i need clear ans by hand and solve very very fast in 20 min and thank you | Consider the system shown in figure (1). Design a compensator network Ge(s) that the static velocity error constant is 20 sec-¹ Verify the results of your design. R(s) Input Ge(s) Figure (1) 16 s(5+4) Y(s) output

i need clear ans by hand and solve very very fast in 20 min and thank you | Consider the system shown in figure (1). Design a compensator network Ge(s) that the static velocity error constant is 20 sec-¹ Verify the results of your design. R(s) Input Ge(s) Figure (1) 16 s(5+4) Y(s) output

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Determine V,, Vs(pk), Vupk), Vdc, PIV, and fout. Draw also the output waveform with the voltage…

Q: Given circuit below rposition to find voltage across the capacitor, vet) Frequency is 100 Ha 6kn…

Q: 3. Determine whether the systems with the following characteristic equations are stable or unstable:…

Q: |9. The waveforms in the figure below are applied to the MUX as shown. The multiplexer has the input…

Q: The output of the op-amp comparator is a a. rectangular waveform O b. sawtooth waveform O . triangle…

Q: Ise Kirchoff's junction rule to give the equations of current in figure. 30 40 50

Q: Number 9 Please show your detailed solution. Number 9 Please show you detailed solution. A 50-ohm…

A: Given that: R=50 ΩC=40 μF V= 180 volt Current I=3.13 A Find frequency f.

Q: A copper-constantan thermocouple is connected to a copper-constantan extension wires and the…

Q: 100 V 50 8mH 600 200 A The switch is initially open in the circuit diagrammed above. A) What current…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: 1- In a buck DC/DC converter: V₁ = 100 V, R= 8M, D= ton = 0.8, f == 20000 Hz, L = 200 µÍ, Find: a)…

A: Types of Converter DC-DC Converter (Chopper) DC AC Converter (Inverter) AC-DC Converter…

Q: 2. Discuss the following circuits by directly stating their circuit diagrams, waveforms, principle…

Q: . You are given the following First Order Differential Equation. The current ? is in Amps and the…

Q: Plot the graph between P vs Va in Dc shunt excitation motor

A: In dc shunt motor speed is nearly constant. The relation between power and voltage is non linear.…

Q: This is a practice problem from the Introduction to Electronics course in my Electrical Engineering…

A: Circuit Analysis:Given the circuit, we have:Bipolar junction transistors (BJTs) Q3 and Q4.Resistors…

Q: A charging RC circuit has a switched-control DC voltage source of 6V and has a series RC of 20 ohms…

A: In this question dc source with transient given....We have to find out time constant , capacitor and…

Q: 4. What is an emergent property? O a. a property that a system has but that its individual component…

A: Given: Emergent property

Q: 32 Ω 4 M μF 25 S μF 16 Ω A In the circuit above the switch S is initially open. The battery has been…

Q: For the circuit shown in the given figure, assume vst=-2 V. VS2=2sin (2mx2000) V. R₁ = 100 kohm,…

A: We need to find out the output voltage for the inverting summing amplifier.

Q: answer with solution Derive an expression for the total output for the system represented by the…

Q: 1- In a buck DC/DC converter: V₁ = 100 V, R = 82, D = ton = 0.8, f == 20000 Hz, L = 200 μH, Find: a)…

Q: Q1: Suggest an appropriate differential equation for the following analog computer diagram. (Show…

A: Given: The analog computers are well suited to represent the situations described by the…

Q: 10. What happens to the potential difference across the resistor when the capacitor becomes fully…

A: Explanation: “Since you have asked multiple questions, we will solve the first question for you. If…

Q: e 9:27 E118% ", OON 36 For the following circuit in the figure below. Determine Vp-Va ( in units of…

Question

i need clear ans by hand and solve very very
fast in 20 min and thank you |
Consider the system shown in figure (1). Design a compensator
network Ge(s) that the static velocity error constant is 20 sec-¹
Verify the results of your design.
R(s)
Input
Ge(s)
Figure (1)
16
Y(s)
output

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Compensator Gc(s)

VIEW

Step 2: Verification using compensator and velacity error

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Different Types of System and Its Property

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A voltage commutated chopper operating at 1 kHz is used to control the speed of dc motor as shown in figure. The load current is assumed to be constant at 10 A. 00000 V = 250 V 1₁F XA vous 2mH The minimum time in uses for which the SCR M should be ON is
Number 22
The data-input and data-select waveforms in Figure 7 are applied to the multiplexer. Determine the output waveform F in relation to the inputs.
R +Vcc -Vcc C Vout R R a. Quantify how the resistors and the capacitor influence the output voltage of the circuit, Vout. What are the upper and lower limits of Vc? b. Howlong does it take for the capacitor to be charged from minimum to maximum voltage and vice versa?
4- Design a boost converter that will have an output of 60 V from a 24-V source. Design for continuous inductor current and an output ripple voltage of less than one percent. The load is a resistance of 50 2. Assume ideal components for this design. VL ooooo ip - ^
I need the answer as soon as possible
I need a clear step by step answer please and explanation please on how to obtain the values of Th and Tl and Vl
For the following zener clipper draw the output waveform Vz1 = 5V, Vz1 = 7V VK = 0.8v lkn ISV V₁₂ 5V 2, 72. -5V Q2 Determine The Output Waveform And Calculate The current and PIV 1kQ 1kQ 10 V 10 si www www Q. For the circuit shown in Figure below (1),find the maximum and minimum values of zener diod current. Live 5 ΚΩ www I IL 15 80-120 V 10 ΚΩ LIR 101 102 1015 S Ne 1 k0 www Iz 50 V U2 -ot V. Fumal inash
This is an Electronic subject. Please provide a step-by-step working solution. Thank you.
i need clear ans and solve very very fast in 20 min and thank you | ᴅʏʙᴀʟᴀ ?✨؛
A boost converter is required to have an output voltage of 8 V andsupply a load current of 1 A. The input voltage varies from 2.7 to4.2 V. A control circuit adjusts the duty cycle to keep the outputvoltage constant. If the switching frequency is 200 kHz, determine:i. a value for the inductor such that the variation in inductorcurrent is no more than 40% of the average inductor current forall operating conditions.ii. a value for the capacitor such that the output voltage ripple isno more than 2%.iii. in case the OFF period is reduced by 30% for constantfrequency operation, find the new output voltage
Write the loop equations for a Buck converter in the two modes if the inductance is characterized by a combination of inductance L1 in series with an equivalent resistance r1, filter capacitance is characterized by a capacitor C1 in series with resistance r2. Also assume that the controlled switch has a drop of 0.4V and the freewheeling diode has a voltage drop of 0.65v. Draw the corresponding equivalent circuits in each mode.