Given the following data of a stream of uniform flow: h b h=height of water = 1.20m b= with of bottom = 3.30m water surface tength of stream =120.70m elevation = 220.34m elevation = 221.31m A = cross sectional area, sq m P = wetted perimeter, m S =slope of stream bed, decimal n = 0.025 (roughness coefficient ) Determine the following: a) Hydraulic radius b) Average velocity of stream using Manning's coefficient and the corresponding discharge c) Average velocity of stream using Kutter's coefficient , and the corresponding discharge

Given the following data of a stream of uniform flow: h b h=height of water = 1.20m b= with of bottom = 3.30m water surface tength of stream =120.70m elevation = 220.34m elevation = 221.31m A = cross sectional area, sq m P = wetted perimeter, m S =slope of stream bed, decimal n = 0.025 (roughness coefficient ) Determine the following: a) Hydraulic radius b) Average velocity of stream using Manning's coefficient and the corresponding discharge c) Average velocity of stream using Kutter's coefficient , and the corresponding discharge

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The ratio between discharge and top width of a best hydraulic rectangular channel is 91/50, calculate the depth of the water and the channel width if the bed slope is 1/ 3000 and Chezy coefficient; C = 50.
Question 5 : Please answer parts 1 & 2
Question,
Problem 3 Determine the slope of the bed of a rectangular channel of width 6 m and depth of flow 3 m. Assume the rate of flow as (20+X) m³/s and Chezy's constant 'C' as (50+X).
Determine the hydraulic radius for the following rectangular open channel: Width = 29m Water depth=7m
Water flows in a concrete rectangular channel (n = 0.013) that is 12.0 m wide and water depth of 2.5 m. The channel slope is 0.0028. Calculate the water velocity V and flow rate Q.
Q2/Béd width of an open channel is B = 40 (m), depth of water in the channel is y = 2 (m), longitudinal bed level slope is So = 0.001 and Manning's coefficient is n= 0.025 { m(l)/s}. Calculate the value of water flow rate in the channel. Find the Type of flow in the channel.
a water resource engineer is in charge of designing atrapezoidal open channel for flood control. Typically, these types of channels are made ofconcrete. Use Manning’s Equation.Flowrate (Qb), channel slope (S0), bottom width (Bw), channel sidewall angle (θ), actual depth(y), and Manning’s coefficient (n) are tabulated below. State all assumptions. * z is the sidewall ratio: for every 1 unit increase in depth, the top width increases by z on eachside of the channel, or 2z total.A) Given the actual depth, y = 1.25 ft, find the discharge Qa.B) Find the Critical Depth, yc, for the discharge Qa found in (a). For a trapezoid,dA/dy =Bw +2 yz .Is the flow sub- or super-critical?C) Determine the uniform flow normal depth (yn) at Qb = 209 cfs.D) If the slope is increased to 0.001, what roughness coefficient would be needed tomaintain the same discharge Qa? What about for Qb? Would it be the same value?
Kindly do not give copied or wrong solution.
Civil Q- An irrigation canal has been designed to have R = 2.5 m and S = 1.6 x 104. The sediment on the bed has a median size of 0.30 mm.Determine the amount of bed load using Einstein's method.Assume depth of flow and mean velocity of flow to be 2.8 m and 0.95 m/s, respectively.
Determine the bed slope of a rectangular channel 5 m wide and 2 m deep. The discharge is recorded as 20 m3/s for C=50