5. A transmission line circuit with lossless 50N line is terminated with a load Z, =125 2. The generator voltage phasor is V =10eº V, the generator resistance is 502 and the line is lossless and 4.8 m long. The frequency is 125 MHz and the phase velocity on the line is u, = 2x10° m/s. Up (a) What is the wavelength on the line? (b) What is the input impedance of the line, Z, ? (c) Find the voltage across the input to the line, Vin · (d) Find the time average power delivered to the load. Zg = 50 2 + + Z, = 502 Zz = 125 2 in %3D Zin

Q: A circuit consists of three capacitors and one battery as shown. Calculate the volts associated with…

A:

Q: A Si solar cell has a short-circuit current of 100 mA and an open-circuit voltage of 0.8 V under…

A: given here short circuit current and open circuit voltage and fill factor and asked to find the…

Q: 3. Four capacitors are connected to a EMF as shown with C, = 20 µF, C2 = 4 µF, C3 = 3 µF, and C4 = 4…

A:

Q: a) Determine the values of R and C needed to replace the capacitors and resistors of the left…

A:

Q: QUESTION 13 Three capacitors, a 10 micro-F, a 15 micro-F and a 32 micro-F, are connected in…

A: (13) if capacitor are connected in parallel theequivalent capacitance Cth = C1+C2+C3 Cth=10+15+32 uF…

Q: A potential difference Vab = 50.0 V is applied across the capacitor network of (Figure 1). Figure b…

A: In his question, we need to determine the value of capacitor C3  . If energy across the capacitor C3…

Q: If a system has 3 poles have the angles shown below and 1 zero. calculate the angle of the zero

A: For a control system, the transfer function can be represented as,

Q: 1. Three inductors of 20mH, 30mH and 60mH respectively, are connected together in a parallel…

A: If three inductors L1 , L2 and L3 are connected in parallel than equivalent inductance is Leq than…

Q: Exercise Determine the range of K for which the system remains stable, check 3 values ​​of k stable…

A: The given block diagram is as shown below,

Q: 3.84.2 In the circuit shown in the image below, if V1 = 12.1 mV and R1 determine current lo in µA. =…

A:

Q: Compute the equivalent capacitance of the network

A:

Q: Find the energy of r(t) = 2te¯½ p (¹+¹), where p(t) is the pulse p(t) O -5 -4 -3 -2 -1 0 t Find the…

A:

Q: The circuit in the diagram below consists of several resistors and a capacitor (values diagram). The…

A: Option AFor the given circuit diagramthe capacitors are fully discharged at t= 0R1 = 10 ohm,R2 = 5…

Q: A capacitor is connected to a 480 V supply. An ammeter indicates 1.2 A. What is the capacitive…

A: The magnitude of reactance of capacitor (XC) is the ratio of the voltage across the capacitor to the…

Current Division Method

The generalized current divider formula is given by the following relation below,