Iculate the radius of capillary tube if water rise to a height 4.5 cm. Surface tension of water is 72 dyne/cm. (angle of contact for water = 0°, g = 980 cm/s 2) %3D
Q: Calculate the fluid force on one side of a semicircular plate of radius 3 ft that rests vertically…
A:
Q: Calculate the radius of capillary tube if water rise to a height 4.5 cm. Surface tension of water is…
A: To find-Radius of capillary tube (r)=?Given data-Height of water column (h)=4.5 cmSurface tension…
Q: The water nozzle ejects water at a speed vo= 45.8 ft/sec at the angle 0 = 31°. Determine the…
A:
Q: fluid f 式 an aver pipe dicmet that the p
A:
Q: n side BC
A: Given: To find the total force acting on the sides BC and ABCDE as,
Q: 1-69 Freshwater and seawater flowing in parallel horizontal pipelines are connected to each other by…
A: The density of sea water is given as, ρsea=1035 kg/m3, The density of mercury is given as,…
Q: 5. A capillary tube of 1.2 mm diameter is immersed vertically in water exposed to the atmosphere.…
A:
Q: d = 6mm d = 15mm The left common carotid artery (shown) has an axisymmetric constriction because of…
A:
Q: A paperweight, when weighed in air, has a weight of W = 5.19 N. When completely immersed in water,…
A: Given Weight of the paperweight in air is W=5.19 N Weight of the paperweight completely immersed in…
Q: The radius of a capillary tube is 0.05cm. It stands vertically in a liquid of surface tension 25…
A:
Q: Derive an expression for capillary rise (or depression) between two vertical parallel plates. Then,…
A:
Q: A crown has a mass of O,59Z kg and when it is Sübmerged tn wwater (lo0 kg Per cubic meter)it…
A: The buoyant force, B=0.671 N The mass of the crown, m=0.592 kg
Q: Acylindrical tank withalarge diameter is filled with water to a depth D= 0.401 m. A hole of…
A:
Q: Q1/Find the force required on the orifice 40 cm dia. 10 cm K=5 m/s Water
A: SOlution: Given that V1 = 5 m/s d1 = 40 cm = 0.4 m d2 = 10 cm = 0.1 m
Q: What is the gauge pressure (in kPa) when there is a height difference of 17.0 cm in the two arms of…
A: Given, Height difference in the two arms of the manometer (h) = 17cm density of olive oil (ρ) = 917…
Q: Calculate Using the coordinate the density the fluid force on one side of the plate below. Assume…
A: The pressure exerted by a fluid at equilibrium at any point of time due to the force of gravity”.…
Q: e inside diameters of the larger portions of the horizontal pipe depicted in the figure below are…
A: Diameter of the larger portion is The rate at which liquid flows is The height of the larger portion…
Q: Find the fluid force on the vertical side of the tank, where the dimensions are given in feet.…
A: We are given a tank full of water. We have to find the force on vertical or say curved part of the…
Q: s Water is flowitag theouge a a pipe ot radius 2s on at speed of so %s. the pipe then constriats to…
A: Please note : As per answering guidelines I can answer the first question only. Since, this is not a…
Q: When the initial height of the pipe is 10 m and final height to 3 m, what is the final pressure of…
A: Using Bernoulli’s principle, P1+ρgh1=P2+ρgh2 Here, P1 is the initial pressure. P2 is the final…
Q: 6- The rectangular gat has dimensions 6 m by 2 m. Neglect the weight of the gate. Determine (a) The…
A:
Q: The t'ank shown is filled with water. Af wheet depth does the resultant ferce act? The Surface under…
A:
Q: Q4) Derive a formula for capillary rise (h) between two concentric glass tubes of radiuses R1 and…
A: Given data: The surface tension is σw=0.072 N/m. The inner radius is R1=30 mm. The outer radius is…
Q: A certain man has a mass of 84.0 kg and a density of 994 kg/m3 (excluding the air in his lungs). (a)…
A:
Q: 90 The sewage outlet of a house constructed on a slope is 6.59 m be- low street level. If the sewer…
A: Given data: The sewage outlet is h1=6.59 m. The depth of sewer is h2=2.16 m. Density of waste is…
Q: An impeller (axial-flow turbine propeller) in an agitated tank has an output torque (T) whose…
A:
Q: Problem 1: Equation of Continuity, Bernoulli's Equation, and Rates (a) In the figure above, show…
A:
Q: Determine the pressure at the point 3?
A: Given that: P1=Patm=1.013×105 Pav1=6.9 m/sh=0.89 ft=0.89×0.3048=0.27 m
Q: Calculate the mass of a solid gold rectangular bar that has dimensions Iwh = 5.90 cm x 15.0 cm x…
A: Given data: Dimensions of gold bar lwh = 5.9cm × 15cm × 27cm Density of gold (ρ) = 19.3×103 kg/m3…
Q: What is the largest average velocity of blood flow in an artery of radius 2*10 raise to power -3 m…
A: Radius of artery = 2×10-3 m.Type of flow = Laminar.
Q: a honizontal flowing thraugh Water is 8 Sts diamt to the tube ace au 0.3m & 0lm Resp. is equeal to…
A:
Q: A capillary tube of bore 0.84 mm in dipped into a liquid of density 840 kgm and surface tension…
A: The rise of liquid in a capillary tube can be calculated using the formula: h = (2Tcosθ)/(ρgr)…
Q: z> Find the difCerence (P.-P) for the below in pressure pipe System : IS em
A:
Q: When one end of the capillary is dipped in water, the height of water column is 'h'. The upward…
A: We need to compute-Inner circumference of capillary=?The data given is-Upward force(F)=105…
Q: A rock weighs 17 5 N in air. When the rock is suspended ov a lignt cord and totallv immersed in…
A: Dear student I'm assuming weight of rock as 17.5 N. I think you have forgotten to put a decimal…
Step by step
Solved in 2 steps with 1 images
