1) If the 50-kg crate is subjected to a force of P = 200 (N), determine its speed when it has traveled 15 m starting from rest. The coefficient of kinetic friction between the crate and the ground is P=0.3. If the 50-kg crate starts from rest and attains a speed of 6 m/s when it has traveled a distance of 15 m, determine the force P acting on the crate.The coefficient of kinetic friction between the crate and the ground is μ = 0.3.

Q: 7. The simple machines that make up the can opener are (a) lever, wedge, inclined plane, gears (c)…

A: Simple machines is a types of machines that creates work trouble free . it contains some of the…

Q: A 4.8 m long from fixed point, 0.5 m wide and assumed a thickness of 30 mm throughout a springboard…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Problem 3 An initially-insulated, rigid tank conta removed and the water in the tank e at 27°C. What…

A:

Q: 4. Explain the operation of thermochemical energy storage system.

A:

Q: are you able to do it using integration method?

A:

Q: A stationary diesel engine with a thermal efficiency of 40% produces 200 horsepower. The exhaust…

A:

Q: A building has a heating load of 630,000 BTU/hr. A hydronic heating system is used, supplying 40 GPM…

A:

Q: Which of the following is the Camot Efficiency? work input /work output (input temperature - output…

A: Carnot efficiency: It is maximum efficiency of a thermodynamic cycle. Heat input and heat output is…

Q: A biomass digester receives 23 kJ of energy in the form of heat. There is a mechanical mixer that…

A:

Q: calculate the annual heating demand and the maximum heat output required by the boiler b) If the…

A: Given: Heating - 2670 DD/year V - 300 m3 U - 252 W/K To find: Design service heat loss

Q: Electrical discharge machining process, breakdown voltage across inter electrode gap (IEG) IS 300 V…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.