A voltage commutated chopper operating at 1 kHz is used to control the speed of dc motor as shown in figure. The load current is assumed to be constant at 10 A. 00000 V = 250 V 1₁F DA vous 2mH The minimum time in uses for which the SCR M should be ON is

A voltage commutated chopper operating at 1 kHz is used to control the speed of dc motor as shown in figure. The load current is assumed to be constant at 10 A. 00000 V = 250 V 1₁F DA vous 2mH The minimum time in uses for which the SCR M should be ON is

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Frequency of emf in the stator of a 8 pole induction motor is 50Hz and the rotor emf frequency is…

Q: D1 KH 1SR154-400 V1 + SINE(0 15 1K) Vo R1 2K

A: Diode: It is a semiconductor device that is on in the forward bias condition and off in the reverse…

Q: In a workshop, there is a three-phase asynchronous motor with a power of 6 HP, an efficiency of 85%,…

A: Given dataOutput power, Efficiency, Initial power factor, Final power factor, To find outWe have to…

Q: Question 2. Considering this figure. The firing angle is 45°, the motor current is 10 A, and the…

Q: For the figure shown, If SCR 3 and SCR 4 are conducting. The output voltage of three phase…

Q: For the DC circuit shown in Figure P30, find the voltage across each resistor and the current in…

A: We have to calculate the voltage and current across each resister.

Q: A single-phase AC voltage controller has a resistive load R = 10 Ohm, and the RMS input voltage is…

A: First we will find rms value of output voltage. Output power delivered = (Rms value output…

Q: Capacitors are used after the converter toA. smooth out the DC current.B. suppress the noise.C.…

A: A converter is used to convert the input AC voltage into DC voltage. The capacitor is used after the…

Q: R1 Vi 1k0 Di IN4148 D2IN4148 5V FL Vo -5V Eiv -3V Figure 1 a)Draw a simplified circuit for positive…

A: The diode is ON when the voltage across anode is more than the cathode voltage. It is known as…

Q: In DC generators, lap winding is suitable for ) high voltage, high current low voltage, high current…

Q: induction motor is rated 5 HP, 75% power factor and 220 V. What approximate size of capacitor (VAR)…

A: We need to find out VAR size for increased power factor

Q: The O smaller O larger the number of poles used in a stepper motor, the better the resolution

A: here we have to give relation between the number of poles and resolution.

Q: A four-pole induction motor drives a load at 2575 rpm. This is to be accomplished by using an…

Q: What is the differential compound generator and what is the principle of work, what are its…

A: Generator is a electrical machine which converts Mechanical energy into electrical energy.…

Q: Angular speed of a DC motor running at a speed of 1200rpm is

A: To determine angular speed (in rad/sec) from the speed given in rpm

Q: Can you explain the given questions in an original way? Factors Affecting Electrical Energy in DC…

A: Electrical machines can be either generator, transformers, or motors. They can be either Ac machines…

Q: In Single AC regulator with bidirectional control, if the input voltage is 200 V, 50HZ and the load…

A: following data is given Vinrms=200 volt⇒VS=Vm2=20022 volt f=50Hz α=60° we…

Q: Draw a circuit diagram to get the DC output voltage with constant DC output current from a fixed AC…

Q: In a given circuit below is connected to an AC signal with 240V peak in a 4:1 transformer. Sketch…

A: According to the question we have sketch the voltage wave form at V A and V o as practical diode.

Q: Which of the following could dictate the level to which the AC signal can be adjusted? a. Bias…

A: Alternating current- An alternating current varies sinusoidal in time domain, or to be more specific…

Q: A Flyback converter has the following parameters Vin=30V, N1=30turns, N2=15 turns, the magnetizing…

A: Given below clear explanation

Q: Q/A230u Sepeiately-exaled de generator has the followingeccharactenstics when run at looe Lield CA).…

A: The open-circuit characteristic data table of a 230 V separately excited DC generator is given as…

Q: block diagram fro dc motor refrigerator

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines…

Q: If the output voltage across the transformer secondary coil is Vm AC volt. a- Give a circuit to…

A: We want the output as DC value. Hence a rectifier type circuit must be present. The input AC voltage…

Q: The excitation circuit of a free-excited DC motor is a single-phase full- * wave uncontrolled…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should be…

Q: The single - phase ac voltage controller with inductive load. Plot the waveform of output voltage…

A: According to the question we have to plot waveform according to given conditions.

