Home Work 2 The articular Cartilage is subjected to plane stress ith normal stresses ox, Oy and shear stress Txy, as own in the figure. At a counterclockwise angle = 30° from the x-axis, the normal stress is 3 MPa nsion, and at an angle 6 50', it is 2 MPa ompression. Find the principals stresses. o,=10 MPa

Q: For each of the stress states listed below, find all three principal normal and shear stresses. Draw…

A: Find outFind all three principal, normal, and shear stresses. Draw a complete Mohr's three-circle…

Q: 4 The state of stress on an element at a point is described by the Figure shown. Stress magnitudes:…

A: The objective of the question.(a) Neatly sketch the Mohr's Circle, identifying the locations of the…

Q: Problem (7,2): The surface of an airplane wing is subjected to plane stress with normal stresses oy,…

A: Given, Stress in x direction = σx = 100 MPa   Normal stress at any angle θ can be given by, σn = σx…

Q: shaft attached to 1900 N flywheel at distance of 400 mm from A and the shaft is rotated by a pulley…

A:

Q: A homogenous rigid block subjected to the loading shown in figure is supported by three steel rod…

A: Given: Diameter of steel rod, d=25 mm

Q: Consider the plane stress element shown in representing the state of stress at a material point. If…

A:

Q: = A machine component is fabricated from a bent tube as shown below. One part of the tube lies along…

A: Outside diameter, d0=122 mmInside diameter, di=108 mmForce F=8.5 kNLengths,L1=258 mmL2=118 mmL3=281…

Q: Oy = 90MPA %3D Try 60MPA %3D Ox=20MPA

A: Given Data Normal stresses σx= 20MPa σy=90MPa Shear stress fxy=60MPa   Main stresses are the…

Q: Lical planes at the polnt are Sx (a) Determine the principal stresses (o,l > Op2) and the maximum…

A:

Stress transformation

The term stress indicates the measure of internal forces that develop due to an external force's application on an object. When a specific external force is applied to an object, internal stress generates in the material. The value of stress can obtain by taking the ratio of the externally applied force and cross-sectional area of the object. There are different types of stress depending on the type of external force.