Hello, good day. I have a problem answering this question, and I need your help. Hoping for a response, and thank you so much. Instruction: The answer must be in a minimum of 2 paragraphs, and each paragraph must have a minimum of 4 sentences. Question: What are the similarities between Flotation and Sedimentation methods of Concentration Techniques?

Q: The reaction C2H5I + OH C2H5OH + I was studied, and the following rates were obtained. Temperature,…

A: Given,                                     Temperature (◦C )…

Q: What is the best technique for pushing down on the plunger to carefully form a drop? Select the most…

A: To decribe the best technique for pushing down the plunger to carefully form a drop.

Q: In case of SEC method, the proteins’ adsorption could be a result of overall ionic interactions…

A: In the size exclusion chromatography (SEC), the factor the that differentiates one type of molecule…

Q: A chemist received a radioactive sample that is suspected to contain U, 23U and other elements. The…

A: The objective of this question is to show the surface analysis technique for this sample is X-ray…

Q: A supporting electrolyte is usually added to the analyte solution to minimize solution…

A: 1. SOLUTION - The correct option is (a) minimize solution resistance According to the question -…

Q: The maximum amount of nickel(II) that could be plated out using 15 amps for an hour is

A: Given that - Nickel (II) - Ni2+ Current in Amperes = 15 ampere Time = 1 hour = 60 minutes = 60×60…

Q: A. Solid stationary phase with liquid or gas mobile phase. B. Solute attracted to specific group…

A: All given types are of chromatography.

Q: Surface Adsorption: This always results in positive errors in gravimetric procedures Select one:…

A: The objective of this question is to find whether surface adsorption always gives positive errors in…

Q: ons should be shown of the back of Formula of the Hydrate Weight of Hydrate and Evaporating Dish…

A: Chemical formula of the hydrate is CuSO4.5H2O  Weight of hydrate = 10.884 g  Weight of water in the…

Q: 1. The density of ice at 0°C is 0.9168 g mL-1, and that of liquid water at 0°C is 0.9999 g mL-. (1)…

A: Density of a substance is defined as mass of substance per unit volume. SI unit of density: kilogram…

Q: Explain two separation techniques how may be feasible for H2O vs Ethanol. One can be an industrial…

A: Separating alcohol from water may be done in a number of different ways. Heating the mixed liquid is…

Q: Question: How do factors other than temperature affect the rate of 1. Choose a variable: Pick a…

A: To choose a variable to be investigated on the Diffusion Gizmo and explain how it affects the rate…

Q: Mean, standard deviation, Coefficient variable, and 95% confidence limits of HCl molarity’s *…

A: In the realm of chemical analysis, the determination of molarity plays a crucial role in…

Q: Select whether the factor will either SHORTEN or LENGTHEN the characteristic of the dosage form.…

A: The answer are as follows:

Q: Pre-lab: Experiment 6 All Sections 1. Define the following terms: Surface tension Viscosity Freezing…

A:

Q: Use the MSDS for potassium permanganate to identify the hazards with which it is associated. Choose…

A: Material Safety Data Sheet (MSDS) is a type of digital document that gives all the detailed…

Q: #7

A: A question based on properties of liquids that is to be accomplished.

Q: If some of the analytes were found to be out of range after doing the Quality Control and the…

A: Quality control is designed to detect ,check the actual quantity of analyte before patient's use.…

Q: Given the following data for a screen analysis, calculate the mass fraction, average particle size,…

A: Solutions- Given data- Total sample size =1721 gm.

Q: Consider a pond with three types of fish. 1) N1= 100, M1-1 lb 2) N2-30, M2-3 lb 3) N3-10, M3-7 lb…

A: The solution is given below. Q1. 3.3077 lb  Q2. 5.0465 lb  Q3. 1.8571

Q: 1. Calculate the concentration (mol/L or M) of calcium ions in each water sample using the molar…

A: The balanced chemical equation for the reaction between Ca2+ and EDTA is shown below: Ca2+ +…

Q: Question 9 What is the most appropriate time to use a safety shower? 1) You spilled 400 milliliters…

A: The correct option is:

Q: use analytical separation and analyses to outline analytical separation method protocols that can be…

A: It has become an important need to prevent water pollution by removing all contaminants. Water is…