I am allowed to work with someone I just don’t understand this Using the Volumetric Pipet Data from Part C calculate the 12. Percent error between the known density (from data A) and the average experimental density (from calc 10).

Q: 5. Calculate the stoichiometric amount of anhydrous ammonia (kg NH3/day) needed to reduce 800 ppm…

A: The volume of fluid which goes through per unit time is known as flow rate.

Q: Chemistry 2. Calculate the Vm of Ar(g) at 200 K and I atm.

A: Molar volume =16.4 lit/atm To calculate the molar volume of a gas, you need to know the temperature…

Q: For a perfect gas with Cp.m = a+ bT + c/T², where a, b, and care certain constants, find expressions…

A:

Q: 11. 22.4 kg/L to dag/mL 12. 0.74 miles/min to dm/sec 13. 1.42 g/em² to mg/mm?

A:

Q: Virial equation can be written in Z (compressibility factor form): Z = pV/RT = 1 + B'p + C'p2 +…

A: Virial equation was proposed by Kamerlingh-onnes.This is the equation of state for real gases in…

Q: A sample of H2 gas is collected over water at 21.5 degrees C and atmospheric pressure is 765 torr.…

A: Given: Temperature = 21.5 oC Atmospheric pressure, Pbarometric = 765 torr = 765 mm Hg…

Q: The lung capacity of a scuba diver at the surface of the water is 3200 mL at 17°C and standard…

A: At standard pressure, the pressure is 101.325 kPa (i.e. 1 atm, 760 mm Hg)

Q: (6) Using the following diagram to determine the atmospheric pressure (cm Hg): S0 cm

A: The given diagram is simple barometer. It is used to measure the atmospheric pressure.

Q: If a small box contains 1.5×1012 molecules per cubic centimeter for methane gas, a temperature of…

A: Interpretation -  To determine the partial pressure of methane gas when box contain 1.5 × 10 12…

Q: b Convert the pressure 1.4000 x 106 Pa into millimeters of mercury. mm Hg C Convert the pressure 363…

A: Dimensional analysis is used to convert a physical quantity given in one type of unit to some other…

Q: Find the total pressure for a mixture that contains four gases with partial pressures of5.00 kPa,…

A: When a single gas or the mixture of gases are filled in a container. Due to their kinetic energies,…

Q: Virial equation can be written in Z (compressibility factor form): Z = pV/RT = 1 + B'p + C'p2 +…

A: Virial equation is the one of the most important equations of thermodynamics. In Virial equation we…

Q: An experiment is conducted in which a quantity of H2(g) is chemically generated in a closed…

A: Given initial condition are volume = V1 at absolute temperature = T1   Pressure increased from Pa…

Q: Please identify the percent difference of the experimental molar volume and theoretical molar volume…

A: The balanced equation for the reaction between Zn(s) and HCl to form H2(g) is: Zn(s) + 2HCl(aq) →…

Q: 1) The limit for SO2 concentration in the stack gas of a power plant is 390 ppm. Convert the SO2…

A: a) The limit of SO2 in ppm can be converted to μg/m3

Q: 1. Determination of the Ideal Gas Constant "R" using Carbon Dioxide 10 °C- 3700ml 768.0mm Hg…

A: As per student request Part 1(First question) Solved!!

Q: p/(kg m³) 0.225 0.456 0.664 1.062 1.468 1.734 PIA.6 The molar mass of a newly synthesized…

A: Hi, we are supposed to answer one question. To get the remaining questions solved please mention the…

Q: (a) 100 K N2 200 K 500 K 1000 K 500 1000 1500 Velocity v (m/s) This figure shows the relationship of…

A: Kinetic molecular theory explains the behavior of molecules. It demonstrate the relationship between…

Q: A 1.00 L flask is filled with 1.30 g of argon at 25 °C. A sample of ethane vapor is added to the…

A: Answer is given below

Q: . A cylindrical metal canister is filled with pressurized diatomic oxygen gas, O2. he circular base…

A: The physical properties of the gas can be better described based on the kinetic theory of gases.…

Q: In a major human artery with an internal diameter of 5 mm, the flow of blood, averaged over the…

A:

Q: e P x V product for each trial (use significant digit rules) and complete the table below. yle's Law…

