In the given circuit, a step down transformer with an RMS voltage as 110V / 11-0-11 V is used with RL =1 KQ. Assume diode as Germanium and the input frequency is F= 50HZ. D Vin 1- Name the given circuit . 2- Find The PIV. 3- Find Current trough load resistance. Draw the Innut and Outnut waye forms elle

Q: C. A single phase full converter feeding RL. load has the following data: source voltage 230V(RMS),…

A: (i) The circuit diagram for the full wave converter is shown below:

Q: 5. The circuit in Figure 3 is modified by adding a capacitor as show in Figure 4. Given Vian= 20 V.…

A: Given in the question: Vpin=20Vf=50Hz (a): The peak value of the output voltage is: As the diode is…

Q: In the full-wave rectifier circuit of figure , the transformer has a turns ratio of 1:2. The…

A: We need to calculate peak to peak ripple voltage for full wave rectifier .

Q: For the given circuit below, it operates on a peak- to-peak input voltage of 133.1 V, F = 60 Hz…

A:

Q: The peak value of the output voltage across the load shown in figure for a given input of 230V, 50HZ…

A:

Q: What is the steady-state output voltage diodes. Vin 25:1 = 450sin (200t) V? Vy=1V for both ✈ D1 本 D2…

A: Given circuit:Input voltage To determine:The output voltage vo

Q: b. Suggest a circuit that eliminates the negative portion of an AC waveform, leaving the positive…

A: Note:As discussed in the question, we are required to answer only part (b). we are required:To…

Q: In a given circuit below is connected to an AC signal with 240V peak in a 4:1 transformer. Sketch…

A: It is given that:

Q: An R-L load is connected to a 250 V, 400 Hz step down dc converter. The average load current is 100…

A: An R-L load connected to 250 V, 400 Hz step down dc converter- Vs=250 V & frequency f=400 Hz.…

Q: the full-wave rectifier circuit of figure , the transformer has a turns ratio of 1:2. The…

A:

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.