- how a 32Kbyte ROM module can be c PROM chips, occupying the address ran ne following address decoding circuits: Nand decoding circuits A line decoder and a Nand gate PLD decoding circuit

Q: -What is the last address in a SRAM chip with pins A0 A15 and D0 D7

A: Address of the last location of SRAM Chip is FFH

Q: Compare CISC machines to RISC machines

A: CISC and RISC machines Reduced Instruction Set Computer (RISC) is a type or category of the…

Q: 3. In Harverd archticture for PICs there are A. Compact program bus and data bus B. Data, program,…

A: In Harverd archticture for PIC's there are   A. Compact program bus and data bus   B. Data,…

Q: A 5 bit address decoder is shown below. The address that triggers the output gate is (use…

A: The Address that triggers the output gate is

Q: 12. What is the vector address of Timer 1?

A: 8051 has two internal interrupts namely timer0 and timer1.

Q: WRITE AT LEAST 3 MIDDLE RANGE MICROCONTROLLERS AND THEIR QUALITIES. WHAT IS THE USE OF THE BUSES IN…

A:

Q: Interface two 4K X 8 EPROMS and two 4KX 8 RAM chips with 8086. by using appropriate gates ( like AND…

A: NOTE Below is the answer for the given question.  Hope you understand it well. If you have any…

Q: Place -23.5 in the IEEE floating point register.

A: IEEE Single Precision Floating Point Format   IEEE Single Precision Floating Point Format…

Q: When comparing EPROM, EEPROM, and Flash Memory, how are they different? Why do parity bits exist and…

A: GIVEN: When comparing EPROM, EEPROM, and Flash Memory, how are they different? Why do parity bits…

Q: 10. What is the benefit of using sample sequencers in the A/D chip microcontroller? 11. Where the…

A: According to bartleby guidelines we are supposed to answer only 1 question so I have answered 11th…

Q: Specify the size of a ROM (number of words and number of bits per word) that will accommodate the…

A:

Q: Show the memory address range (i.e., the first address and the last address) for the 64×8 PROM chip?…

A: To find the memory address range for a 64x8 PROM chip, you need to determine the number of…

Q: How does the concept of "write amplification" apply to NAND flash memory and its impact on SSD…

A: "Write amplification" is a crucial concept in NAND flash memory technology, particularly when…

Q: Using four 32 x 8 ROM chips, design a circuit such that the effective size of the ROM circuit is 64…

A: Address using the high-order address bit to generate the chip select. By inserting two chips in…

Q: Discuss an advantage and disadvantage of multifunctional pins on a microcontroller.

A: Given:  Advantages and Disadvantages of multifunctional pins on a Microcontroller.

Q: Write the RISC-V assembly code that creates the 64-bit constant 0x1234567812345678hex and stores…

A: Dear Student, The required code with explanation is given below -

Q: 1: Describe Program Status Word (PSW) of 8051 microcontroller.

A: The PSW is an 8 bit register, also known as flag register. It is 8 bits wide and only 6 bits are…

Q: ave se

A: Introduction: In most cases, RAM, ROM, and IO pins are absent from microprocessors. Typically, it…

Q: Illustrate how three 2-Kbyte external ROM could be interfaced to the 8051 microcontroller

A: Illustrate how three 2-Kbyte external ROM could be interfaced to the 8051 microcontroller.

Q: Distinguish between short jump and long jump of 8051 microcontroller

A: The relative address of the short jump is 8 bit. It can only forward to the 127 location.  Generally…

Q: Explain the significance of "NAND" memory in the realm of SSDs.

A: NAND memory is a type of volatile storage that plays a fundamental role in Solid State Drives…

Q: nterface two 32KB EPROM to the 16-bit data bus of 8086 based system. Design an address decoder…

A:

Q: One of the following is NOT a description of a data hazard in a RISC architecture: Select one:…

A: 1. Data Hazards in RISC Architecture: Data hazards occur when instructions that exhibit data…

Q: How does analog-to-digital conversion work in the context of microcontrollers?

A: In embedded systems, a microcontroller is a small integrated circuit that has a memory, programmable…

Q: Is the CMPS instruction confusing in any way?

A: Introduction: Two strings are compared using the CMPS instruction.  The DS: SI and ES: DI registers…

Q: Draw a complete memory interface for 8088 MP if the memory space is 512k byte and the memory type is…

A:

Q: Given 8 registers of 3 bit each. Design a bus using 2 to 4 line decoders and tri state buffers and…

A: In digital electronics a 3-state logic enables the output/ input pad to take high impedance,…

Q: The code is in RISC V For this part write the binary code/machine level code of the following…

A: Here, I have to provide a solution to the above question.

Q: High speed in RISC architecture is due to overlapping register windows rather than the reduced…

A: The idea of RISC architecture is to decrease the amount of time needed for the execution of certain…

Q: If a design has three inputs, eleven states, and five outputs, how many address pins (enter a…

A: Given Data : Number of inputs = 3 Number of states = 11 Number of outputs = 5

Q: Describe the memory structure of the programme memory on the 8051 microcontroller.

A: Introduction: Program Memory is a 64KB area named CODE in the original 8051. This sector is usually…

Q: Write a RISC V script to reverse the bits in a register. Use as few instructions as possible

A: void _start()  {      volatile char* tx = (volatile char*) 0x40002000;        unsigned int example =…

Q: Develop an Intel 8086 ALP using BIOS interrupts to print a 100x50 (in pixels) parallelogram in cyan…

A: Intel 8086 is a sixteen-bit HMOS microprocessor. It is to be had in forty pin DIP chip. It uses a 5V…

Q: Io 1 12 13 14 I5 16 17 EI 74148 EO Ao A1 A2 GS

A: All the input to priority encoder 74148 is active low. That is when input is Low, it is activated or…

Q: Choose the correct RISC-V instructions that can be used to jump to the instruction at PC = 0x0000…

A: Step 1 This problem is from RISC-V instructions. Let’s see some points about RISC-V instructions.

Q: Draw the connection of MARIE’s PC to the datapath using the format shown in Figure 4.15.

A: Explanation: The read operation is enabled when the signal “P1” is high and write operation is…

Q: What are the fields in an MIPS instruction?

A: INTRODUCTION:  A typical indicator of computer speed is MIPS (million instructions per second),…

Q: Regarding RISC-V: Considering the case of adding two positive 32-bit integers and placing the…

A: