(i) A tie bar is 2.5 m long, has a circular cross section of 50 mm in diameter and is subjected to a force of 250 kN. Given that Young’s Modulus E = 209 kN/mm2 and Poisson’s Ratio ν = 0.3 calculate the change in volume of the bar when loaded. (ii) Draw the shear force and bending moment diagrams for the cantilever beam shown in the image attahced clearly indicating all significant points.

Q: 5 - An aluminum circular shaft, fixed at both ends, is loaded by torques applied at points B and C,…

A: Given Data  Shear modulus (G) = 85 GPa  Diameter of shaft (d) = 40mm  Length of AB (LAB) = 0.5m =…

Q: 100 mm 25 mm 125 mm M. 75 mm The beam is subjected to an internal moment of M = 3 kNm. 25 mm 75 mm…

A:

Q: A structural tubing 2.5 in x 4.0 in rectangular cross-section was abricated by extrusion. Determine…

A:

Q: The stress on a structure is as follows. The EI of the ?-shaped part of the structural section is…

A:

Q: 200 mm If the beam is subjected to a bending moment of M=50KN, determine the maximum bending stress…

A: Using formula to find bending stress

Q: Pin G B (b) (a)

A:

Q: The wide-flange beam is subjected to the loading shown in (Figure 1). Suppose that P = 40 kN. Follow…

A: Solution:

Q: 2. Determine the shearing stress in each of the four walls of a portion of a structural aluminum…

A: Given, Torque =3 kN-m=26.55 kip-in Dimension=100×51 mm=3.93×2 in Wall thickness=4 mm=0.15 in.

Q: 6 m 3 m 3m 30 kN 4 m F 4 m 4 m H. 4 m A B Figure (a)

A: Using method of joints to calculate the forces in each member of the truss. Support reaction at A=…

Q: A solid 27 mm diameter shaft is subjected to an axial load of P = 50 kN and a torque of T acting as…

A:

Q: What is the max shear stress in the shaft? Input your answer as a value only in MPa to one decimal…

A:

Q: A propped 6 m long cantilever beam is shown in Figure 3. In addition to a saw-tooth loading as shown…

A: Given  clockwise moment is applied at B = 10 KN-m

Q: A steel strut S serving as a brace for a boat hoist transmits a compressive force P= 57 kN to the…

A:

Q: The channel shape cross-section and the rectangular cross-section shown in the Figure Q4 are made of…

A: two sections are given as followsh=74mmb=52mma=8mmH=74mmd=52mmfor channel section yield…

Q: saw-tooth loading is applied as shown in the figure. The flexural tiffness (EI) of the beam is 1×10³…

A: Given- A propped cantilever beam carrying UVL loading. Required- To calculate support Reactions of a…

Q: A torque of T = 1900 Nm is applied to each of the fixed supported bars as shown in Fig. 1. a)…

A: Given : T = 1900 Nm To Determine :

Q: Question # 3: The frame supports the distributed load shown. Determine the state of stress acting at…

A: Determine the stress at point D and E. where point D and E are at different location in beam and…