H.W Q1) A four pole, three-phase synchronous generator is rated 250 MVA, its term is 24 kV, the synchronous reactance is: 125%. ERI Calculate the synchronous reactance in ohm. • Calculate the rated current and the line to ground terminal voltage. → Draw the equivalent circuit. - Calculate the induced voltage, E., at rated load and pf = 0.8 lag.

H.W Q1) A four pole, three-phase synchronous generator is rated 250 MVA, its term is 24 kV, the synchronous reactance is: 125%. ERI Calculate the synchronous reactance in ohm. • Calculate the rated current and the line to ground terminal voltage. → Draw the equivalent circuit. - Calculate the induced voltage, E., at rated load and pf = 0.8 lag.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

urgent required.
A synchronous generator has been synchronized to an infinite grid of 13.8 kV and 60 Hz. The generator prime mover C/C is such that the no-load frequency is 62.5 Hz and the power slope is 1 MW/Hz. The AVR C/C (The reactive power against the terminal voltage C/C) is such that the zero reactive power voltage is 14.6 kV, while the slope is 0.4 MVAR/kV. Calculate: (a) the kVA loading of the generator and its power factor. (b) the settings of the prime mover and AVR such that the generator delivers 3 MW at 0.85 lagging power factor.
A generator with constant 1.0 p.u. terminal voltage supplies power through a step-up transformer of 0.12 p.u.reactance and a double-circuit line to an infinite bus bas as shown in the following figure. The infinite bus voltage is maintained at 1.0 p.u.Neglecting the resistances and susceptances of the system, the steady statestability power limit of the system is 6.25 p.u. If one of the double-circuit istripped, the resulting steady state stability power limit in p.u. will be oi
Illustrate the circuit diagram
A 3Ø, Y-connected alternator is rated at 1,600KVA, 13.5KVv. The armature effective AC resistance per phase is 1.50. The percentage regulation for a load of 1,280kW at unity power factor is 3.5%. Determine: (a) synchronous reactance of the alternator (b) %VR at full-load 0.8pf leading (c) What is the effect on %VR value if taken at half-load lagging pf? Justify and explain briefly your answer on one(1) sentence.
a. 4 KA O b. None of these O c. 6.25 kA O d. 2.309 KA A 100-MVA, 60-kV, three-phase synchronous generator has a synchronous reactance of 16 Ohms/phase and negligible armature resistance. The generator is operating with an excitation per phase E= 47.116 KV, and is delivering maximum power before losing synchronism (stability limit). Thus, the maximum generated power is Pmax = and the armature current is la = 306 MW None of these 102 MW 530 MW A 90-MVA 69.3-kV, three-phase synchronous generator has a synchronous reactance of 10 Ohms/phase and negligible armature resistance. The generator is delivering power to the bus bar at the rated voltage with its field current adjusted for a generated emf (excitation voltage) of 50 kV per phase and a power angle & = 7.1 degree. Thus, the delivered power is the generator armature current is and the power factor is The thre tings of the below.electr nower system is given below:
A 3-phase, 50 Hz, 16 pole generator with concentrated windings has 144 slots with 10 conductors per slot. The flux/pole of 24.8 mWb is sinusoidally distributed. The coil is full pitched. Find the line emf.
Three identical steam-turbine generators G1, G2, and G3 are operating in parallel. Each generator is: 7.2 KV, 24 MVA, 50 Hz, 0.85 PF lagging, 4-poles, Y-connected, with synchronous reactance of 2 Q and an armature resistance of 0.05 Q. Each of generators G1 , G2 , and G3 has a characteristic power-frequency slope of 4.2 MW/Hz , 4.5 MW/Hz, and 5.0 MW/Hz, respectively The no-load frequency of each generator is set to 52.4 Hz. The load increases with no changes in the settings of the no-load frequencies, until a generator reaches its maximum rated power first. At what system frequency does this limit occur? Select one: O a. fsys = 49.2 Hz O b. None O c. fsys = 48.9 Hz O d. fsys = 48.32 Hz Clear my choice
Draw a complete circuit diagram of 1 phase synchronous alternator including the field excitation circuit. Then, draw the phasor diagram of the generator a general leading power factor. Include the phase resistance in the diagram.
Three identical steam-turbine generators G1, G2, and G3 are operating in parallel. Each generator is: 7.2 KV, 25.4 MVA, 60 Hz, 0.77 PF lagging, 4-poles, Y-connected, with synchronous reactance of 2 Q and an armature resistance of 0.05 Q. Each of generators G¡ , and G2 has a characteristic power-frequency slope of 5.8 MW/Hz, and no-load frequency of 62.5 Hz. Generator G3 has a characteristic power-frequency slope of 6.0 MW/Hz. Find the no-load frequency of generator G3 for which all generators supply a load of 38.5 MW, at fsys = 60 Hz. Select one: O a. fsys = 62.5 Hz O b. fsys = 61.85 Hz O c. None O d. fsys = 61.58 Hz Clear my choice
(a) A single phase distributed winding carries alternating current. Show that the time maximum of the peak mmf for a P pole machine is given by 4 N V21 Fipm -K ph ATs per pole P
Solve it clearly please with clearly steps