Identify the statement from the following when the inductance can have high value. O a. All the given options O b. If the length of the wire is shorter O c. If the number of turns of the wire is less O d. If the cross-sectional area is lesser

Identify the statement from the following when the inductance can have high value. O a. All the given options O b. If the length of the wire is shorter O c. If the number of turns of the wire is less O d. If the cross-sectional area is lesser

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 2RQ: Semiconductors are ____________. conductors insulators half conductors none of the above

See similar textbooks

Related questions

Q: requires 10 watt-sec to charge a capacitor with 0.09 coulomb, determine the size of the unit in…

A: In this question we will find size of capacitor...

Q: A car battery has gone dead and it needs to be replaced with a large capacitor. The old car battery…

A: To solve above problem, one should know capacitors and capacitance offered by a capacitor. A…

Q: Which of the following elements of electrical engineering cannot be analyzed using Ohm's law?

A: The correct option along with the explanation is provided in the following section.

Q: n-type semiconductor acquires a negative charge on the material, the majority has electrons as a…

A: In semiconductor there are 2 types of semiconductors no.1 is p type semiconductor and no 2 is n type…

Q: A coil consists of 2000 turns of copper wire having a cross-sectional area of 0.8mm². the mean…

A: Given data, Number of turns N=2000 turns Area, A=8 mm2=0.8×10-6 m2 Length, L=0.8×2000=1600 m…

Q: How is the resistance of a component calculated if, for example, the resistivity or cross-sectional…

Q: Physical properties that affect inductance are: 15) ________ A) area of the coil, permeability, and…

A: Physical properties upon which inductance depends are describing as follows, Inductance relies on…

Q: a series circuit contains a resistor and an inductor as shown in figure 1.3.14. determine a…

Q: 2- If the string is supplied by a guard ring and this lead to add one air capacitance of 0.12C. find…

Q: Consider a 3-phase, 50 HZ, 11 KV distribution system. Each of conductors is suspended by an…

A: The operating line voltage is given as 11kV then the phase voltage:

Q: Calculate the conductivity of intrinsic Si at 27oC and write your answer in 1/(Ω.m).

Q: Determine the value of reactance that need

A: Types of open circuit fault- 1) Symmetrical fault- Three phase line to ground fault Three phase…

Q: Determine the inductance if the energy stored in the coil is 10 Joules, having a charge of 4 Coulomb…

Q: What is the property of an Inductor? a. Oppose the sudden change in voltage b. Oppose the flow of…

A: Inductor: It is a passive, two terminal electrical device. Also called as coil. It is used to store…

Q: A coil consists of 5000 turns of copper wire having a circular - section of diameter 0.0045 m. The…

Q: Each of three insulators forming a string has self-capacitance of "C" farad. each cap of insulator…

Q: What is the Property of an Inductor? a. Oppose the sudden change in voltage b. Oppose the flow of…

A: Voltage across inductor is given by, VL = L * di/dt Where, i = current flows through inductor For…

Q: Solve for the value of the capacitance (in nF unit) if R2 = 1057 ohms and Xc = 2365 ohms. Round your…

Q: 1. Explain the difference of pure resistive, pure capacitive and pure inductive circuit.

Q: determine the voltage Va.

Q: Given the inductance of 2.5 µH with a reactance of 400 Ω. What will be the value of the frequency?

Q: If a coil of wire has a resistance of 20ohms at 40oC and 20 at 80oC,what will be the resistance of…

A: Given, R40=20 ΩR80=100 Ω

Q: In a welding process, a current of 400 A flows through the arc when the voltage is 35 V. The length…

Q: Discuss briefly the importance of renewable energy

Q: What effect would the multimeter's internal resistance (in the voltage setting) have on the…

A: The multimeter work to determine the capacitance by charging the known current. that measures the…

Q: insulating material that separates the electrodes of a capacitor. Select one: a. dielectric b. air…

A: We need to select correct option for capacitor .

Q: Consider the large inductor in Figure 3 with given number of turns N, core permeability μ, core…

Q: What is the reactance (in Ohms) of a 0.15H inductor at 198rad/sec? (Give answer in 2 decimal places.

A: Here we are given, L= 0.15 H. ω= 198 rad/sec. The reactance(opposition) offered by inductor to flow…

Q: What is the period in milliseconds for a given voltage having an equation of v(t) = 100sin377t?

