How many kilograms (kg) of 20-20-20 soluble fertilizers should you add to a 50 gallon concentrated stock tank using and injector dilution ratio of 200:1 to provide a fertilizing solution of 200 mg N/L for plants plants?

How many kilograms (kg) of 20-20-20 soluble fertilizers should you add to a 50 gallon concentrated stock tank using and injector dilution ratio of 200:1 to provide a fertilizing solution of 200 mg N/L for plants plants?

Chemistry & Chemical Reactivity

10th Edition

ISBN:9781337399074

Author:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Chapter11: Intermolecular Forces And Liquids

Section11.6: Properties Of Liquids

Problem 2.2ACP

See similar textbooks

Similar questions

Hi! I need answers for numbers 2 and 3. My professor said that The unit of solubility is in grams per 100mL, while the solvent used is only 50mL, so a yield of close to 2.0g is impossible. Recalculate using this information. Thanks!
Ir Ali is currently taking Mucogel suspension at a daily dose of 10 ml after her three meals and bedtime. How much magnesium hydroxide will Mr Ali have taken after 5 days of compliant use of Mucogel? (Mucogel contains magnesium hydroxide 195 mg and dried aluminium hydroxide (220 mg/5 ml
3. 3 M NaOH Reagent water Concentration of Stock to Prepare Calculate the grams of chemical needed for each stock listed below. 1% Lactose 1% Dextrose 16.7 ML 73.3ML 1% Sucrose 100 mL Total Volume of Stock Needed 10 mL 20 mL 25 mL 16.7m Amount of chemical Needed (in grams) Your instructor will have you make ONE of the above solutions-ask your instructor which solution t make.
Tea leaves were boiled in water and around 1.50 grams of caffeine were extracted by 200.0 mL of water. If three portions of 25.0 mL of dichloromethane were used to extract the caffeine from the aqueous layer, how much caffeine will be extracted by the dichloromethane? Solubility of caffeine in water: 2.18 g per 100 mL waterSolubility of caffeine in dichloromethane: 18.2 g per 100 mL dichloromethane
Determine the percent yield of the synthesis. The % yield = 81.33 % The Theoretical Yield = 2.65g The Actual Yield = 3.256g Part I Synthesis of Aspirin Mass of salicylic acid used (g) 2.029g Volume of acetic anhydride used (mL) 5ml Mass of acetic anhydride used (vol. × 1.08 g/mL) 5.4g Mass of aspirin synthesized (g) 3.256g Part II Melting Temperature Data Melting temperature (°C) 133°C Part III Salicylic Acid Standard Stock Solution Initial mass of salicylic acid (g) 0.210g Moles of salicylic acid (mol) 0.0147mol Initial molarity of salicylic acid (M) 0.724 M Part III Beer’s Law Data for Salicylic Acid Standard Solutions Trial Concentration (M) Absorbance Water (mL) 1 0.724 M 0.301 0 2 0.724 M 0.219 2.5 3 0.724 M 0.163 5.0 4 0.724 M 0.074 7.5 Best-fit line equation for the salicylic acid standards Test of the Purity of the Synthesized Aspirin…
! ( give step by step explanation)
Kindly answer this question
A 1 mL sample of glycogen was calculated to contain 21 µmol (micromole) glucose. To 1 mL of this sample was added 2 mL of 2 M HCl. It was then hydrolysed by boiling the solution for 15 minutes. After boiling the hydrolysate was cooled and made up with H2O to a final volume of exactly 10 mL. The glucose was measured in this solution and found to have a concentration of 340 µg/mL (microgram/milliliter). i) Calculate the mass (mg) of glucose in the 10 mL of hydrolysate. As the 1 mL of glycogen sample was made up to a final volume of 10 mL, this mass of glucose was produced by the hydrolysis of the original 1 mL glycogen sample. ii) Calculate the amount (µmol) of glucose produced by the hydrolysis of the glycogen sample. iii) Calculate the purity of the glycogen used in the sample as % Purity = (moles of measured glucose/ moles of calculated glucose in glycogen) *100 iv) state your answer in a complete sentence. Show your working out such that the marker can easily understand it.…
A 1 mL sample of glycogen was calculated to contain 35 µmol (micromole) glucose. To 1 mL of this sample was added 2 mL of 2 M HCL. It was then hydrolysed by boiling the solution for 15 minutes. After boiling the hydrolysate was cooled and made up with H2O to a final volume of exactly 10 mL. The glucose was measured in this solution and found to have a concentration of 570 µg/mL (microgram/milliliter). i) Calculate the mass (mg) of glucose in the 10 mL of hydrolysate. As the 1mL of glycogen sample was made up to a final volume of 10 mL, this mass of glucose was produced by the hydrolysis of the original 1 mL glycogen sample. ii) Calculate the amount (µmol) of glucose produced by the hydrolysis of the glycogen sample. iii) Calculate the purity of the glycogen used in the sample as % Purity = (moles of measured glucose/ moles of calculated glucose in glycogen) *100 iv) state your answer in a complete sentence.
How many grams of ascorbic acid must be dissolved in 0.15 liters of water to produce a 0.3 M solution? How many milliliters of water should be added to a 0.1-liter aliquot (taken from the 0.3 M solution) to achieve the desired dilution which is a 0.15 M solution? Use (C1V1 = C2V2) in solving the dilution. M stands for molarity.
how to I convert 10mg/L (10ppm) of nitrate (NO3-) to molar mass of nitrate? Ç Chapter 10 part 1: concentration units As we have learned throughout this class, water contaminants can be harmful to the human body and the environment. There is an exact amount of how much nitrate can be present in drinking water before it becomes unsafe. The U.S. EPA has a standard of 10 milligrams of nitrate per liter of water (mg/L), which is the same as 10 ppm. Anything at or below 10mg/L is considered to be safe for humans to drink. If we were to consume more than the standard level of nitrate it can cause a lot of health concerns, like weakness, dizziness, and an excessive heart rate. Problem: What is the molar mass of Nitrate at 10ppm? the same problemljust worded differently Nitrate (NO3-) I 1mg/L-1ppm convert 10ppm of (NO3-) into molar mass of (NO3-)
Since natural gas (CHe 16.05 g/mol) and propane (CyHg, 44.11 g/mol) are colorless and odorless, a small amount of methanethiol is added to make it easy to detect a gas leak since humans can detect methanethiol in concentrations as low as only a few parts per billion. A sample of propane is analyzed and found to contain 2.50 mg of methanthiol in 1000.0 g of the mixture of the two gases. Which of the following statement is true? O methanethiol is the solute, propane is the solvent the vapor pressure of methanethiol is 2.5 mg/g propane is the solute, methanthiol is the solvent O The methanethiol must become a solid to dissolve in propane