H.W.2:A Three- phase, 400 V, 50 H2. Star Connected SCIM,The motor dvaws no-lond C.wet of (5A) withno-lond observedload Conditron the motor drans (18 A) atpowerof (1120 w). At RM(o.85) power factar and (o.04) Sip.if theAvmature resistance is (o.6 slph), and therotational losses (250 w), Determine!O Ivon lossO Outpat powerO Effieienty

Answered: Image /qna-images/answer/44b635d5-7850-44b9-8b5b-a368c04a6990.jpg

HiW.2: A Three-phase, 400 V, 50 H2. Star Connected SCIM, The motor draws no-load Carret of (5A) with no-lond observed power of (1120 w). At PM load Conditron the moter drans (18 A) at (o.85) power factar and (o.04) Sip. if the Avmature resistance is (o.6 slph), and the rotational lesses (250 w), Determine! O Ivon loss O Output power

HiW.2: A Three-phase, 400 V, 50 H2. Star Connected SCIM, The motor draws no-load Carret of (5A) with no-lond observed power of (1120 w). At PM load Conditron the moter drans (18 A) at (o.85) power factar and (o.04) Sip. if the Avmature resistance is (o.6 slph), and the rotational lesses (250 w), Determine! O Ivon loss O Output power

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.4P

See similar textbooks

Similar questions

A Three phase, 600 V, 50 Hz, De lta Comnected SCIM, %9. Il. li. o H. W. 2 A... HiW. 2! The motor dvaws no-load Current of (8A) with no load observed power of ( 1100 w) . At Rell londing Condition the motor draws (20 A) at (o.8) power factor and (o.04) Slip. if the Armatuve resis tamce is (o.4 slph) amd the rotational losses (240 w), Detormine; 0 Iron loss ® Output Power OEfficin ay
A generator is feeding the load. A second load will then be connected in parallel with the first load. The generator has an idle frequency of 61Hz and an Sp slope of 1MW/Hz. Load2 draws 800kW active power at 0.707 reverse power factor, while load1 draws 1000kW active power at 0.8 reverse power factor. What will be the operating frequency of the system after load 2 is connected? *Please explain the solution step by step
• Q5/ in a DC motor. List and describe the types of losses that occur
V3152/ SECTION For a power system having induction motor loads, an overexcited synchronous motor is also attached. The the over all power factor O a. Improves b. Remains same O c. becomes upf O d. Degrades A load 100+j0 ohms is connected across a 200 V and 50 Hz supply. Find the total current. O a. 1 A b. 2 A Oc.3 A d. 3.5 A here to search
A Flyback converter (for questions 1-3) shown below has the following parameters. Vin=100V, Vo=20v, Po=40W, D=0.25, Fsw=250kHz iin i out in 1. What is the turns ratio N1:N2 between the primary side winding and the secondary side winding? A. Ν1: N25:3 B. N1: N2 = 3:5 C. N1: N2= 5:2 D. None of the above %3D 2. What is the maximum voltage on the power switch? A. 120V В. 133V С. 100V D. None of the above 3. What is the maximum voltage on the diode? Α. 40V В. 133V C. 80V D. None of the above 4. The magnetizing inductor at the primary side winding is 100uH, what is the peak current in the power switch? Α. 1.8Α В. 1.6A С. 2.1A D. None of the above
can someone help me out with this question 5 and pls explain clearly, tq
Can you please answer Problem 49 to 51.
In a workshop, there is a three-phase asynchronous motor with a power of 6 HP, an efficiency of 85%, and a power factor of 0.8. Find the capacitor capacity required for power factor correction in the workshop. (The capacitors will be connected in a delta configuration.) A new power factor of 0.95 is desired. The nominal voltage in the workshop is given as 0.4 kV. (1 HP = 0.745 kW)
A generating voltmeter is required to measure voltage between 15kV and 250kV. If the indicating meter reads a minimum current of 2uA and maximum of 35uA. Assume that the speed of driving synchronous motor is 1500rpm. Determine the capacitance of the generating voltmeter. A. 1,2 pF B. 6.5 pF C. 15,2pF D. 1 pF
32. An alternator requires an alternating current of 2.1 A to produce on short circuit its full-load current of 50 A. The same on open-circuit an emf of 320 V. The armature resistance is 1Ohms . Find the full-load percentage regulation with a lagging p.f. of 0.6 when terminal p.d. on load is 2000 V. A. 7.2% B. 28.8% C. 3.6% D. 14.4%
9. Three unequal single-phase induction motor are connected between lines and neutral of balanced 3 phase, 350 V circuit. The line to neutral voltage is 202 Veach. The first load takes 20 kW at 0.82 pf, the second takes 28 kW at 0.75 pf and the third takes 36 kW at 0.8 pf. What is the current in the neutral conductor? a. 105.5 A b. 125.4 A c. 85.6 A d. 133.4 A
Number 9 letters c and d.