V/m. Charge is given q = 0.001 C. Distance is given d = 2 m.

Q: 28. The potential difference between two conductors is 110 V. How much work is done in moving a 5…

Q: A certain electrical conductor was found to have a conductivity of 85.1 percent at 20 degrees…

A: Conductivity of the conductor is 85.1% at 200Casked to find the followingresistivity of the…

Q: Find the work done moving a charge 2 C having potential V = 24 Volts is: 96 J O 24 J 36 J O 48 J

Q: Which of the following statements is true about Proximity Effect? It increases with frequency It is…

A: Describe the Proximity effect ? It is the tendency of current to flow near the surface of the…

Q: What is the clectric field of a material when the current is cqual to 25A, the resistance is…

Q: 180 C of charge flow through a section of wire in 3 min. How much electric current flows through the…

Q: What is the resistance of a No. 14 iron wire, 600 feet long at 248 degrees Fahrenheit.

A: The given information is written below. Length of No.14 iron wire is L=600 feet=182.88 m. We know…

Q: What will be the voltage drop across a 5 mH indjctor if 2.5sin(20t) A current flows through it?

Q: Predict the current, which would be induced in the conductors if a voltage of 40 V could be applied.

A: SOLUTION GIVEN--> Applied Voltage V…

Q: a copper conductor has a resistance of 0.2 ohms at 20°C. if it is found to have a resistance of 0.22…

Q: THE CHARGE ON AN OBJECT - EXAMPLES • A balloon rubbed against someone's hair gains nine electrons.…

A: To find the value of charge

Q: What is the value of current if a 50C charge flows in a conductor over a period of 5 seconds? a) 5A…

A: Given, Charge, q = 50 C Time, t = 5 sec

Q: If 120 C of charge passes through an electric conductor in 60 seconds, then what will be the amount…

A: Given information: The amount of charge is Q=120 C The time duration is t=60 s

Q: If the cross sectional area of the conductor increases, then the resistance of the conductor A5 From…

Q: 8. What will be the current density of metal if a current of 30A is passed through a cross-sectional…

A: It is given that:

Q: An electric charge of 4 C passes through a conductor in 2 seconds. How many amperes is the current…

A: The resistance of a material is directly proportional to the length of the material and inversely…

Q: In Kelvin's law, prove that the most economic current density is that the annual cost of energy…

A: According to kelvin's law Annual cost of transmission is minimum for most economical area of the…

Q: The resistance of a wire with length of 6.7 mile and diameter of 0.5 in and conductivity of 3.20 S/m…

A: Given data, Length = 6.7 mile, Conductivity = 3.20 S/ m , Diameter = 0.5 meters. We know resistivity…

Q: 2. The potential difference between the conductors 110 V. How much work done in moving current of 3…

A: Given data, Potential difference V = 110 V. Current is given I = 3 A. Time t = 0.5 sec.

Q: 31.The potential difference between two points on a wire that are 8 m apart is 7.2mV when the…

A: Given, The length of the wire, L=8 m Potential between two points, V=7.2×10-3 V The current density,…

Q: If a conductor with a current of 200 mA passing through it converts 40J into electrical energy in…

Q: 3. A conductor whose diameter is 0.175 inch has a resistance of 0.5 ohm. The wire is drawn through a…

A: Resistance is the opposition to the flow of current. Its unit is ohm. Formula to calculate…

Q: A wire of resistivity 2.8 x 10^-8 ohm. m and length 20-m must dissipate electrical energy at a rate…

A: An object's resistance is determined by its shape and the material it is made of. The cylindrical…

Q: O) Number of electrons in 1C of charge ? O Charge of 5µC passes from a given section of a conductor…

Q: Determine the heat dissipated (in joule) through a conductor of 10 ohms resistance, when 1 A of…

A: Heat dissipated in a resistor is given by H=I2.R.t where I is the current flowing through the…

Q: A total charge of 50 x 10-3 C passes a point every 2.5 seconds. Calculate the value of the current…

A: Step 1:Given Information:Q = 50 x 10-3 Ct=2.5 secondStep 2:We have to find the current through the…

Concept explainers

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.

Question

QI)I- If a conductor with a current of 200 mA passing through it converts 40 J of electrical energy into heat in 30 s,
what is the potential drop across the conductor?
2- The resistance of a copper wire is 0.92 2 at 4°C. At what temperature (°C) will it be 1.06 2?
3-Find the range in which a resistor having the following color bands must exist to satisfy the manufacturer's
tolerance
4-A 172-W resistor has a resistance of 1000 2. What is the maximum current that it can safely handle?
5- What is the total cost of using 720wattsfor 30min, 640watts for 2hours and 360 watts for 60 min at 9¢ per
kilowatthour?
Q2) Find the unknown quantities in the circuit of Fig.land Fig.2
R1
R3
R4
10 2
10n
P- 30 W
100 V
R30 N
R,
R 10n
30 ! R.
R:
2A
P.
R2 P3
Good tuck
Dr. Ibrahim Aljubouri
Fig.1.
Fig.2.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Semiconductor Material and Its Energy Band Analysis

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Two infinitely long parallel wires are at a distance of 5 cm apart. If the wires carry a current of 1.9A, what is the exchanged force per meter between the wires?
What is the force on an electron in an electric field of 5000 N/C?
What is the electric field of a material when the current is equal to 25A, the resistance is measured to be 782, the current density equals 24A/m2, and the length the current flows is 100m? Lesturen Dr bageE alnash
Some materials conduct electricity better than others. Can you figure out wwhich is the best of the three to choose? (Aliminum, Copper, or String)
Two long parallel conductors carry 200 A. If the conductors are separated by 40 mm, the force per meter of length of each conductor will be
Resistivity is a property of a material that relates to how well or how poorly the material conducts electricity. Given the following materials' resistivities, which one would be the best conductor? Nichrome: p= 1.00 x 106 Ohm-meters silver: p = 1.59 x 10-8 Ohm-meters aluminum: p= 2.82 x 10 8 Ohm-meters iron: p = 10 x 10-8 Ohm-meters O Iron O Silver O Nichrome O Aluminum
The magnetization within a bare of some metal alloy is 9.2x10 A/m at an H fiels of 104A/m. What is this alloys's susceptibility.
ovni sbo 5. Under what conditions did the power supply register current?