:5.) Given a transmission line with a characteristic impedance of Z, = 50 Ohms, determine thecharacteristic impedance Zą of a quarter wave section and its length / to match a load impedance Zz =1000 Ohms at a frequency of 10 GHz on an air-filled line.

Answered: Image /qna-images/answer/25076e96-38b7-410d-96c9-c97694ae03c3.jpg

) Given a transmission line with a characteristic impedance of Za = 50 Ohms, determine the characteristic impedance Zo of a quarter wave section and its length / to match a load impedance Z: = 1000 Ohms at a frequency of 10 GHz on an air-filled line.

) Given a transmission line with a characteristic impedance of Za = 50 Ohms, determine the characteristic impedance Zo of a quarter wave section and its length / to match a load impedance Z: = 1000 Ohms at a frequency of 10 GHz on an air-filled line.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: An air lossless transmission line is operating at frequency of 3 MHz and has a length of 1.75 A,…

A: Given: An air lossless transmission line having Frequency, f=3 MHz Length, L=1.75 λ Characteristics…

Q: Q3) If the length of the transmission line is one-quarter wavelength (1 = 1 /4). Derive an…

A: We need to find out input impedance for quarter wavelength transmission line

Q: The following lossless network excited with the microwave source having f = 9 GHZ. if Zo=74 Q, 6,…

A: For lossless transmission line Characteristic Impedance is Zo Zo =√(L/C) Zo^2 = L/C L =…

Q: A line is 20 cm long and at 1 GHz the phase constant β is 20 rad/m. What is the electrical length of…

A: Given data, Length l=20 cm = 0.2 m Phase constant β=20 rad/m

Q: Consider a transmission line with Z-=50 N that is terminated by a load with ZL=200+j100 2. The…

A: Given: Consider a transmission line with Zo=50 Ω that is terminated by a load with ZL=200+j100 Ω.…

Q: A 45.6 m long transmission line with a characteristic impedance of 100ohms is terminated with an…

A: A 45.6 m long transmission line with a characteristic impedance of 100ohms is terminated with an…

Q: Problem 4. The carrier c(t) = A cos(2710°) is angle modulated (PM or FM) by the sinusoid signal m(t)…

A: By using formulas of PM and FM we can solve for all partsExplanation:Step 1:Step 2:Step 3:Step 4:

Q: ) Find the input impedance and VSWR of a transmission line 4.3 ATL long when Zo = 100 and Z₁ = 200…

Q: The rms velocity fluctuation in a plane acoustic wave is given as 0.2m/s. Find the sound pressure…

A: Given: For a plane acoustic wave, the rms fluctuation of velocity is u = 0.2 m/s

Q: If the amplitude of the input reflection coefficient is 0.5 with an angle of 45 degrees and the…

Q: 1) Transmission line properties of typical high-speed interconnects are experimentally investigated…

A: Given parameters phase constant β=200rad/mattenuation constantα =140NP/mcharacteristic impedance…

Q: An air lossless transmission line is operating at frequency of 4 MHz and has a length of 0.25 ),…

A: As per company guidelines we can solve only first three sub part kindly post the rest questions…

Q: Problem 1: A lossless transmission line has characteristic impedance Z. 50 2 and its input impedance…

A: Given Few parameters of a lossless transmission line.we need to determine the load impedance…

Q: Consider a transmission line with a characteristic impedance of value ( Zo ) 50Ω, which is connected…

Q: A 100 MHz FM broadcast station uses a 300 2 transmission line between the transmitter and a…

Q: A horn antenna with low side lobes has half-power beamwidths of 29 degree in both principal planes…

Q: A transmitter with an output power of 50 W is connected to a matched load by 32 m of matched coaxial…

Q: Calculate the charecterictics impedance, propagation constant and velocity of propagation at 600 KHz…

A: Given: f=600KHz L=0.5Mh/km C=0.8μF/km R=G=0 (negligible)

Q: For the network given blow f=5,4 GHz, E,=1,4 and I, -0,7+j 0,5 amplitude of incident wave is V+ 2,8…

A: The minimum voltage level at which Vmax occurred is determined as shown below

Q: A Wi-Fi access point operating at 5GHZ, receives a -60 dBm signal at a distance of 50m. What was the…

A: We need to find out transmitted power for given system .

Q: Since S = 1.7 in a transmission line to be used at 2 GHz; What is the length, in cm, of the parallel…

Q: A load connected to a transmission line (Zo= 10092) produces a reflection coefficient of 0.5272°.…

A: At each point along the transmission line, the input impedance is fixed and equal to its…

Q: At 3 GHz, a shorted parallel sideline will be used to match a 60 ohm transmission line to a load…

A: Given,f = 3 GHzZ0 = 60 ΩZL = 30-j60 Ω

Q: A 2-meter, two-wire, lossless line with a characteristic impedance of 250 Ohms connects an antenna…

A: Length of the two wire , lossless line is 2 metresImpedance = 250 ohms Velocity= 2.4 × 10⁸ m/s 500…

Q: A lossless coaxial cable with L = 0.5 uH/ft and C = 100 pF/ft is terminated by a 100-ohm resistive…

A: Given that, L = 0.5 uH/ft C = 100 pF/ft ZL= 100-ohm impedance of cable is defined as…

Q: Load impedance using a quarter wavelength impedance converter with cascading - A load of 50 + j502…

