I want to find the mesh currents in this circuit. I calculated i1=2.2A, i2=0.5A but Falstad is saying the answer is i1=2.7A, i2=1A. I've asked this same question before so could I please get a new response to it

Q: Write the nodal equations for the circuit of figure and solve for the nodal voltage b. R2 = 5 0 2 =…

A:

Q: Convert Wye-Delta If R1 = 3, R2 = 15, and R3 = 19, find Rb. Two decimal places. R. b a R2 R1 n Ra Rp…

A:

Q: Determine the loop currents values for the circuit. where R1= 170 (ohms), R2= 340 (ohms), R3= 85…

A: To find the loop currents I1 and I2 .

Q: V1 is solved using voltage nodes: V1-10 Vi-1.4 Vj-0.7 + + 400 100 200 300 ||

A: We need to find out V1 from given equation

Q: 100V 200 AS 20mH wwall b. 600 300 1. ww

A: Transient analysis

Q: In the figure e = 6.97 V, 82 = 13.8 V, R = 94.9 Q, R2 = 201 Q, and R3 = 327 0. One point of the…

A: This question belongs to circuit theory . It is based on the nodal analysis in circuit . Nodal…

Q: Write down the KVL equation of the First loop for the circuit shown in Figure. 152 100V 20Ω 102 I2…

A: Entering into the resistor terminal is taken as positive and leaving the resistance terminal is…

Q: Don't use ai to answer I will report your answer Solve it Asap with explanation

A: Thank You

Q: DETERMINE THE SUPERPOSITION CURRENTS AND TOTAL CURRENT THROUGH R2. DETERMINE THE SUPERPOSITION…

A:

Q: Solve by Method of Branch Current by using figure 1. R1=5 R3=15 R5=25 R6=30 Loop1 cw R2=103 Loop 2…

A: The given figure is

Q: 3. D2 has a Vz of approximately 10 volts. Type in the calculated voltage for TP7 with -5 volts…

A: We need to find out the voltage at given point in the given circuit.

Q: Write the equation for node D. Assume all currents through resistors are going out of node D.

A: Let the node voltage is VA , VB ,Vc ,VD and VE  as shown in below circuit.

Q: R/ For The Circuit shown in figure if ( B= 50) find The value of ( Ic) and of Then express The…

A:

Q: Please derive KVL equation based on below circuit. Please give full complete calculation

A:

Q: Problems Work 3 of the following 4 problems: 1) In th figure to the right apply the Kirchhoff's…

A:

Q: 4. Use the labeled in the figure. current-division principle to find the currents i₁ = 3 A R₁ = 10…

A: The given circuit is,

Q: 11 R5 (A1) 5600 11 R2 R3 2200 3300 R4 4700 V1 R1 1000 12 13 -25V A2) A3 12 13

A:

Q: In the figure below the current in resistor 6 is i6 = 1.40 A and the resistors are R1 R2 = R3 = 2.00…

A:

Q: Using Loop Analysis, determine V₁. Please give your answer in V. lB = 6mA VA = 9V R₁ = 9.7kQ R₂ =…

A: Using loop analysis Calculation of voltage V1. Here I mentioned all the given value in the circuit.…

Q: the circuit shown in figure (1), solve the circuit using chhoff's laws to determine currents and…

A:

Q: Find the current i2 for the following circuit: iT 120x10-³sin(wt +60°) = ₁80x10-³sinwt i₂ = ?

A: Here the value of current given in terms of Variable x It has some ambiguity but the fundamentals…

Q: For the mutual electric circuit shown in figure beside, find the set values of mesh currents 11 &…

A: a mesh is a loop that does not enclose other loops. KVL, states that “in any closed-loop network,…

Q: there is also e1-v2-e2=0 thus e1-e2=v2 he typed accoridng to kvl but i didnt understand it. i know…

A:

Q: 3. Below is a circuit with four branches. The currents I₁ and I2, and the emf &₁ are unknown. The…

A: The circuit diagram,

Q: Consider the circuit shown. VDD M₁ M₂ V₁ V₂ VDD = 2.5V and I = 0.25mA. VT=0.5V and k' = 0.1mA/V².…

A:

Q: detemine the currents I,I2 E, =18V Junction RuleI,4I,= Ig. Oloop rule: 18+0.5I2t 6エ,12.5エ2…

A: KIRCHHOFF’S LAW KCL: The algebraic sum of all currents at a node is zero. KCL is applicable for…

Q: Example(6): Determine the values of currents In ,2 &I3. RI R2 I1 V1 =10V+ V2-20V R3 0n 13

A: We need to find current for given circuit

Q: For the AC equivalent circuit f,-120, B2-80. Icas = lcaz2 =1 mA.... Find AV1= V 1 kO 4 kQ Select one…

A:

Q: Q2- Find the short circuit admittance parameters Y1 and Y1 for the circuit shown In the figure. 3h…

A:

Q: For the circuit shown IC2 1mA,VCE1 = 3V, and VCE2 = 6V 1. The value of RC is equal to • ohm 2. The…

A: Here we will use bjt current relationship and ohm's law to find out unknown parameter.

Q: R, =212 R2=752 E,= 25VE R =602 Q E2 = 50V %D %3D

A: According to the question we have to find the value of the current flowing through each branch.

Q: Kirchhoff's voltage law states that the voltages (rises and drops) around a loop combine in this…

A:

Q: For R1-8, R2=17, 11=24 A & K1=4 in the shown circuit, Find the Norton equivalents at terminals a-b…

A:

Q: Use the mesh-current method to find the branch currents ia, ib, and ic in the circuit shown in…

A: In the given questions we need to calculate the current ia by mesh analysis.

Q: circuit in which R= 10 ohms and L= 0.1 Henry. This is energized by a 24 volt DC source. If the…

A:

Q: For the mutual electric circuit shown in figure beside, find the set values of mesh currents 1 & 12?…

A:

Q: R =50 V2 IA R1 30 6A I5 2 A R 40

A: The given circuit is:

Q: Give your observation and conclusion with this circuit given.

A:

Q: Find the currents and Voltage of the circuit( V1,V2,V3,V4) ( I1, I2,I3)

A: In this question we need to find the currents and Voltage of the circuit( V1,V2,V3,V4) ( I1, I2,I3)

Q: For the circuit shown IC2 = 1mA ,VCEI = 3V, and VCE2 = 6V 1. The value of RC is equal to • ohm 2.…

A: From the given information of the current and potential difference of the voltage we calculated the…

Q: 24. Write the Kirchoff's Rule equation for R.R₂ R₁+R, the currents at junction A the voltages in the…

A:

Q: For the mutual electric circuit shown in figure beside if Vs-10cos 10t Volts, write the set of mesh…

A: Given circuit is shown below. Given that Vs=10cos10t ω=10 rad/secZL=jωLZC=1jωC

Q: Q14. Obtain the equivalent resistance at the terminals a-b for the circuit in Figure Q14. ac 3100…

A: In this question we will find equivalent resistance across point ab...