Given the Cu-Zn phase diagram below, determine the amount of the phase/s present of a 75 wt% Zn -25 wt% Cu alloy for the following temperatures. Indicate the required composition for each temperature in the diagram. Round off your final answers up to two decimal places. Show your solutions completely and neatly and follow the table format below. Phase/s Phase present Relative composition amount Temperature 600 °C 500 °C y+ L 700 1200 8+L 600 P 598°C 560°C 570 E 1000 e+L 500 60 68.6 70 74.3 75 78.2 80 90 Temperature (°C) Temperature (°F)

Q: If the mass flow rate can be expressed as m=PAV, then the averaged velocity should be O A.…

A: Given data:- Mass flow rate (m)=ρAV Where, ρ= density of flowing fluid A= area of flowing system V=…

Q: I need the answer for problem number 14.

A: 14.In this drawing, only one chamfer is represented by the leader line. The chamfer is represented…

Q: Consider the simple pendulum in the figure. The pendulum is released at point A, swings through its…

A: At the highest point of its motion, kinetic energy is minimum (i.e. zero) and potential energy…

Q: What is a freeze frame

A: Freeze Frame: At the point when a PC or framework (PCM) distinguishes a mistake and the Check Engine…

Q: Explain this diagram

A: Given:To find:Explain the diagram.

Q: Write the advantages and disadvantages of gus turbime

A: Required:Advantages and disadvantages of gas turbine

Q: Does the velocity change across a stator?

A: Yes, the velocity change across a stator.

Q: Write down the name of Primary Control Surface

A: The rudder is a fundamental control surface which is typically controlled by pedals rather than…

Q: 10. The principle advantages of air flat plate over a liquid flat plate collector are: A. It is…

A:

Q: The optimum effective temperature for human comfort is ?

A: For a human being,

Q: What is stand for AFUE and explain its efficiency system

A: AFUE stands for Annual Fuel Utilization Efficiency.

Types of loading

In mechanical terminology, the term load indicates that external force/weight, either constant or variable, acts on a mechanical member/structure. The weight of an object of a specific material is also an external load, and the external force that works on a structure comes under the categories of loading. The external load generates its effects as stress and strain in the structure.