Q: Since S = 2.5 in the 50 ohm transmission line used at 1.5 GHz and the distance to the minimum…

Q: Consider a receiving antenna with a ground value of 20 dB and an equivalent noise temperature of…

A: In this question, We need to choose the correct options Here Antenna Gain = 20dB Equivalent noise…

Q: Q1: Draw the standing wave pattern for a transmission line with a characteristic impedance of Zo…

A: Given data The surge or characteristics impedance is denoted by Z0. The wavelength is denoted by λ.…

Q: A rectangular guide with dimensions of 5.7cmX2.524cm has air as its dielectric and operates at a…

A: According to the question, for the given rectangular waveguide with the dimension of 5.7 cm * 2.524…

Q: One end of an air lossless transmission line having the characteristic impedance of 75 Q and length…

A: Power generation, transmission, and distribution systems constitute a power system. The power…

Q: Find out the general solution for a transmission line due to transient voltage,where ,e = f(x-at) +…

A: e = f(x-at) + F(x+at)

Q: Q3/ If transmitter produced 20W of power is applied to an antenna with gain equal to 1 with 1000MHz…

Q: A distortionless transmission line with a characteristic impedence of 50 N, and the attenuation…

Q: For the network given blow f={freq_q11} GHz, E={epsilon_q11) and IL = 0,15+j 0,23 amplitude of…

A: Given :f=11 GHzεr=1.1V+=7.4 VΓL=0.15+j0.23ΓL=0.275

Q: A transmission line in air with characteristic impedance Z0=50 ohm is terminated with a load…

A: The propagation constant (k) of the transmission line can be computed in the following way:

Q: a transmission line has a characteristic impedance of 90 ohms and a propagation constant of j0.9…

Q: 3/ By measuring the rf voltage amplitude along a line with voltmeter, it is found that the voltage…

A: Given data, The value of VSWR = 7

Q: 5. A transmission line circuit with lossless 50N line is terminated with a load Z, =125 2. The…

Q: How do I find the input impedance of a 60 ohm transmission line that is a quarter wavelength long if…

A: Given:Z0 = 60 ohms (Characteristic impedance of the line) l = (Length of the line)

Question

:
5.) Given a transmission line with a characteristic impedance of Z, = 50 Ohms, determine the
characteristic impedance Zą of a quarter wave section and its length / to match a load impedance Zz =
1000 Ohms at a frequency of 10 GHz on an air-filled line.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Transmission Line Parameter and Scattering Parameter (S-parameter)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A microwave link includes two sites that are 10 km apart and uses a center frequency of 9 GHz. On either transmitter or receiver side, a 100-m transmission line that has an attenuation per unit length of 0.01 dB/m is connected to an amplifier and a parabolic reflector antenna. Other losses caused by connectors and insertions incurred on one side amounts to 3 dB. Antenna has a power gain of 20 dB. If the output of the transmitter amplifier is 30 dBm, what is the received signal level (in dBm) at the input of the receiver amplifier?
The Subject is Electromagnetic II .
A microstrip patch-type antenna has 240-j80 Ω input impedance at 1 GHz. Match thisimpedance to 50 Ω using a quarter wavelength microstrip transmission line section.
pls solve in less than 30 min pls.
QI/ A lossless coaxial cable of 170 mm long has the parameters L — 245 nWm andC — 200 pF/m. The operating frequency is f —I GHz and the line is terminated by ZL —100 Q, determine:A) The characteristic impedance.B) The input impedance at the input terminals of the line.C) The standing wave ratio on the line.
I want a solution for branches A and B, pleaseA) Determine the primary constants, R, L, G, and C for a distortion-less line working at 300 MHz. Given that the line has characteristic impedance, Zo=750, attenuation constant a=0.12Np/m, and wave velocity, v=1.4×10 m/sB) A lossless transmission line used in a TV receiver has a capacitance of 50 pF/m and an inductance of 200 nH/m. Find the characteristic impedance for sections of a line 10 meter long and 500 m long.
A lossless coaxial cable transmission line has L = 10 uH/ft and C = 4 nF/ft. If the signal frequency is 1 GHz, what is the length between two successive oscillations of an electromagnetic signal?
Help me
Q1: A. a lossless transmission line, with a length of 0.22, has an equivalent inductance 2500 time larger than its equivalent capacitance. The load attached at the end of the transmission line is 250 Determine: | 1. The characteristic impedance. 2. The load reflection coefficient. 3. The SWR over the line. 4. The input impedance. 5. What is the length in wavelength to be the input impedance equal to the load impedance? 6. If the source supplies just 1w to the input of the transmission line, what is the power at the load?
A single-phase antenna transmission line with a length of 40 km and supplying the load with a voltage of 200 kV. a frequency of 60 Hz, and a capacity of 130 MW with a single power factor. If the line resistance, inductance, and capacitance per km are 0.3 ohms, 3.6 mH, and 0.02 microfarads per km, respectively. Find the voltage and current at the receiving end.
6. A signal with wavelength of 10 cm travel through a twin lead transmission line with the following characteristics: L-InH/mil, C-0.02pF/mil, R-552/mil, G-100 u S/mil, and &, = 2.1. Determine the following a) Operating frequency of the line b) Zo c) y, a, and ß for the transmission line
I need the answer as soon as possible