Given: • The members are a semi-circular 3 m cross-section with a radius of 16 mm. 3 m 4 m E • Thickness of each member is 14 mm • Diameter of the rivet used is 18 mm D 80 KN 4 m 50 KN Determine: a. Cross-sectional area of the members b. Internal load in member AB, and indicate if tension or compression c. Internal load in member BD, and indicate if tension or compression d. Normal Stress in member AB e. Bearing stress in member BD

Q: Determine the force in member CF in lbs.  If P1 = 638 lbs and P2 = 842 lbs note: Negative value if…

A: To find force in member CF

Q: Problem The lower ends of the three bars in Fig. are at the same level before the uniform rigid…

A:

Q: 01. Each of the members of the truss loaded as shown is an L 50 x 40 x 5 of A36 steel. For member…

A:

Q: determine the internal forces of each member

A: Given:Required:Internal forces of each member

Q: A machine member is subjected to forces as shown in Fig. B 300- 3 kN-m 1.5 kN-m 20 kN Determine the…

A: A )  To find : Determine the stresses ? A problem of solid mechanics.

Q: 2.19 The rigid bar ABC is supported by a F the largest vertical load P that can be applie limited to…

A:

Q: • Part A Suppose that P = 12 kN and P = 17 kN. (Figure 1) Determine the force in member CF of the…

A: Away from the joint : tension (+ve) Towards the joint : compression (-ve)

Q: A bike brake consists of two pieces AOB and COD (Fig.P3.17). Draw the  associated FBD for structural…

A: The piece AOB of the bike brake has the following elements. Internal hinged support at Point O.…

Q: Provide the information missing (blanks) in the table ONLY for caiculate COMPOSITE centroid of the H…

A: Dimensions of B = 0.1 m*(2*0.7)m Dimensions of B = 0.1 m*1.4m Area of A = 0.1 *0.7 =0.07 m2 Area of…

Q: Suppose that P₁ = 33 kip, P₂ = 22 kip, and P3 = 11 kip. (Figure 1) Figure 40 ft- -40 ft- -40 ft- D…

A:

Q: (3) Determine the largest shear force V that the member can sustain if the allowable shear stress is…

A:

Q: A T-beam with the cross-section shown above is subject to the loads shown. a) Determine the second…

A: Given:- To find:- Second moment of area SFD and BMD Normal stresses at A, B and C Concept:-…

Q: 100 KUMT emm 130 1 5 m 25 kNm • At the top of the beam . At the neutral axis At the bottom of the…

A: Given: Required : At B, normal stress at top,  bottom and neutral axis  At A,  normal stress at…

Q: Determine the force in each member of the truss shown in Fig. 4.20(a) by the method of joints.

A: Support reaction :   ∑MB=0RAY×5-30×5+25×12+50×6=0RAY=-90 KN∑FY=0RAY+RB-30=0-90 +RB-30=0RB=120…

Q: Strain energy for truss AC. Enter your answer in J to 2 decimal places. Positive value indicates…

A:

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?