A: The general expression for Sinusoidal signal is v(t)=Asin(wt+ϕ) A= Amplitude of Sinusoidal signal…

Q: Enumerate 10 important Electrical Materials and briefly describe each.

A: The answer as given below:

Q: Reflect and elaborate comprehensively the concept, application and importance of these topic.…

A: Current: It is the time rate of charge, or flow of electrons in a conductor. It is measured in…

Q: (A) The capacitances of a 3-phase belted cable are 12-6 µF between the three cores bunched together…

A: Consider the given below diagram of the cable,

Q: A mild street ring having across sectional area of 600 sq mm and a mean circumference of 500 mm has…

A: Introduction: Magnetic flux density: It is denoted by 'B'. Magnetic flux density is defined as flux…

Q: A string of suspension insulators consists of three units. The capacitance between each link pin and…

A: As we have given V3=35 kVk=16=0.16

Q: An insulator has 3 units. The capacitance between each insulator pin and earth is 15% of self…

Q: Compare alternative and direct currents by comparing their physical properties. (Explain alternans,…

A: The AC changes its direction periodically whereas DC is unidirectional. The AC is easy to transmit.…

Q: 1) According to the figure given below: a) Determining the de resistance at 2 mA. b) Determining the…

Q: A single phase half-wave rectifier is connected to a 300V RMS 50Hz AC supply. If the rectifier is…

Q: In a 36KV overhead line, there are 3 units in the string of insulators. If the capacitance between…

A: Here, Value of K = 55% = 0.55 Line voltage = 33 kV

Q: QI/ DC chopper with inductive of 10mH, supplies a load of 220 V from 120 V de supply. If conducting…

A: Disclaimer: Since you have asked multipart questions, we will solve the first three subpart for…

Q: The figure below shows three possible arrangements of a pair of electrons (the red dots). Consider…

A: given pair of electron.

Q: In a 33kV overhead line, there are three units in a string of insulators. If the capacitance between…

Q: 6. A string of four suspension insulators is connec unit is equal to 5 times pin to earth…

Q: - If the type of dielectric material between the plates of a capacitor is changed, which of the…

Q: In an overhead line, there are three units in the string of insulators having line voltage of 33kV.…

A: Given V= 33 kV K=0.11 ratio of shunt capacitance to self capacitance

Q: (b) Determine the inductance value, L when the number of coil's turns, Na is 120. Given that the…

Q: 1) According to the figure given below: a) Determining the dc resistance at 2 mA. b) Determining the…

Question

Identify the statement from the following when the inductance can have high value.
O a. All the given options
O b. If the length of the wire is shorter
O c. If the number of turns of the wire is less
O d. If the cross-sectional area is lesser

Identify the statement from the following why silver allows electric current.
O a. It is an insulator
O b. None of the given options
O c. It is a non-metal
O d. It is not an insulator

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Semiconductors are ____________. conductors insulators half conductors none of the above
What is a negative ion?
For solar cell the Open Circuit Voltage (Voc) occurs when O a. voltage is minimium f O b. voltage is zero ion O C. current is maximium O d. current is zero page
Identify the statement from the following why silver allows electric current. a. It has low resistance O b. All the given options O c. It is a conductor O d. It is not an insulator
Current can not flow through an insulator because they have O a. free electrons O b. no free protons O c. no free electrons O d. free neutrons
22/ Which of the following has higher energy? a. valance band electrons b. impurity atoms c. forbidden band electrons d. conduction band electrons
I need a reference about Elemental Semiconductor
Copper is a Select one: O a. Semiconductor O b. Conductor Super Conductor O d. Insulator
Q1. Determine the class of material based on relative comparison for each energy diagram. Energy Energy Energy Conduction band Energy gap Conduction band Energy gap Conduction band Overlap Valence bund Valence band Valence band (b) (c)
* A material that does not normally conduct current is called semiconductor O conductor O insulator O copper O
In an n-type semiconductor material, the net flow of charge will be the flow of Blank 1. Blank 1 Add your answer In semiconductors, if more impurities are added, their doping level is termed as Blank 1 doped semiconductors. Blank 1 Add your answer A device that converts one form of energy to another is called a/an Blank 1. Blank 1 Add your answer
In * semiconductor, the concentration of the holes and electrons is equal.