I Review | Constants re 1) shows two rectangular tanks, A and B, full of r. They have equal depths and equal thicknesses (the nsion into the page) but different widths. Compare the forces the water exerts on the sides indicated in the figure. Is F, larger than, smaller than, or equal to Fв? Explain. Match the words in the left column to the appropriate blanks in the sentences on the right. < 1 of 1 > is greater in tank A because the mass of water is greater in this tank The pressure at any given depth The area of the sides indicated in the same for each tank, so is the same in both tanks because the water depth is the same A Sides FA = FB

Q: At which location will the pressure in the fluid be the greatest? Ignore viscosity. (You can assume…

A: Given the a circular pipe of varying radius.from left to right filling the pipe completely.At which…

Q: An object with a density of 1.2 kg/liters and a mass of 23.2 kg is fully submerged in seawater…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Could you solve this please

A:

Q: A river narrows at the rapids from a width of 12 m to a width of only 6 m. The depth of the river…

A: Width before rapid (W) = 12 m Width after rapid (w) = 6 m Depth before rapid (D) = 3 m Depth after…

Q: Blaise Pascal duplicated Torricell's barometer using a red Bordeaux wine, of density 984 kg/m³, as…

A:

Q: 4. If a wooden cylinder has a density of 995 kg/m3 and floats upright, what fraction of it will be…

A: The density of the wooden cylinder is ρcylinder = 995 kg/m3 The density of fresh water is ρfwater =…

Q: A hollow spherical iron shell floats almost completely submerged in water. The outer diameter is…

A: Given values: outer diameter do = 62.4 cm Iron's density ρI=7.87 g/cm3

Q: contains water to a di orce of 16 kN parallel acceleration of the tan C. 43.6 m/s? d. 1.71 m/s?

A: Weight of tankwt =3.6KN Weight of water Ww =Vw ×spesifiveGr Weight of waterWw =(3×3×1)×1Weight of…

Q: Once again, using our bicycle pump (same diameter) from question #9 and Figure 15-10, imagine that…

A:

Q: A plastic tube, shown on below, has a cross sectional area of 8.9 cm². The tube is filled with water…

A: Pressure at the depth of h  is  P=ρgh Where P is pressure, h is depth at which pressure is to be…

Q: At 20 °C, the surface tension of water is 0.073 N/m. A soap film is holding up the entire weight of…

A: Wire length = 2.2 cm = 0.022 m Wire Diameter = 0.1 cm = 0.001 m Wire radius = 0.001 / 2 Surface…

Q: Calculate Using the coordinate the density the fluid force on one side of the plate below. Assume…

A: The pressure exerted by a fluid at equilibrium at any point of time due to the force of gravity”.…

Q: Consider the sealed containers (same fluid and on the same ground level) below with heights given in…

A: Pressure in a container only depends on the density of the fluid and height to which the container…

Q: 5. The radius of the blood vessel is 0.9 cm with a viscosity and density of 0.004 kg/(m-sec) and…

A:

Q: A tube with variable diameter has one extremity at the ground level with diameter d₁=15 cm and the…

A:

Q: a) Calculate the volume of 55000 g woman, who has a density of 960 kg/m3that excluding the air in…

A: 1) Volume can be calculated as V=mρ=55000×10-3 kg960 kgm3=0.05729 m3 2) Buoyant force air exerts on…

Q: parameters wel all Ull ile VISCUSILY Ulule yulus allu gases! Q1:C) Define the surface tension? Drive…

A: Given : To define Surface Tension. To derive an expression for Surface Tension for rectangular pipe…

Q: Q4) Derive a formula for capillary rise (h) between two concentric glass tubes of radiuses R1 and…

A: Given data: The surface tension is σw=0.072 N/m. The inner radius is R1=30 mm. The outer radius is…

Q: 4. An object has a weight of 8.10 N when in air. However, it submerged in water. What is the density…

A:

Q: A trench in the Pacific Ocean is 46m deep. Assuming that sea water has an average density of…

A:

Q: QI. Solve the following: (Compulsory question) a) Pressure on the quay Weight of the container.…

A: Draw the free-body diagram of the system as:

Q: I Review | Constants A piece of wood is 0.550 m long, 0.240 m wide, and 0.078 m thick. Its density…

A:

Q: 2. Refer to figure 2. Blood flows through a 2.50 cm long artery with a 10.0 mm diameter at 12.0…

A: Given

Q: PROBLEM 1. Compute the capillary effect of immersion in mercury of a glass tube of ómm internal…

A: H = 2Tcos(theta)/DgR T is surface tension Theta is contact angle  D is density of mercury g is…

Q: A large storage tank with an open top is filled to a height h0. The tank is punctured at a height…

A: (a) Find expression for the velocity of the exit sream:Applying Bernoulli's…

Q: V₁ V₂ The two blocks (block 1 with volume V₁ = 6 m³ and block 2 with volume V₂ = 2 m³) shown in the…

A: The free body diagram of the given situation is as shown above.Given volume of block-1 is V1=6 m3…

Q: A triangular water trough is "a" metres wide and "a" metres deep, as shown in Figure 3. If the…

A: Given: The density of water is 1000 kg/m3. To determine: The magnitude and location of resultant…

Q: How to answer this? Thanks so much.|For 5. In Hg is a unit of pressure (specifically, pressure head…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: A rectangular object weighs 300 N. It displaces a volume of water that weighs 200 N. a. Draw the…

A: Given, Weight of an object, W = 300  N weight of the water displaced, Wd = 200 N density of the…

Q: A 50-cm-thick layer of oil floats on a 140-cm-thick layer of water. You may want to review (Pages…

A:

Q: The net force needed to hold up a block of aluminum immersed in fresh water is 10 N. What is its…

A:

Q: Convert the following a) 1000 R° to FO b). 70 bar to mm Hg

A: As per our guidelines, we are supposed to answer only first one question in case of multiple…

Q: à large tankK upright ground cated in the diagram given below. (The diagram is not to scale.) H1 H2…

A:

Q: A rectangular boat made out of steel with a mass of 2000 kg floats on a freshwater lake (water…

A:

Q: xi+yj + zk, A fluid has density 1000 kg/m³ and flows with velocity where x, y, and z are measured in…

A: Given that :Fluid density: ,Velocity vector: , Paraboloid equation:

Q: The second Newton Law's for a fluid is: Du Dt f = VP+p( What things should we consider to get the…

A:

Q: Water flows steadily with negligible viscous effects through the pipe shown in the figure below.…

A:

Fluid Pressure

The term fluid pressure is coined as, the measurement of the force per unit area of a given surface of a closed container. It is a branch of physics that helps to study the properties of fluid under various conditions of force.

Gauge Pressure

Pressure is the physical force acting per unit area on a body; the applied force is perpendicular to the surface of the object per unit area. The air around us at sea level exerts a pressure (atmospheric pressure) of about 14.7 psi but this doesn’t seem to bother anyone as the bodily fluids are constantly pushing outwards with the same force but if one swims down into the ocean a few feet below the surface one can notice the difference, there is increased pressure on the eardrum, this is due to an increase in hydrostatic pressure.