Give the name of an 8088 pin used to signal an interrupt request. [Type the name as it is shown on the schematic.]

Q: What are the two main types of output circuits in TTL

A: There are three  types of output configurations of TTL are given below.

Q: (Create truth table before multiplexer), list the inputs for the following configuration. Final…

A:

Q: 4)Comparison instructions A)may be combined in AND (series) as well as OR (parallel) configurations…

A: To execute the comparison instructions, the combination of the AND and OR gates is required. The OR…

Q: 10) Comparison instructions A) may be used only in OR (parallel) configurations B) cannot be used…

A:

Q: Da Their timer accuracy and repeatability are extremely high All the above QUESTION 5 The enable bit…

A:

Q: Select all the 8088 input signals that can cause the microprocessor to take an interrupt. O INTR OSC…

A: The 8088 input signals that can cause the microprocessor to take an interrupt is INTR, INTA, and…

Q: What analogRead() value is equivalent to the voltage output of analogWrite(pin, 255)?

A: In Arduino board Writes the analog number (PWM wave) in the pin. It can be used to illuminate the…

Q: Question : with Eight LEDs with 74HC595. This code uses a shift register to use a single data pin to…

A: Given data: 8 LEDs 74HC595 shift register Value of current LED=5 We have to find the value of the…

Q: The 8259 PIC has 8 interrupt request (IRQ) inputs. Two 8259's can be to increase the number of IRQS…

A: The Intel 8259A Programmable Interrupt Controller handles up to eight vectored priority interrupts…

Q: What is the device address used by the instruction OUT A4, AL

A: OUT is a mnemonic that stands for OUTput Accumulator contents to an output port whose 8-bit address…

Q: MATCH 1:2 De-Multiplexer A 2:1 Multiplexer 8 data distributor.c data selectors D DO D₁ A D NOT ge…

A: here we have to match the circuits with the given options.

Q: Is the conversion time of the ADC constant or variable? What parameter does control it?

A: The conversion time of an Analog-to-Digital Converter (ADC) can be constant or variable depending on…

Q: What causes ground loops in an instrumen­tation system? What are the effects of a ground loop?

A: Given:

Q: Motorola processors 1/O ops. Do not have separate instructions for O Have separate instructions for…

A: Let's talk about the Motorola M6800 which is 40pin DIP IC. It is an 8-bit Microprocessor. It was…

Q: Which of the following are part of the Arduino microcomputer. The answer could be more than one

A: Arduino microcomputer contains several important parts i.e  Digital inputs , ADC's , PWM ports ,…

Q: QUESTION 44 The 8259 is a O Low priority interrupt O Tristate buffer Programmable Peripheral…

A: Intel 8259 is a very important device and very commonly with 8085/8086 systems.

Q: What are the two primary categories of output circuits that are used in TTL?

A: TTL The Transistor-Transistor Logic is a logic family made up of bipolar junction transistors.…

Q: What does the Arduino instruction pinmode do in the Traffic Light program

A: The pinMode() function is used to specify a particular pin to act as output and input. In the…

Q: A device that can be turned on or off by a gate pulse is called an SCS.   True or False

A: SCS is Silicon-Controlled Switch which is equivalent to the SCR (Silicon Controlled Rectifier). In…