H.W-I:- A platinum Coil has a resistance of 3.146 N at (40°c) and 3.7670 at(100°c). Find the resistance at (0"c) and temperature coefficient ofresistance at (40°c).

Answered: Image /qna-images/answer/94d1a73e-de9b-488e-b3cc-513bf3afdf57.jpg

Answered: H.W-I:- A platinum Coil has a…

Engineering

Electrical Engineering

H.W-I:- A platinum Coil has a resistance of 3.146 N at (40°c) and 3.7670 at

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: Determine and carefully sketch the even and odd parts of the function shown in Figure 1.

Q: j202 Select one: O a. None of these O b. Is 100 <-90° mA O c. Is = 5.0<.90° A 90° me ell

Q: Find the reactance voltage when current is changed from -2A to 2A in 4 sec and self inductance is…

A: Given, Current is changed from, ∆i=2--2=4 A. In the time period, ∆t=4 sec. Self inductance, L=1 H.

Q: Two parallel wires made of copper are placed in air. The inductance of each wire is 0.9 µH/m with…

A: Two parallel wires made of copper are placed in air. Total inductance L= 0.9uH/m What is the…

Q: What are the types of semicondoctors available

A: The objective of the question is to identify and describe the different types of semiconductors…

Q: This is an electrical engineering question. It belongs to microelectronics and material processes.

A: In MOS devices, usage of the polysilicon as a gate electrode is a significant development in MOS…

Q: What are the things common in direct current and alternating current. And also its Difference

A: The explanation is as follows.

Q: assume that tthe circuit shown in figure 21-1 is connected to a 480 v 60 hz line. the capcitor has a…

Q: 7. A coil 12 H. The urent 50 aud tof the has hesistance tuductante thiough coil io inereased…

A: It is given that: R=5 ΩL=1.2 H

Q: For the following circuit if the secondary voltage of the transformer is 20V rms, the output voltage…

Q: Millmans theory current thru 5ohm

A: Given: A circuit, To find: Current through 5 Ω resistance.

Q: For the following circuit if the secondary voltage of the transformer is 20V rms, the PIV of the…

Q: Find voltage between point A abd point B

A: Given circuit,

Q: What is the accurate LVDT output voltage when the core is at the centre position? a. 5.22V b. 2.5V…

A: Given: LVDT

Q: Determine the maximum peak-to-peak ripple current of previous problem by using the next equations,…

A: To determine the maximum peak-to-peak ripple current ((Imax)), we can use the given equations.…

Q: explain the process of the following Positive pulses Positive edges

Q: For figure (1)draw and calculate the voltages waveform across each half of secondary winding and…

A: The figure shows a full wave rectifier circuit using two diodes D1 and D2. The supply voltage is…

Q: A coil that consists of 450 windings is wound around a Bakelite ring. The mean diameter of the ring…

A: Coil: A coil is made by connecting a few curves in a series. Coils are used as components of…

Q: A step up chopper has input voltage 110 V and output voltage 150 V. The value of duty cycle is.

A: Given a step up chopper with, Input voltage, Vin=110 V. Output voltage, Vout=150 V. Duty cycle, α=?

Q: An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a…

A: An inductor and resistor are connected in parallel we need to find the phase angle between voltage…

Q: For the below circuit, find Req across the source in KO. 3 kn3 5 kn 4 kN 3 mA() 10 kn 3 7 kn3 Select…

Q: P4. The BJT in the common-emitter amplifier in Figure 4 has ß = 100. The coupling capacitors may be…

Q: For the series RL circuit shown in the figure below, answer the following questions and justify your…

A: 1) The inductance of the inductor will beL=μN2×Cross section areaLengthSince all the parameter of…

Q: The main difference between resistance R and capacitive reactance X, is that

A: Resistance Resistance is the measure of opposition for the flow of electrons or current in an…

Q: resistor R and a capacitor C are connected in series across a 400 V variable ac supply. When the…

A: A series RC circuit is a circuit that contains a resistor (R) and a capacitor (C) connected in…

Q: The maximum possible mutual inductance between the coils have self inductance L1 = 4 H and L2 = 16 H…

A: This question belongs to circuit theory . It is about mutual inductance between coil . Have a look…

Q: An e.m.f. of 16 volts is induced in a coil of inductance 4H. The rate of change of current must be…

A: Given; EMF induced vL=16 V Coil inductance L=4 H

Q: Due to mutual inductance between two coils, there is an induced emf in one coil due to a change in…

A: Answer:True

Q: In the given circuit, a step down transformer with an RMS voltage as 110V / 11-0-11 V is used with…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: Q6) The waveform of the voltage obtained after rectification is of a -----nature and therefore…

A: AC signal has both positive and negative half cycle where as dc has only positive voltages.…

Q: If the voltmeter in the figure shown reads 60 V, find the following: A V V j3 + j4

Concept explainers

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.

Question

100%

H.W-I:- A platinum Coil has a resistance of 3.146 N at (40°c) and 3.7670 at
(100°c). Find the resistance at (0"c) and temperature coefficient of
resistance at (40°c).

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

H.W-I:- A platinum Coil has a resistance of 3.146 N at (40°c) and 3.7670 at (100°c). Find the resistance at (0°c) and temperature cocfficient of resistance at (40°c).
quick please
We want to investigate how the field strength will be with air as dielectric and with steatite. A plate capacitor is placed in a 24 kV network between phase and ground. The relative permittivity of air is &=1 and for steatite &-6. The plate capacitor has area = 1m². The distance between the electrodes is 2 mm. Ep = 8.854-10-12 F/m A=1m² d=2mm a) Calculate the maximum field strength in the plate capacitor. (Answer: 9.8kV/mm) b) What is the capacitance of the capacitor if we use steatite? (Answer: C = 26.6nF)
400 V is the input voltage given to a chopper, the required output is 650 V. The thyristor is conducting 300 usec. what is the addition of conducting and non conducting period? (Write your answer in usec) Answer:
An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coil
A clipper circuit based on diodes are simple way to modify waveform in mechatronics. Assume that the two diodes shown in the circuit below are ideal diodes. If the input voltage in the circuit is a 1 kHz sinusoid with peak amplitude of 8V, sketch the Vaue (t). 10 k. 8V 10 kN. D2 RL Vourlt) Vin= Vin(t) Ims D1 6V -8V 4V Page | 1
i need a solution within 10 mints
A coil connected in series with a resistance are supplied from a 240 volts 60 Hz source draw 1.0 ampere current. The voltage across the series resistance and across the coil are both equal to 160 volts. Find the value of coil resistance.
Diodes Are Connected In Series To Share A Total... 21 Question • Two diodes are connected in series to share a total reverse voltage of VD=D 5 KV. Reverse leakage currents of the diodes are ID1=30 mA and Ip2=35 mA. - Find Vp1 and Vp2 for R,=R2=100 k2 - Find R, and R2 for VD1=VD2 R1 VD1 Hint: Is=L,+IRj= I,2+IR2 VD R2 VD2
A coil consists of 2000 turns of copper wire having a cross-sectional area of 0.8 mm2. The mean length per turn is 80 cm and the resistivity of copper is 0.02 un-m. Find the resistance of the coil and power absorbed by the coil when connected across 110 V d.c. supply.
In a given circuit below is connected to an AC signal with 240V peak in a 4:1 transformer. Sketch the voltagewave form at VA and Vo as practical diode. (Show Complete Solution)
Do all questions