HHowm Walk A unity feedback system is characterized by an open loop transfer function: K G(s) = s(s+10) Determine the gain K so that the system will have a damping ratio of 0.5. For this value of K, determine settling time, peak percent overshoot, and time to peak overshoot for a unit step input.

Q: Q1\ Design and find frequency passband of analog Butterworth filter that has -2dB passband…

A: To design an analog Butterworth filter and find its frequency passband given the following…

Q: A voltage amplifier with gain 3 dB is cascaded with an attenuator of attenuation (ratio) of 1/v2.…

A: Refer to step 2 for the answer.

Q: 1. Design 6th order Butterworth band-pass filter with cut-off frequency is 4KHz and 7KHz and pass-…

A: Planning a sixth request Butterworth band-pass channel includes a few stages, including deciding the…

Q: In a given system, if the damping factor is observed to be equal to "1" then the system is…

A: A system is called Under-damped, if damping ratio (denoted by zeta) is less than 1. Here the system…

Q: 2 resistor using Ohm

A: 1 Current through 1 ohm is 20 amps 2. Equivalent Resistance = 64 ohms

Q: Consider a linear circuit having a single output voltage and two possible voltage sources as the…

A: The notion of superposition may be used to discover the output for a particular input condition. The…

Q: Write a computer program or use an equation solver to calculate and plot the s v a j diagrams for a…

A: Displacement, velocity, acceleration and jerk are calculated for a rise of 20 mm in 60 degree of…

Q: A moving coil instrument has full scale deflection at 50 m V and 10 m A . the value of shunt…

A: Refer to further steps for answer

Q: R1 3 Ohms Node 1 R3 4Ohms Node 2 R4 4 Ohms Vi=40V R2 2 Ohms V2= 20V Rs 5 Ohms

A: Given: For the circuit given in figure 7 apply Node Voltage Analysis and voltage and current across…

Q: For a system having damping factor, 8 =0.7 and frequency of natural oscillations, wn =14.5 rad/sec.…

A: I have given an answer in step 2.

Q: A 4bit x 4bit DIVIDER circuit can be designed using AND gates, Full Substractor and Magnitude…

A: A 4bit x 4bit DIVIDER circuit can be designed using AND gates. Full Subtractor and Magnitude…

Q: Q1. Timing analysis (Graded for completion) CLK CLK CLK Given the circuit, each two-input XOR gate…

A: Actually, flip-flop is a circuit. given information Each two-input XOR gate has : a propagation…

Q: 2. Consider the following R-L circuit: Rs t= to iz(t) V's Vz(t) If to = 0 and initial current…

A: Question :-

Q: Explain the implications of integral and derivative control on damping and steady-state errors.

A: As time passes to infinity, steady-state error is defined as the difference between a system's input…

Q: Given an armature-controlled DC motor has the following transfer function K G(s): (s + 10)(s + 1) S.

A: On expanding the denominator,we get s2+11s+10. we take the value of k as 10, since it is a…

Q: Given the Unity feedback control system in Figure 3 is a motor with controllable speed and also…

A: Answer

Q: Q; For a unity feedback control system the open loop transfer function G(S)= 10(s+2)/s2(s+1), Find…

A: solution for this question is provided below in step 2.

Q: X D Q₂ Q₁ Z

A: This qus is from the subject computer Organization. here we have a circuit diagram for which we have…

Q: 7- A certain TTL gate has IH =20 µA, IL =0.1 mA, IoH =0.4 mA and IoL = 4 mA. Determine the input and…

A: Given that A certain TTL gate has I_{IH}=20 μAIIH ​=20μA, I_{IL}=0.1IIL​=0.1 mA,I_{OH}=0.4IOH =0.4…

Q: FIND THE SOLUTION USING K-MAPPING AND FIND THE EQUIVALENT LOGIC CIRCUIT GATE.

A:

Q: Design a half-wave rectifier with a filter for the following conditions: a) The peak input

A:

Q: The mole balance equation for the phase separator is ziF=yiV + xiL.What does the F represent in this…

A: Mole balance equation is: ziF = yiV + xiL Here, F is total molar flow rate. V = vapour molar flow…

Q: In a given system, if the damping factor is observed to be equal to "0" then the system is…

A: SOLUTION :-  Undamped

Q: .Ccoraing to the following tion data for a chioride lon selective electrode. Sample Conc. pCl- Avg.…

A: First word written their which got cut is THE.

Q: Use a K-map to find an optimum SOP equation for F(W, X, Y, Z)= Em(3,4,5,7,9,13,14,15)

A: input = ∑(3, 4, 5, 7, 9, 13, 14, 15)   YZ YZ YZ YZ WX 0 0 0 1 1 3 0 2 WX…

Q: Refrigeration system, saturated Calculate the capillary tube length for the specified conditions…

A:

Q: Q3- Design a BPF FIR filter that will have a-3 dB cutoff at 20x and 25x rad/sec. and an attenuation…

A: Here we have to design a BPF FIR filter that will have a -3 dB cutoff at 20x and 25x rad/sec. and an…

Q: In a given system, if the damping factor is observed to be equal to 1.6 then the system is…

A: Damping ratio describes how oscillations in a system decay after a disturbance. Damping ratio is a…

Q: - B 1. Derive the Boolean equations representing the outputs D = B = 2. Complete a truth table for…

A: Expression A and B for the circuit  and truth table

Q: R2

A: Given values steady-state current I flowing in a circuit that contains a resistance R = 5 ,…

Q: 2. Determine the range of K for stability of a unity feedback control system whose ppen-loop…

A: Solution K>6 is the condition for the system to be stable In RH criteria,the first column should…

Q: The following Boolean function Y=f{A,B,C,D,E) =Em (0,1,2,4,5,6,10,13,14,18,21,22,24,26,29,30 ).…

A: Note: As per guidelines we are supposed to answer only one question at a time .please repost the…

Q: e(s) V(s) 0.01 0.005 s3 + 0.06 s2 + 0.1001s 5. Calculate rise time, time constant, damping ratio,…

A: answer is given below  Matlab code is given below  for given function

Q: Consider the non homogeneous ODE with a nonlinear term called b: dy + 2Aw- dt2 dy + w?y (1+ by²) =…

A: Matlab Code: clear; clc; close all;   % Description: Solves forced damped motion using ode45 w = 3;…

Q: 1. Given the following circuit: 5 ns A D t. 1ons The gate delays are as shown above the gates. A, B,…

A: import numpy as np import matplotlib.pyplot as plt # Define the time interval t = np.arange(0, 40,…

Q: The transient response of a circuit can be determined using the following methods Differential…

A: D is the answer  The Laplace transform has special properties with derivatives of functions.…

Q: Design a minimum 2-level NOR gates for the following Boolean function: f(a,b,c,d) = Em(2,3,8,11) +…

A:

Q: Design a low-pass digital filter to be used in an A/D-H(z)-D/A structure that will have a -3 dB…

A: Above the question are showing the linear phase and the system that will use sampling.

Q: The function (x(n) = K; for 0 <n < ∞) called step function unit pulse unit step constant sequence

A: Here for each value in x is assigned with K x(1)=K x(2) = K x(3) = K ... ... ... x(n) = K This…