has a diameter of 50 mm and is firmly attached to the rigid supports at A and B when the initial temperature is 50°C. Determine the force P in kN that must be applied to the collar at its midpoint so that, when the final temperature becomes 30°C, the reaction at B is zero. Where: α=12x10^6 m/(m°C), E = 200 GPa and L = 500 m

has a diameter of 50 mm and is firmly attached to the rigid supports at A and B when the initial temperature is 50°C. Determine the force P in kN that must be applied to the collar at its midpoint so that, when the final temperature becomes 30°C, the reaction at B is zero. Where: α=12x10^6 m/(m°C), E = 200 GPa and L = 500 m

Solid Waste Engineering

3rd Edition

ISBN:9781305635203

Author:Worrell, William A.

Publisher:Worrell, William A.

Chapter4: Mechanical Processes

Section: Chapter Questions

Problem 4.20P

See similar textbooks

Similar questions

– A joint is made by gluing two plywood gussets of thickness t to wood boards.The tensile working stresses are 1200 psi for the plywood and 700 psi for the woodboards. The working shear stress of the glue is 50 psi. Determine the dimensions’ b and tso that the joint is as strong as the boards.
Please determine the second part
1) Identify the Yield Strength of the material using a 0.2% Offset line
Determine the dimensions :
FOR THE GIVEN PROPERTIES DESIGN d': 15 mm THE REINFORCEMENT OF : 400 mm b d = $80 mm fc = 33 MPa fy = 320 MPa Mu: 1 000 000 000 N mm A. USE B.USE OF NSCP 2001 NSCP 2015 BEAM THE BEAM 132 13 Gra mm of BELOW. #H 1606 210135 03 M 12437 P0122399/100mA 02338941 242
(2) * 28" 2#8 7 14" I2.5" NWC fé=3000 psi > 2 #10 z 2 #11 I 3" Grade 60 steel &Mn = ?
SHOW COMPLETE SOLUTION PLS VALUE:X = 425
Flexure stress *please answer in complete solution and Draw the FBd properly and neatly *
3. The manufactures wood beam carries a uniformly distributed load of intensity wo Determine the largest safe value of w, if the shear stress in the wood is limited to 300psi. 1.0 ft Wo 4 ft 1.0 ft 0.75 in. 4 in. 0.75 in. 5 in. -0.75 in. -NA I= 46.7 in.
Pls
b. Shrinkage is defined as the reduction in volume of 1.2 Fill the blank space (s) with the correct answer given at the end of each question below a. In reinforced concrete cross section the strain in reinforcing bar is the same as that of the surrounding 1- Bars 2- concrete 3- load 4- shear b. should be placed in the locations of anticipated tensile stresses and cracking areas 4- Loads 1- Concrete 3- Reinforcement 2- Water 1.3 Write two of the mechanical properties of the concrete? a. b.
The column is built up by gluing the two boards together. If the wood has an allowable normal stress of sallow = 6 MPa, determine the maximum allowable eccentric force P that can be applied to the column.