Identify the following apparatus for this test: 28 97AH Write your answer according to tagging of letters. eg. A. Beaker, B. Balance Use the editor to format your answer

Q: 500 Hz. The ceiling is acoustic ceiling tile (ACT), Symbol for pi = .95 at 500 Hz Using the same…

A: Room dimensions: Length  = 4 mWidth  = 7 mHeight = 3 mFloor absorption coefficient= 0.15 Wall…

Q: 9) In the section . due to . . tensile reinforcements suffer.. A) Perforated steel, high volume of…

A: In low steel section it suffers high level of stressed. And also low in the Compression.

Q: 6) Three behaviors what is the cross section of reinforced concrete in order and by drawing the…

A: A typical graph of force-displacement curve for reinforced concrete is shown below: In the above…

Q: 8) In the plastic area, the use of regulations based on .. is not allowed due to.. .... ... A) ASD,…

A: Here are also warning are given initially, however I do my best as like my previous answer.    Let's…

Q: A T-shaped built up steel beam is composed of 150 mm x 10 mm flange plate at top and a vertical web…

A:

Q: Part 2: By Super Position Consider the simple supported beam shown in the Fig. a. Determine the…

A:

Q: Classify the following soils by the AASHTO classification system. Give the group index for each…

A:

Q: QUESTION 5 An S18x70 steel section is available with nominal depth of 9 inches O True False QUESTION…

A: 5. From the Standard Steel Beam Sizes, Dimensions, and Section Properties Chart, An S18×70 steel…

Q: C-time elapsed until the blocks touch.0

A:

Q: 3) What does the area under the strain stress curve represent and what is the advantage of…

A: Steel is a ductile material which can have many deformations before failure. The concrete is a…

Q: 5) What is the role of the cover on the rebars in reinforced concrete sections? A) Cross-sectional…

A: Covers are use to prevent from the environmental exposure of the bars.

Q: PROBLEM 3: Determine centroid of the composite figure. Refer your final answer to x and y axis. 5"…

A:

Q: 1) In a reinforced concrete project, 25 cubic meters of concrete has been used for concreting the…

A: According to ACI 318 section 5.6, test samples should be minimum of: 1. Once per day 2. Once per 115…

Q: The state of strain at the point has components of € = 300 (10-). y = -260 (10-6), and Yzy = 460…

A:

Q: 2) What is the characteristic of concrete in the stress-strain curve of concrete? What is the…

A: The characteristic property of concrete obtained from the stress-strain curve is the Modulus of…

Q: 10) In case of architectural restrictions, the designer must: A) Place the rebars periodically B)…

A: Warning  is being given before answering,  However I do my best.  I try to give good explanation…

Q: indicate the final answer in 3 decimal places.

A:

Q: 4.1 Results from liquid and plastic limit tests conducted on a soil are given below. Liquid limit…

A:

Q: The hydraulic gradient for quicksand condition is equal to 1.24 with a void ratio of 0.55. The moist…

A: Given: critical hydraulic gradient  Void ratio  Moist unit weight  To find:  Dry unit weight

Q: Solve for the reactions at C which is an internal pin.

A: The given figure shows the structure carrying point load  of 240N. At D roller support is provided…

Q: Which method designs a bylaw based on a coefficient?

A: Coefficient are use to minimize or maximize the value to include adequate safety in the design.

Q: A vertical retaining wall 5.9 meters high retains a horizontal backfill having the following…

A:

Q: 7) In order for a section to have elastoplastic behavior, it must: A) Tolerable anchor is greater…

A: Brief concept- Elastoplastic behavior- Elastoplastic behaviour is the combination of the elastic and…

Q: If the roller at A and the pin at B can support a load up to 4kN and 8kN respectively, determine the…

A: Given : Determine the max. intensity of distributed load that can be supported without failure of…

Q: A concrete dam is triangular in cross section and 30 m high from the horizontal base. If water…

A:

Q: A reinforced concrete beam section is "b" wide and "h" deep. It is to be reinforced with 10 mmø…

A: I had answered only first two steps. Because given time limit I can solve only two steps.

Q: 5.1 Classify the following soil using the U.S. Department of Agriculture textural classi- fication…

A: This question is from geotechnical engineering and here some soil samples are given and their…

Q: Draw the flow curve and obtain the liquid limit. What is the plasticity index of the soil?

A:

Q: 4.5 A saturated soil used to determine the shrinkage limit has initial volume V₁ = 20.2 cm³, final…

A: The shrinkage ratio can be defined as the ratio of given volume change to the corresponding change…

Q: indicate the final answer in 3 decimal places.

A:

Q: 10. In a construction project, the field moist unit weight was 18.08 kN/m3 at a moisture content of…

A:

Q: 5.4 Classify the following soils by using the Unified soil classification system. Give the group…

A: Solution: All calculations are done on the basis of the Unified soil classification chart mentioned…

Q: Problem No. 1 A copper rod of length L =18.0 in. is to be twisted by torques T (see figure) until…

A:

Q: indicate the final answer in 3 decimal places.

A:

Q: Problem 3: Support A is pin connected while support B is roller. reactions at A and B if the slope…

A:

Q: indicate the final answer in 3 decimal places.

A: