Given the Frame as shown below. Using Method of Members, determine the following: a.) The Internal Reaction at Point B. b.) The External Reaction at Point C. c.) The Moment Reaction at Point C. d.) The External Reaction at Point D. 300 mm- 600 N A 300 mm В 200 mm 400 mm 600 N 400 mm

Q: 1.3 Determine the length of side a and the measure of the two acute angles. 72.0' 67.3'

A: find the side a and two acute angles.

Q: A motor operates at 1800 RPM and expends 2 HP.  How many ft-lbs of torque does it provide at that…

A: Given data: The speed of the motor is; N=1800 RPM. The power of the motor is; P=2 HP.

Q: Given the top and front view create a section view.

A: Find Create a section view using the given top and front views.

Q: Find in inches the inside diameter of this water pipe for an automatic icemaker. Express the answer…

A: Given     Outside diameter, d = 1 1/4 in                                  = 1.25 in…

Q: A steel beam, of lengths a = 4 m and b=4 m and a hollow box cross section, is supported by a hinge…

A: A steel beam, of lengths a = 4 m and b = 4 m and a hollow box cross section, is supported by a hinge…

Q: A 10 cm diameter solid aluminum post is subjected to a horizontal force of V= 7.1 kN and a…

A:

Q: What would it be in celcius

A: From the result, the final temperature of the air in the tank is 277.3 K

Q: In the scale of inches, draw material edge at 7.00 diameters with six holes at 50 diameters. The six…

A:

Q: A Prony brake with a 12” arm is applied to an engine flywheel. At 1200 rpm, the scale registers 20…

A:

Q: A 3500-lb automobile travels down a 10° inclined road at a speed of 20 ft/s. If the driver jams on…

A:

Q: What did you put in the calculator to get the box answers? Please put exactly what you put

A: The solution provided in the previous response is as follows.

Q: The horsepower (hp) that a shaft can safely transmit varies jointly with its speed (in revolutions…

A:

Q: Consider the crank assembly of the figure. The bearings at points A and B are in good alignm…

A:

Q: The horsepower (hp) that a shaft can safely transmit varies jointly with its speed (in revolutions…

A:

Q: The beam in the figure below is subjected to a load P= 3.9 kN at its end. Young's modulus is 210 GPa…

A:

Q: a) Calculate the area of the plate. A= Number in?

A: Given:

Q: So would F12 and F13 both be equal to .5?

A: Here you asked , would F12 and F13 both be equal to .5

Q: An engine has internal combustion volume of 6.31 liters. What is that volume in cubic inches?…

A: Given data volume(V) = 6.31 liters

Q: Find the area of the figure shown. a=3 cm b= 6 cm Take pie3D3.14 Round answer to one decimal place.…

A: It is required to determine area of given section

Q: Make the indicated conversion between customary and metric units of weight and mass. 17…

A:

Atomic diffusion in solids

In material science, diffusion can take place in solid, liquid, and gases. In solids, atomic diffusion can take place with the help of thermally activated and randomly vibrating atoms. The atomic diffusion in solids is complex and very slow in comparison to atomic diffusion in liquids and gases because the interatomic distance between the atoms is smaller in solids as compared to liquids and gases.