homogenous block to be in static equilibrium. What will happen to the block if the magnitude of force P went above the maximum? The coefficient of static friction between the block and the floor is 0.30. The weight of the block is 500 lb, indicate the direction of the impending motion. 40° Guide Questions: a. What is the direction of frictional force on the 500 lb block? b. If slipping is impending, can we assume that F = μgN? c. Where is the location of the frictional force on the block if tipping is impending? Answer: Pmax=432.55 lb The block will tip to the right before it slips.

homogenous block to be in static equilibrium. What will happen to the block if the magnitude of force P went above the maximum? The coefficient of static friction between the block and the floor is 0.30. The weight of the block is 500 lb, indicate the direction of the impending motion. 40° Guide Questions: a. What is the direction of frictional force on the 500 lb block? b. If slipping is impending, can we assume that F = μgN? c. Where is the location of the frictional force on the block if tipping is impending? Answer: Pmax=432.55 lb The block will tip to the right before it slips.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Answer in two decimal places please
Read the question carefully and give me right solution with clear calculations
Kindly answer. Thank you!
Give me right solution according to the question
Please show intermediate steps including free body diagrams, equations used, problem setup etc. so that your approach can be followed.
In the floor plan below, the rigidities of walls A, B, and C are 1.0. The rigidity of wall D is 1.5. For a force of 100 kips in the horizontal direction, determine the maximum diaphragm shear per unit depth (absolute value). Assume that the center of mass is at the center of the diaphragm. To obtain this answer you will first need to compute the location of the center of rigidity and the force in each wall. 10' 10' A 10' CR D 10' X B
A concrete beam prestressed with a parabolic tendon is shown in the sketch. The eccentricity of the tendon is measured from the centroid of the cross-section. The applied prestressing force at service is 1620 kN. The uniformly distributed load of 45 kN/m includes the self-weight. 500 750 145 Cross-section (tendon not shown) 7300 Sectional elevation (All dimensions are in mm) The stress (in N/mm2) in the bottom fibre at mid- span is
We have simply supported two-way slap as shown below. If the density of concrete is 2450 kg/m3, calculate the maximum bending moment in kN.m at beam A due to the un-factored self weight of the concrete slab. ... 7 m 7 m 5m Beam A
2 DECIMAL PTS
The 600-lb, 20ft-wide rectangular gate shown is hinged at B and leans against the floor at A making an angle of 45° with the horizontal. The gate is to be opened from its lower edge by applying a normal force P at its center. A. Determine the magnitude of the hydrostatic force acting on the gate using the HYDROSTATIC PANEL EQUATIONS. Express your answer in kips. B. Determine the minimum force P required to open the seawater gate. Express your answer in kips.
Give three formulas to calculate the slip factor. Derive Stodola's relation for the slip factor.
Determine the maximum normal stress and the maximum shear stress, making the graph of the corresponding diagrams. Also determine the diagram of tangential efforts.