Homework 1- A 20-kg package is at rest on an incline when a force P is applied to it. Determine the magnitude of P if 10 s is required for the package to travel 5 m up the incline. The static and kinetic coefficients of friction between the package and the incline are both equal to 0.3.

Q: Can the statue be dragged without tipping? O Yes No Frip xN If the movers can apply the force…

A:

Q: The force Pis applied to the 48-kg block when it is at rest. Determine the magnitude and direction…

A:

Q: A 130-lb crate is being transported by a 175-lb hand- truck cart along the frictionless floor. The…

A: To Find:The smallest ratio d/b for which the box will tip before it slides.Given:The force is

Q: This climber (mass=52kg) is maintaining this posture while grabbing onto a rock at P3 and reaching…

A:

Q: The force P is applied to the 42-kg block when it is at rest. Determine the magnitude and direction…

A:

Q: The force P is applied to the 37-kg block when it is at rest. Determine the magnitude and direction…

A:

Q: A brake mechanism is used to lower body A with a constant velocity of 3.0 m/s. The coefficient of…

A: Given:To find:(a) Mass of body A.(b) Power dissipated by the brake.

Q: 1) If the 50-kg crate is subjected to a force of P = 200 (N), determine its speed when it has…

A: In this question I have solved using both the methods to get the solution in different ways.…

Q: Block A has a mass of 29 kg and block B has a mass of 41 kg. The two blocks are stacked on the ramp…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.