A: Average = Sum of observation/number of observation

Q: Study the tabulated data during an gravimetric analysis of BaSO4 experiment Trial T1 T2 T3 Mass of…

A:

Q: An experiment is conducted in which a quantity of H2(g) is chemically generated in a closed…

A:

Q: Gas Laws (3) O a. State Boyles Law - for a fexced mass of gas at constant Temperature Volume vanes…

A: Boyle's Law states that for a fixed mass of gas at constant temperature, the volume of the gas is…

Q: at 1 atm. Assume that the air consists of 100% oxygen. How long does it take to deposit one atomic…

A: The objective of the question is to determine the time taken for the deposition of oxygen layer on…

Q: nistry 1 100 cm of hydrocarbon at 1 atm is compressed to 37.0 cm3 at a constant temperature. What is…

A:

Q: 15. Predict the total pressure in Container C if the initial pressure in Container A was tripled and…

A: A question based on properties of gases. A mixture of two gases in a container are given whose total…

Q: Forgot to put the units they are asking for on the previous submission. Am I doing this correctly?…

A: The details of calculation is given below:

Q: 3. Calculate the collision frequency, z, and the collision density, Zaa, in H;S (d = 360 pm) at 75 C…

A:

Q: (ii) the maximum energy that can be made available for work due to the process.

A: Given: Moles of gas = 100 Initial volume = 2m3 Final volume = 5m3 Temperature  = 280 K Constants, a…

Q: 6) In an Edie-Hofstee plot of v versus v/[S] what are the units of the y- intercept? 7) The Vmax…

A:

Q: Show the calculation of the mass (grams) of a 14.5 liter gas sample with a molecular weight of 82…

A:

Q: Percent Yield of hydrogen gas at STP Trial 1 Trial 2

A: Mg(s) + 2HCl(aq) →MgCl2(aq) + H2(g)

Q: compressibility factor of the gas at 508 K and 131,813 Pa. Report your answer to 4 decimal places of

A:

Q: 1. Which of the following is NOT a true representation of the Lineweaver-Burk equation? Group of…

A: Since we only answer one question at a time, we’ll answer the first one. Please resubmit the…

Q: A 7.00 L tank at 19.6 °C is filled with 3.42 g of dinitrogen difluoride gas and 5.08 g of chlorine…

A:

Q: 8. Consider a gas with the equation of state P - RT(1/V+ a/V + b/V). Usually one finds the critical…

A: All the gases, in ideal condition follow the gas laws. The gas laws states that “at constant…

Q: 5) In some system with a constant composition, U is a function of V and T. Write the differential…

A: Internal energy is a function of the volume and the temperature. In a closed system of constant…

Q: If PV = nRT, then solve for T.

A: A question based on general chemistry that is to be accomplished.

Q: For problems 1-3, consider the situation below. The van der Waals constants for HCl are a = 0.372 Pa…

A: We know that the formula for calculation of the following is :       Critical volume = 3b

Q: Describe unique charachteristics of gas particles, give at least two pieces of information.

A: Characteristics  of Gas particle

Q: Pre lab Assignment Name 1. A student, following the procedure described in this exercise, collected…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Calculate the volume of the flask using the mass of water which filled the flask and the density of…

A:

Q: Using the data sets provided in the photos, please solve how to find the (M) of H2O2 (after mixing)…

A: Molarity is defined as the moles of compound present per L of solution. Its unit is mol/L.

Kinetic-Theory of Gases

Kinetic theory of gases is the model or method which was developed in the 19th century by Maxwell and Boltzmann. This is possible as the interatomic force which is of short-range forces that are important for solids and liquids can be neglected for gases. This theory or gas law gives a molecular interpretation of the pressure and temperature of a gas and is consistent with gas laws and Avogadro’s hypothesis. This theory is very helpful to correctly explain the specific heat capacities of many gases, kinetic energy and it also explains the transport qualities such as viscosity, thermal conductivity, and diffusion with molecular parameters. As stated in the kinetic-molecular theory, the temperature of a substance or gas particle is related to the average kinetic energy of the particles of that substance. When a substance is heated, some of the absorbed energy is stored within the particles, while some of the energy increases the motion of the particles, called average kinetic energy.