Homework 1 The simple beam AE shown in the Figure (1) supports a concentrated loads. Determent the following: 1-Reactions in points A and E 2- Shear force at each points 3- Bending moment at each points 4- Draw the shear-force and bending-moment diagrams for this beam. 35 kN 120 kN 20 kN B D E 5 m- 20 m 5 m 5 m

Q: Beams, Shear Force and Bending Moment in Beams Problem#3: HOMEWORK Draw Shear Force and Moment…

A: The reaction force acting at A and B due to the symmetry is RA=RB=100+1002=100 lbs For this question…

Q: Given: the simply supported beam with applied loads below Required: The resultant force of the…

A:

Q: Determine the magnitude of P so that the resultant couple moment acting on the beam is 45 kN-m…

A:

Q: The bending moment M of a beam of length / at a distance x from one end is given by M = Wx(1-x)/2,…

A:

Q: A simply supported beam of a total length l is shown in Figure Q5, where point A is supported by a…

A:

Q: A cantilever beam (with a clamp at x=0 and free at x=L, where L is the length of the beam) is…

A: Given:A cantilever beam (with a clamp at x=0 and free at x=L, where L is the length of the beam) is…

Q: A cantilever beam AB with a built-in restraint at end A is subjected to a combination of loads as…

A:

Q: SHEAR FORCE AND BENDING MOMENT For the beam ABCD shown in figure Q1, a) Determine the support…

A: In the given problem, the conventions of shear force will be taken as At left end : upward force is…

Q: A wooden beam is loaded by a distributed load w = 7 N/mm as shown in Figure Q4(a). The cross-…

A:

Q: A simply supported beam of a total length l is shown in Figure Q5, where point A is supported by a…

A: Given: To determine the support reactions and determine the equations for shear force and bending…

Q: Two identical 20-mm thick plates are bolted to the top and bottom flange to form the built-up beam.…

A:

Q: Ore is to be transported along a conveyor belt in a refinery. Figure Q1 shows an idealised beam…

A: Apply force equilibrium in horizontal direction.Apply moment equilibrium about point C.Apply force…

Q: The following diagrams show a fully fixed cantilever beam subjected to different loading cases. For…

A: The following diagrams show a fully fixed cantilever beam subjected to different loading cases. For…

Q: A thin beam with a solid rectangular cross-section is loaded as shown in Figure Q7 below. W W L/3…

A:

Q: 1) Sketch the shear/moment diagrams for the following beams. Your diagrams should show the value of…

A:

Q: A C B D 6 m 3 m 3 ni

A:

Q: Note: Include all necessary free-body diagrams. Q.1) (a) Find the support reactions of the beam…

A:

Q: Determine the maximum shear force and maximum bending moment for the beam

A:

Q: 40.0° 30.0⁰ cg 2.0 m draw the free body diagram. draw the vector starting at the black dogs. The…

A: draw the free body diagram. draw the vector starting at the black dogs. The location and orientation…

Q: Pravinbhai

A: Step 1:Step 2:Step 3:Step 4:

Bending Moment

In general, we can define the bending moment as the reaction induced when a certain amount of load or force is applied to an element which makes it bend.