Q: A three phase full wave rectifier is shown below. The input phase voltage peak is Vm=311.128 V. The…

A: The solution is given below the answer is option b

Q: ----- In d.c. generators armature reaction is produced by armature current O none of the mentioned O…

Q: 7. When power to a resistance load is controlled by full-wave SCRs with a 90° firing angle, what is…

A: In this question we need to find a load power factor of the given full wave SCR .

Q: A DC-DC buck converter operates in continuous conduction mode. It has 48 V input voltage and it…

A: Given- DC-DC buck converter- Input voltage V=48 V, Resistive load R=24 Ω, Frequency f=250 Hz, Switch…

Q: Comment briefly on the relationship between input and output power at varying excitation levels and…

A: Infinite Bus Bar is the bus bar where many(infinite) synchronous machines are connected. The…

Q: 1. The operation of Commutator in DC Motor is O a) to convert dc to ac O b) to convert ac to dc O c)…

Q: 4. A 60 Hz AC circuit has a voltage of 120 V and a current of 6 A (effective value). What are the…

Q: (2-8) A zener diode has a de power dissipation of Iw and a zener voltage rating of 27v. What is the…

Q: A commutator has 456 segments. Indicate whether or not the windings are possible a. Duplex-wave,…

Q: The brushes width in Wave winding is equal to a. 1.5 commutator segments. b. 1 of commutator…

A: brushed width in wave winding is equal to?

Q: Find the values of K₁ and K₂ to yield a peak time of 1.5 seconds and a settling time of 3.2 seconds…

Q: the way of work buck dc-to-dc converter

A: The operation is explained in following pictures

Q: A 35 V rms sine wave is applied to the input of a certain negative clamper circuit that uses an…

Concept explainers

Differential amplifier

There are two amplifying stages with common degeneration in a differential amplifier.

Question

A voltage commutated chopper operating at 1 kHz is used to control the speed of dc motor as
shown in figure. The load current is assumed to be constant at 10 A.
00000
V = 250 V
1₁F
XA
vous
2mH
The minimum time in uses for which the SCR M should be ON is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How voltage is built up in dc shunt generator
An ac controller has a resistive load of R = 10 2 and the input is 220 V, 50 Hz. The thyristors switch is on for n 25 cycles and for m 75 cycles. Determine: (i) (ii) (iii) the rms value of the output voltage, the input power factor, the average and rms current through thyristors.
In DC machines the number of parallel paths for a wave winding generator is Select one: O a. Three O b. Two OC. Half the number of poles O d. Equal to Number of Poles
The frequency of rotor current in an induction motor is slip times the frequency of stator current. slip times the frequency of supply, One by slip times the frequency of stator current. One by slip times the frequency of supply
Untitled Section Jalis 6 In d.c. generators armature reaction is produced by field current O armature current commutating winding current none of the mentioned compensating winding current *.The use of d.c. generators eliminated the use of rectifiers and ac supplies True False O
Solve it quickly please
B9
Rectifier determine the following show complete solution
A single phase full wave AC voltage controller has a resistive load of 5 ohms and an input voltage of Vs = 240 V (RMS), 50 Hz. The delay angles of both thyristors are set to 45 degrees. The maximum RMS and average current ratings of the thyristor are equal to: Select one: O a. 33.94A and 21.6A O b. None of these O c. 24A and 10.8A O d. 48A and 26.09A Clear my choice
The ripple factor for pure dc is
2 Compare between base load pbiney stvion and peak load power station.